| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Texas Instruments |
LOW-VOLTAGE 20-BIT FET BUS SWITCH ensures that damaging current will not backflow through the device when it is powered down. The device has isolation during power off. DGV OR DL PACKAGE (TOP VIEW) NC 1 1A1 2 1A2 3 1A3 4 1A4 5 1A5 6 1A6 7 GND 8 1A7 9 1A8 10 1A9 11 1A10 12 2A1 13 2A |
|
|
|
|
Texas Instruments |
32-Bit FET Bus Switch the outputs, preventing damaging current backflow through the device when it is powered down. SN74CBT34X245 32-BIT FET BUS SWITCH SCDS089C – MAY 1999 – REVISED MAY 2001 DBB PACKAGE (TOP VIEW) NC 1 1A1 2 1A2 3 1A3 4 1A4 5 1A5 6 1A6 7 1A7 8 1A8 9 G |
|
|
|
|
Texas Instruments |
1-of-8 FET Multiplexer/Demultiplexer •1 5-Ω Switch Connection Between Two Ports • TTL-Compatible Input Levels • Low Crosstalk Between Switches • Fast Switching and Propagation Speeds • Operating Temperature Range: –40°C to 85°C 2 Applications • Digital Radio • Signal Gating • Factory Au |
|
|
|
|
Texas Instruments |
8-BIT FET BUS SWITCH ensures that damaging current will not backflow through the device when it is powered down. The device has isolation during power off. To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resisto |
|
|
|
|
Texas Instruments |
Octal FET Bus Switch ions to be made with minimal propagation delay. The device is organized as one 8-bit switch. When the output-enable (OE) input is low, the switch is on, and port A is connected to port B. When OE is high, the switch is open, and the high-impedance st |
|
|
|
|
Texas Instruments |
10-BIT FET BUS SWITCH ensures that damaging current will not backflow through the device when it is powered down. The device has isolation during power off. To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resisto |
|
|
|
|
Texas Instruments |
QUADRUPLE FET BUS SWITCH independent line switches. Each switch is disabled when the associated output-enable (OE) input is high. To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the re |
|
|
|
|
Texas Instruments |
QUADRUPLE FET BUS SWITCH independent line switches. Each switch is disabled when the associated output-enable (OE) input is low. To ensure the high-impedance state during power up or power down, OE should be tied to GND through a pulldown resistor; the minimum value of the r |
|
|
|
|
Texas Instruments |
QUADRUPLE FET BUS SWITCH independent line switches. Each switch is disabled when the associated output-enable (OE) input is low. To ensure the high-impedance state during power up or power down, OE should be tied to GND through a pulldown resistor; the minimum value of the r |
|
|
|
|
Texas Instruments |
18-BIT FET BUS-EXCHANGE SWITCHES 35 5B2 34 GND 33 6B1 32 6B2 31 7B1 30 7B2 29 GND 28 8B1 27 8B2 26 9B1 25 9B2 ORDERING INFORMATION TA PACKAGE† ORDERABLE PART NUMBER TOP-SIDE MARKING −40°C to 85°C SSOP − DL TSSOP − DGG Tube Tape and reel Tape and reel SN74CBT16209ADL SN74CB |
|
|
|
|
Texas Instruments |
10-Bit Bus-Exchange Switch •1 High-Bandwidth Data Path (Up to 200 MHz) • Low and Flat ON-State Resistance (rON) Characteristics Over Operating Range (rON = 5 Ω Typical) • Control Inputs Can Be Driven by TTL or 5-V and 3.3-V CMOS Outputs • Bidirectional Data Flow With Near-Zero |
|
|
|
|
Texas Instruments |
10-Bit FET Bus Switch open. When ON is high or VCC is 0 V, B port is precharged to BIASV through the equivalent of a 10-kΩ resistor. ORDERING INFORMATION TA PACKAGE† ORDERABLE PART NUMBER TOP-SIDE MARKING SOIC – DW Tube Tape and reel SN74CBT6800ADW SN74CBT6800ADWR |
|
|
|
|
Texas Instruments |
4-BIT 1-OF-2 FET MULTIPLEXER/DEMULTIPLEXER reel SSOP (QSOP) − DBQ Tape and reel SN74CBT3257DBR CU257 SN74CBT3257DBQR CU257 TSSOP − PW Tube Tape and reel SN74CBT3257PW SN74CBT3257PWR CU257 † Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guide |
|
|
|
|
Texas Instruments |
DUAL 1-OF-4 FET MULTIPLEXER/DEMULTIPLEXER 253 TSSOP − PW Tube Tape and reel SN74CBT3253PW SN74CBT3253PWR CU253 † Package drawings, standard packing quantities, thermal data, symbolization, and PCB design guidelines are available at www.ti.com/sc/package. 1OE X H L L L L FUNCTION TABLE |
|
|
|
|
Texas Instruments |
8-BIT FET BUS SWITCH ensures that damaging current will not backflow through the device when it is powered down. The device has isolation during power off. To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resisto |
|
|
|
|
Texas Instruments |
DUAL FET BUS SWITCH • Undershoot Protection for OFF Isolation on A and B Ports up to –2 V • Bidirectional Data Flow With Near-Zero Propagation Delay • Low ON-State Resistance (ron) Characteristics (ron = 3 Ω Typ) • Low Input/Output Capacitance Minimizes Loading and Sig |
|
|
|
|
Texas Instruments |
10-BIT FET BUS SWITCH reel −40°C to 85°C SSOP (QSOP) − DBQ Tape and reel SN74CBT3384ADBR SN74CBT3384ADBQR CU384A CBT3384A TSSOP − PW Tube Tape and reel SN74CBT3384APW SN74CBT3384APWR CU384A TVSOP − DGV Tape and reel SN74CBT3384ADGVR CU384A † Package drawings, st |
|
|
|
|
Texas Instruments |
QUADRUPLE FET BUS SWITCH ensures that damaging current will not backflow through the device when it is powered down. The device has isolation during power off. Please be aware that an important notice concerning availability, standard warranty, and use in critical applicati |
|
|
|
|
Texas Instruments |
QUADRUPLE FET BUS SWITCH ensures that damaging current will not backflow through the device when it is powered down. The device has isolation during power off. Please be aware that an important notice concerning availability, standard warranty, and use in critical applicati |
|
|
|
|
Texas Instruments |
LOW-VOLTAGE OCTAL FET BUS SWITCH • Standard '245-Type Pinout • 5-Ω Switch Connection Between Two Ports • Rail-to-Rail Switching on Data I/O Ports • Ioff Supports Partial-Power-Down Mode Operation DBQ, DGV, DW, OR PW PACKAGE (TOP VIEW) NC 1 A1 2 A2 3 A3 4 A4 5 A5 6 A6 7 A7 8 A8 9 GN |
|
Desde 2024. D4U Semiconductor.
|