etcTI SM7 Hoja de datos

No.	parte #	Fabricante	Descripción
1	SM73201	ETCTI	SM73201 16-Bit 50 to 250 kSPS Differential Input MicroPower ADC (Rev. B)
2	SM72501	Texas Instruments	Wide Supply Range Amplifier 1 •2 Renewable Energy Grade Unless Otherwise noted, Typical values at VS = 5V • Input Offset Voltage ±200 µV (max) • Input Bias Current ±200 fA • Input Voltage Noise 9 nV/√Hz • CMRR 130 dB • Open Loop Gain 130 dB • Temperature Range −40°C to 125°C •
3	SM74503	ETCTI	SM74503 800mA Low-Dropout Linear Regulator (Rev. A)
4	SM72485	Texas Instruments	Constant On-Time Buck Switching Regulator •1 Operating Input Voltage: 6 V to 95 V • Integrated 100-V, N-Channel Buck Switch • Internal Start-Up Regulator • No Loop Compensation Required • Ultra-Fast Transient Response • On-time Varies Inversely With Input Voltage • Operating Frequency Remain
5	SM72480	Texas Instruments	WSON-6 Factory Preset Temperature Switch and Temperature Sensor 1 •2 Renewable Energy Grade • Low 1.6V Operation • Latching Function: Device Can Latch the Over Temperature Condition • Push-pull and Open-Drain Temperature Switch Outputs • Very Linear Analog VTEMP Temperature Sensor Output • VTEMP Output Short-circ
6	SM73403	ETCTI	SM73403 Single General Purpose Voltage Comparator (Rev. A)
7	SM74301	ETCTI	SM74301 100V 350 mA Constant On-Time Buck Switching Regulator (Rev. A)
8	SM72482	Texas Instruments	Dual 5A Compound Gate Driver 1 •2 Renewable Energy Grade • Independently Drives Two N-Channel MOSFETs • Compound CMOS and Bipolar Outputs Reduce Output Current Variation • 5A Sink, 3A Source Current Capability • Two Channels Can be Connected in Parallel to Double the Drive Curre
9	SM72295	Texas Instruments	Photovoltaic Full Bridge Driver 1 •2 Renewable Energy Grade • Dual Half Bridge MOSFET Drivers • Integrated 100V Bootstrap Diodes • Independent High and Low Driver Logic Inputs • Bootstrap Supply Voltage Range up to 115V DC • Two Current Sense Amplifiers with Externally Programmable
10	SM73307	Texas Instruments	CMOS Input Amplifier 1 •2 Unless Otherwise Noted, Typical Values at VS = 5V. • Renewable Energy Grade • Input Offset Voltage ±150 μV (max) • Input Bias Current 100 fA • Input Voltage Noise 5.8 nV/√Hz • Gain Bandwidth Product 17 MHz • Supply Current 1.30 mA • Supply Volta
11	SM73710	ETCTI	SM73710 2.7V SOT-23 Temperature Sensor (Rev. A)
12	SM74202	ETCTI	SM74202 100V Current Mode PWM Controller (Rev. A)
13	SM74203	ETCTI	SM74203 60V Low Side Controller for Boost and SEPIC (Rev. A)
14	SM74304	ETCTI	SM74304 High Voltage (80V) Step Down Switching Regulator (Rev. A)
15	SM74601	ETCTI	SM74601 SOT-23 Precision Micropower Series Voltage Reference (Rev. A)
16	SM74101	Texas Instruments	Tiny 7A MOSFET Gate Driver •1 Renewable Energy Grade • Compound CMOS and Bipolar Outputs Reduce Output Current Variation • 7A sink/3A Source Current • Fast Propagation Times (25 ns Typical) • Fast Rise and Fall Times (14 ns/12 ns Rise/Fall with 2 nF Load) • Inverting and Non-I
17	SM74104	Texas Instruments	High Voltage Half-Bridge Gate Driver •1 Renewable Energy Grade • Drives both a High Side and Low Side N-Channel MOSFET • Adaptive Rising and Falling Edges with Programmable Additional Delay • Single Input Control • Bootstrap Supply Voltage Range up to 118V DC • Fast Turn-Off Propagation
18	SM72445	Texas Instruments	Programmable Maximum Power Point Tracking Controller 1 •2 Renewable Energy Grade • 110kHz,135kHz or 215kHz PWM Operating Frequency • Panel Mode Pin for Optional Bypass Switch Control • Programmable Maximum Power Point Tracking • Photovoltaic Solar Panel Voltage and Current Diagnostic • Single Inductor
19	SM72442	Texas Instruments	Programmable Maximum Power Point Tracking Controller 1 •2 Renewable Energy Grade • Programmable Maximum Power Point Tracking • Photovoltaic Solar Panel Voltage and Current Diagnostic • Single Inductor Four Switch Buck-Boost Converter Control • I2C Interface for Communication • VOUT Overvoltage Protecti
20	SM72240	Texas Instruments	Microprocessor Reset 1 •2 Renewable Energy Grade • Precise monitoring of 5V supply voltages • Fully specified over temperature – −40°C to +125°C • 100 ms minimum Power-On Reset pulse width, 190 ms typical: – Active-Low RESET Open Drain Output • RESET Output valid for VCC