| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Texas Instruments |
Low Power 12-Bit DAC • 12-Bit Voltage Output DAC • Programmable Internal Reference • Programmable Settling Time: – 1 µs in Fast Mode – 3.5 µs in Slow Mode • Compatible With TMS320 and SPI™ Serial Ports • Differential Nonlinearity . . . <0.5 LSB Typ • Monotonic Over Tempe |
|
|
|
|
Texas Instruments |
Ultra Low Power Stereo Audio Codec •1 Stereo Audio DAC with 100-dB SNR • 5.8-mW Stereo 48-ksps DAC-to-Ground-Centered Headphone Playback • Stereo Audio ADC with 93-dB SNR • 5.2-mW Stereo 48-ksps ADC Record • PowerTune™ • Extensive Signal Processing Options • Six Single-Ended or 3 Full |
|
|
|
|
Texas Instruments |
Low-Power Rail-to-Rail Input/Output Operational Amplifiers • Qualified for Automotive Applications • AEC-Q100 Qualified With the Following Results: – Device Temperature Grade 1: –40°C to +125°C Ambient Operating Temperature Range – Device HBM ESD Classification Level 2 – Device CDM ESD Classification Level C |
|
|
|
|
Texas Instruments |
High-Speed Comparators • Fast propagation delay: 2.5 ns • Low overdrive dispersion: 600 ps • High toggle frequency: 325 MHz • Narrow pulse width detection capability: 1.25 ns • Push-pull output • Wide supply range: 2.4 V to 5.5 V • Input common-mode range extends 200 mV be |
|
|
|
|
Texas Instruments |
Nanopower Comparator •1 Low Quiescent Current: 75 nA • Wide Supply: – 0.9 V to 6.5 V – ±0.45 V to ±3.25 V • MicroPackages: DFN-6 (1 mm × 1 mm), 5-Pin SC70 • Input Common-Mode Range Extends 100 mV Beyond Both Rails • Response Time: 24 µs • Low Input Offset Voltage: ±3 mV |
|
|
|
|
Texas Instruments |
Low-Power Wide Bandwidth Single Supply Op Amps D Rail-To-Rail Output D VICR Includes Ground D Gain-Bandwidth Product . . . 9 MHz D Supply Current . . . 730 µA/Channel D Single, Duals, and Quad Versions D Ultralow Power Down Mode IDD(SHDN) = 4 µA/Channel D Specified Temperature Range −40°C to 125° |
|
|
|
|
Texas Instruments |
Rail-to-Rail I/O Operational Amplifier •1 Cost-Optimized Precision Amplifier nanoPower: 800 nA/Ch (Typ) • Low Offset Voltage: 400 µV (Typ) • Rail-to-Rail Input and Output • Zero-Crossover Distortion • Low Offset Drift: 0.5 µV/°C (Typ) • Gain-Bandwidth Product: 12 kHz • Supply Voltage: 1.8 |
|
|
|
|
Texas Instruments |
2.7 V High-Slew-Rate Rail-to-Rail Output Op Amps reliable operation over an extended temperature range. This includes, but is not limited to, Highly Accelerated Stress Test (HAST) or biased 85/85, temperature cycle, autoclave or unbiased HAST, electromigration, bond intermetallic life, and mold co |
|
|
|
|
Texas Instruments |
Rail-to-Rail Input/Output Operational Amplifiers or maximum dynamic range in low-voltage systems. The amplifier output has rail-to-rail performance with high-output-drive capability, solving one of the limitations of older rail-to-rail input/output operational amplifiers. This rail-to-rail dynamic |
|
|
|
|
Texas Instruments |
Rail-to-Rail Input/Output Operational Amplifiers or maximum dynamic range in low-voltage systems. The amplifier output has rail-to-rail performance with high-output-drive capability, solving one of the limitations of older rail-to-rail input/output operational amplifiers. This rail-to-rail dynamic |
|
|
|
|
Texas Instruments |
Rail-to-Rail I/O Operational Amplifier •1 Cost-Optimized Precision Amplifier nanoPower: 800 nA/Ch (Typ) • Low Offset Voltage: 400 µV (Typ) • Rail-to-Rail Input and Output • Zero-Crossover Distortion • Low Offset Drift: 0.5 µV/°C (Typ) • Gain-Bandwidth Product: 12 kHz • Supply Voltage: 1.8 |
|
|
|
|
Texas Instruments |
200-mA Low-Dropout Regulator •1 Very Low Dropout: – 43 mV at IOUT = 50 mA, VOUT = 2.8 V – 85 mV at IOUT = 100 mA, VOUT = 2.8 V – 175 mV at IOUT = 200 mA, VOUT = 2.35 V • 2% Accuracy • Low IQ: 31 μA • Available in Fixed-Output Voltages from 1.2 V to 4.8 V • High PSRR: 68 dB at 1 |
|
|
|
|
Texas Instruments |
2-A High Efficiency Synchronous Buck Converter •1 Up to 95% Efficiency • Low RDS(ON) Switches 100 mΩ / 60 mΩ • 2.5-V to 5.5-V Input Voltage Range • Adjustable Output Voltage from 0.6 V to VIN • Power Save Mode for Light Load Efficiency • 100% Duty Cycle for Lowest Dropout • 35-µA Operating Quiesc |
|
|
|
|
Texas Instruments |
Low-Power Stereo Audio Codec • Stereo audio DAC: – 102-dBA signal-to-noise ratio – 16-, 20-, 24-, or 32-bit data – Supports sample rates from 8 kHz to 96 kHz – 3D, bass, treble, EQ, or de-emphasis effects – Flexible power saving modes and performance are available • Stereo audio |
|
|
|
|
Texas Instruments |
Low-Power Serial Analog-to-Digital is further enhanced with software/hardware/autopower-down modes and programmable conversion speeds. The conversion clock (OSC) and reference are built-in. The converter can use the external SCLK as the source of the conversion clock to achieve higher |
|
|
|
|
Texas Instruments |
Rail-to-Rail Input/Output Operational Amplifiers or maximum dynamic range in low-voltage systems. The amplifier output has rail-to-rail performance with high-output-drive capability, solving one of the limitations of older rail-to-rail input/output operational amplifiers. This rail-to-rail dynamic |
|
|
|
|
Texas Instruments |
WIDE-INPUT-VOLTAGE OPERATIONAL AMPLIFIERS with single- or split-supplies makes this family a great choice when interfacing with analog-to-digital converters (ADCs). For precision applications, the TLV244xA is available with a maximum input offset voltage of 950 µV. If the design requires si |
|
|
|
|
Texas Instruments |
RAIL-TO-RAIL INPUT/OUTPUT HIGH-DRIVE OPERATIONAL AMPLIFIERS • CMOS Rail-To-Rail Input/Output • Input Bias Current: 2.5pA • Low Supply Current: 600μA/Channel • Ultra-Low Power Shutdown Mode: IDD(SHDN): 350nA/ch at 3V IDD(SHDN): 1000nA/ch at 5V • Gain-Bandwidth Product: 2.8MHz • High Output Drive Capability: – |
|
|
|
|
Texas Instruments |
Rail-to-Rail Input/Output OpAmps lifier provides high output drive capability, solving a major shortcoming of older micropower rail-to-rail input/output operational amplifiers. The TLV245x can swing to within 250 mV of each supply rail while driving a 2.5-mA load. Both the inputs an |
|
|
|
|
Texas Instruments |
Low-Dropout Linear Regulator • Input voltage range: – 2.5 V to 24 V (30 V max for new chip only) • Available output voltage options: – Fixed: 1.8 V to 5 V • Output current: Up to 150 mA • Very low IQ: 3.4 μA at 100-mA load current • Stable with output capacitor ≥ 0.47 μF • Overc |
|
Desde 2024. D4U Semiconductor.
|