| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Texas Instruments |
I2C RGB LED Drivers •1 Operating Voltage Range: – VCC Range: 2.7 V to 5.5 V – EN, SDA, and SCL Pins Compatible With 1.8-V, 3.3-V, and 5-V Power Rails – Output Maximum Voltage: 6 V • 24 Constant-Current Sinks With High Precision – 25.5 mA Maximum per Channel With VCC in |
|
|
|
|
Texas Instruments |
Ultra-Low-Noise LDO •1 Input Voltage Range, 2.5 V to 5.5 V • Output Voltage Range, 1.5 V to 4.5 V • Stable with 0.47-μF Ceramic Input and Output Capacitors • No Noise Bypass Capacitor Required • Logic Controlled Enable • Thermal-Overload and Short-Circuit Protection • − |
|
|
|
|
Texas Instruments |
Energy Management 1 •2 Supports High-Efficiency PowerWise Technology Adaptive Voltage Scaling • PWI Open Standard Interface for System Power Management • Digitally Controlled Intelligent Voltage Scaling • 1 MHz PWM Switching Frequency • Auto or PWI Controlled PFM Mode |
|
|
|
|
Texas Instruments |
Lighting Management 1 •2 High efficiency boost converter with programmable output voltage up to 20V • 2 individual drivers for serial display backlight LEDs • Automatic dimming controller • Stand alone RGB controller • Dedicated flash function • Safety function to avoid |
|
|
|
|
Texas Instruments |
AVS Energy Management 1 •2 SPMI Bus for System-Level Power Management • High-Efficiency PowerWise® Technology Adaptive Voltage Scaling for Intelligent Energy Management in AVS and DVS Environments • Two Digitally Programmable 3.6 MHz Buck Regulators to Power Dual Voltage |
|
|
|
|
Texas Instruments |
Low Dropout Voltage Regulator 1 •2 Operation from 2.2V to 5.5V Input • ±1% Accuracy Over Temp Range • Output Voltage from 0.8V to 3.6V in 50mV Increments • 30 μA Quiescent Current (Enabled) • 10nA Quiescent Current (Disabled) • 160mV Dropout at 200mA Load • 60 μVRMSOutput Voltage |
|
|
|
|
Texas Instruments |
Adjustable LDO •1 Wide Input Voltage Range: 1.3 V to 6 V • Low VIN Voltage Without Extra Bias Voltage • Adjustable Output Voltage: 0.5 V to 5 V • Low Dropout: 200 mV at 2-A Load • Low Output Voltage Noise: 25 μVRMS • Output Current: 2 A • –40˚C to +125°C Operating |
|
|
|
|
Texas Instruments |
Linear Regulator 1 • Stable with 1.0 µF Ceramic Input and Output Capacitors • No Noise Bypass Capacitor Required • Remote Output Capacitor Placement • Thermal-overload and Short-circuit Protection • –40°C to +125°C Junction Temperature Range for Operation APPLICATION |
|
|
|
|
Texas Instruments |
Low-noise LDO • For a more updated portfolio device, see the TPS7A20 • Input voltage range: 2.2V to 5.5V • Output voltage range: 1.2V to 4.5V • Stable with 1-µF ceramic input and output capacitors • No noise bypass capacitor required • Remote output capacitor plac |
|
|
|
|
Texas Instruments |
30-Channel 12-Bit PWM Ultra-low Quiescent Current I2C RGB LED Drivers •1 Operating Voltage Range: – VCC Range: 2.7 V to 5.5 V – EN, SDA, and SCL Pins Compatible With 1.8- V, 3.3-V, and 5-V Power Rails – Output Maximum Voltage: 6 V • 36 Constant-Current Sinks With High Precision – 25.5 mA Maximum per Channel When VCC in |
|
|
|
|
Texas Instruments |
9-channel LED driver •1 Three Independent Program Execution Engines, Nine Programmable Outputs with 25.5-mA FullScale Current, 8-Bit Current Setting Resolution, and 12-Bit PWM Control Resolution • Adaptive High-Efficiency 1×/1.5× Fractional Charge Pump - Efficiency Up to |
|
|
|
|
Texas Instruments |
9-channel LED driver •1 Three Independent Program Execution Engines, 9 Programmable Outputs With 25.5-mA Full-Scale Current, 8-Bit Current Setting Resolution and 12-Bit PWM Control Resolution • Adaptive High-Efficiency 1×/1.5× Fractional Charge Pump - Efficiency up to 94 |
|
|
|
|
Texas Instruments |
Low-noise LDO •1 Input Voltage Range: 1.3 V to 3.3 V • Output Voltage Range: 0.8 V to 2.3 V • Output Current: 300 mA • PSRR: 75 dB at 1 kHz • Output Voltage Tolerance: ±2% • Low Dropout: 120 mV (Typical) • Very Low IQ (Enabled, No Load): 12 µA • Low Output-Voltage |
|
|
|
|
Texas Instruments |
Energy Management 1 •23 2 300 mA Buck Regulators Operate 180 Degrees out of Phase for Reduced EMI • 1 MHz PWM Switching Frequency • 4 Programmable LDOs Ideal for I/O (Two of These), PLL, and Memory Retention Supply Generation • Supports High-Efficiency PowerWise Techn |
|
|
|
|
Texas Instruments |
12-Bit PWM Ultra-low Quiescent Current I2C RGB LED Drivers • Operating voltage range: – VCC range: 2.7 V to 5.5 V – EN, SDA, and SCL pins compatible with 1.8-V, 3.3-V, and 5-V power rails – Output maximum voltage: 6 V • 12 Constant-current sinks with high precision – 25.5 mA Maximum per channel with VCC in f |
|
|
|
|
Texas Instruments |
12-Bit PWM Ultra-low Quiescent Current I2C RGB LED Drivers • Operating voltage range: – VCC range: 2.7 V to 5.5 V – EN, SDA, and SCL pins compatible with 1.8-V, 3.3-V, and 5-V power rails – Output maximum voltage: 6 V • 12 Constant-current sinks with high precision – 25.5 mA Maximum per channel with VCC in f |
|
|
|
|
Texas Instruments |
I2C RGB LED Drivers •1 Operating Voltage Range: – VCC Range: 2.7 V to 5.5 V – EN, SDA, and SCL Pins Compatible With 1.8-V, 3.3-V, and 5-V Power Rails – Output Maximum Voltage: 6 V • 24 Constant-Current Sinks With High Precision – 25.5 mA Maximum per Channel With VCC in |
|
|
|
|
Texas Instruments |
30-Channel 12-Bit PWM Ultra-low Quiescent Current I2C RGB LED Drivers •1 Operating Voltage Range: – VCC Range: 2.7 V to 5.5 V – EN, SDA, and SCL Pins Compatible With 1.8- V, 3.3-V, and 5-V Power Rails – Output Maximum Voltage: 6 V • 36 Constant-Current Sinks With High Precision – 25.5 mA Maximum per Channel When VCC in |
|
|
|
|
Texas Instruments |
Four-Channel RGB- or White-LED Driver •1 Four Independently Programmable LED Outputs With 8-Bit Current Setting (From 0 mA to 25.5 mA With 100-μA Steps) and 8-Bit PWM Control • Typical LED Output Saturation Voltage 60 mV and Current Matching 1% • Flexible PWM Control for LED Outputs • Au |
|
|
|
|
Texas Instruments |
Programmable Single-LED Driver •1 Wide Input-Voltage Range: 2.7 V to 5.5 V • Adjustable Output Current: 2.8 mA to 19.5 mA • Programmable Blinking Sequence with Current Rise and Fall Time Control • Default Blinking Sequence for Simple Systems Without Programming Capabilities • Sing |
|
Desde 2024. D4U Semiconductor.
|