| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Texas Instruments |
Integrated Analog Front-End •1 Transmitter: – Supports Common Anode LED Configuration – Dynamic Range: 100 dB – 8-Bit Programmable LED Current to 50 mA (Extendable to 100 mA) – Programmable LED On-Time – Simultaneous Support of 3 LEDs for Optimized SpO2, HRM, or Multi-Wavelengt |
|
|
|
|
Texas Instruments |
RF-sampling AFE •1 Four, 14-bit, 9-GSPS DACs – Up to 800-MHz signal bandwidth – 1 DSA per channel tunes output power • Four, 14-Bit, 3-GSPS ADCs – Up to 800-MHz signal bandwidth – NSD: –151 dBFS/Hz – AC performance at fIN = 2.6 GHz, –3 dBFS – SNR: 55 dBFS – SFDR: 73 |
|
|
|
|
Texas Instruments |
256-Channel Analog Front-End 1 •23 256 Channels • On-Chip, 14-Bit ADC • High Performance: – Noise: 758 electronRMS (eRMS) with 28-pF Sensor Capacitor in 1.2-pC Range – Integral Nonlinearity: ±1.25 LSB with Internal 14-Bit ADC – Minimum Scan Time: – Normal Mode: 37.9 µs, Internal |
|
|
|
|
Texas Instruments |
256-Channel Analog Front-End •1 256 Channels • On-Chip, 16-Bit ADC • Photodiode Short Immunity • High Performance: – Noise: 750 Electrons RMS (1.2-pC Input Charge Range) – Low Correlated Noise – Integral Nonlinearity: ±2 LSB with Internal 16-Bit ADC – Scan Time: – < 20 µs to 204 |
|
|
|
|
Texas Instruments |
Quad-Channel General Purpose RF Transceiver •1 Quad transmitters based on direct up-conversion architecture: – Up to 600 MHz of RF transmitted bandwidth per chain • Quad receivers based on 0-IF down-conversion architecture: – Up to 200 MHz of RF received bandwidth per chain • Feedback chain ba |
|
|
|
|
Texas Instruments |
Integrated Analog Front-End •1 Fully-Integrated Analog Front-End for Pulse Oximeter Applications: – Flexible Pulse Sequencing and Timing Control • Transmit: – Integrated LED Driver (H-Bridge, Push, or Pull) – 110-dB Dynamic Range Across Full Range (Enables Low Noise at Low LED |
|
|
|
|
ETCTI |
TP5510 Full Duplex Analog Front End (AFE) for Consumer Applications (Rev. A) |
|
|
|
|
Texas Instruments |
8-Channel Ultrasound Analog Front-End •1 8-Channel Complete Analog Front-End – LNA, VCAT, PGA, LPF, ADC, and CW Mixer • Programmable Gain Low-Noise Amplifier (LNA) – 24-, 18-, 12-dB Gain – 0.25-, 0.5-, 1-VPP Linear Input Range – 0.63-, 0.7-, 0.9-nV/rtHz Input Referred Noise – Programmabl |
|
|
|
|
Texas Instruments |
Quad-Channel Analog Front-End •1 Qualified for Automotive Applications • AEC-Q100 Qualified With the Following Results: – Device Temperature Grade 1: –40°C to 125°C Ambient Operating Temperature Range – Device HBM ESD Classification Level 2 – Device CDM ESD Classification Level C |
|
|
|
|
Texas Instruments |
Mixed-Signal Microcontroller 1 • Low Supply Voltage Range: 1.8 V to 3.6 V • Ultra-Low Power Consumption – Active Mode: 220 µA at 1 MHz, 2.2 V – Standby Mode: 0.5 µA – Off Mode (RAM Retention): 0.1 µA • Five Power-Saving Modes • Ultra-Fast Wake-up From Standby Mode in Less Than 1 |
|
|
|
|
Texas Instruments |
Mixed-Signal Microcontroller 1 • Low Supply Voltage Range: 1.8 V to 3.6 V • Ultra-Low Power Consumption – Active Mode: 220 µA at 1 MHz, 2.2 V – Standby Mode: 0.5 µA – Off Mode (RAM Retention): 0.1 µA • Five Power-Saving Modes • Ultra-Fast Wake-up From Standby Mode in Less Than 1 |
|
|
|
|
Texas Instruments |
Mixed-Signal Microcontroller 1 • Low Supply Voltage Range: 1.8 V to 3.6 V • Ultra-Low Power Consumption – Active Mode: 220 µA at 1 MHz, 2.2 V – Standby Mode: 0.5 µA – Off Mode (RAM Retention): 0.1 µA • Five Power-Saving Modes • Ultra-Fast Wake-up From Standby Mode in Less Than 1 |
|
|
|
|
Texas Instruments |
Mixed-Signal Microcontroller 1 • Low Supply Voltage Range: 1.8 V to 3.6 V • Ultra-Low Power Consumption – Active Mode: 220 µA at 1 MHz, 2.2 V – Standby Mode: 0.5 µA – Off Mode (RAM Retention): 0.1 µA • Five Power-Saving Modes • Ultra-Fast Wake-up From Standby Mode in Less Than 1 |
|
|
|
|
Texas Instruments |
5-10 cell Li-ion Battery protection AFE 1 • 5, 6, 7, 8, 9, or 10 Series-Cell Primary Protection • PMOS FET Drive for Charge and Discharge FETs • Capable of Operation with 1-mΩ Sense Resistor • Supply Voltage Range from 7 V to 50 V • Low Supply Current of 450 µA Typical • Integrated 5-V, 25 |
|
|
|
|
Texas Instruments |
24-Bit Sensor AFE • 24-Bit, Low-Power Sigma-Delta ADC • True Continuous Background Calibration at all Gains • In-Place System Calibration Using Expected Value Programming • Low-Noise Programmable Gain (1x to 128x) • Continuous Background Open / Short and Out-of- Range |
|
|
|
|
Texas Instruments |
24-Bit Sensor AFE • 24-Bit, Low-Power Sigma-Delta ADC • True Continuous Background Calibration at all Gains • In-Place System Calibration Using Expected Value Programming • Low-Noise Programmable Gain (1x to 128x) • Continuous Background Open / Short and Out-of- Range |
|
|
|
|
Texas Instruments |
24-Bit Sensor AFE • 24-Bit, Low-Power Sigma-Delta ADC • True Continuous Background Calibration at all Gains • In-Place System Calibration Using Expected Value Programming • Low-Noise Programmable Gain (1x to 128x) • Continuous Background Open / Short and Out-of- Range |
|
|
|
|
Texas Instruments |
Multi-Channel 16-Bit Sensor AFE 1 •23 16-Bit Low-Power Sigma Delta ADC • True Continuous Background Calibration at All Gains • In-Place System Calibration Using Expected Value Programming • Low-Noise Programmable Gain (1x - 128x) • Continuous Background Open/Short and Out of Range |
|
|
|
|
Texas Instruments |
Configurable AFE 1 •2 Dual Channel Input • Programmable Gain Amplifier • “Dark Signal” Offset Cancellation • Supports External Filtering • Common Mode Generator and 8 Bit DAC • Package 14 Pin TSSOP APPLICATIONS • NDIR Sensing • Demand Control Ventilation • Building M |
|
|
|
|
Texas Instruments |
Configurable AFE •1 Programmable Gain Amplifier • Dark Signal Offset Cancellation • Supports External Filtering • Common-Mode Generator and 8-Bit DAC • Key Specifications – Programmable Gain 167 to 7986 V/V – Low Noise (0.1 to 10 Hz) 0.1 μVRMS – Gain Drift 100 ppm/°C |
|
Desde 2024. D4U Semiconductor.
|