| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Toshiba |
BiCD Integrated Circuit Silicon Monolithic z They are similar substituting products of TA7774PG, TA7774FG, and TA7774FAG. Both products have same packages and same pin assignments. z One-chip two-phase bipolar stepping motor driver (including two bridge drivers) z Power saving operation is av |
|
|
|
|
Toshiba |
CLOCK-in controlled Bipolar Stepping Motor Driver ・BiCD process integrated monolithic IC. ・Capable of controlling 1 bipolar stepping motor. ・PWM controlled constant-current drive. ・Allows full, half, quarter step operation. ・Low on-resistance (High + Low side=0.49Ω(typ)) MOSFET output stage. ・High e |
|
|
|
|
Toshiba |
Clock controlled Unipolar stepping motor driver ・BiCD processed monolithic integrated circuit. HZIP25-P-1.00F Weight 7.6(g)（typ.） ・Capable of operating one unipolar stepping motor. ・PWM controlled constant current drive. ・Full, half(a), half(b), quarter, 1/8, 1/16, 1/32 step resolution. ・Low |
|
|
|
|
Toshiba Semiconductor |
PWM Chopper-Type bipolar Stepping Motor Driver • • • • • • www.DataSheet4U.com TB6560FG Single-chip bipolar sinusoidal micro-step stepping motor driver Uses high withstand voltage BiCD process: Ron (upper lower) = 0.6 Ω (typ.) Forward and reverse rotation control available Selectable phase dr |
|
|
|
|
Toshiba |
Clock controlled Unipolar stepping motor driver ・BiCD processed monolithic integrated circuit. P-WQFN48-0707-0.50-003 Weight 0.1(g)（typ.） ・Capable of operating one unipolar stepping motor. ・PWM controlled constant current drive. ・Full, half(a), half(b), quarter, 1/8, 1/16, 1/32 step resolution |
|
|
|
|
Toshiba |
Active Gain Control Clock-in control Bipolar stepping motor driver Weight 0.14 g (typ.) • Built-in Anti-stall architecture (AGC: Active Gain Control) • Built-in sense resistor less current control architecture (ACDS: Advanced Current Detection System) • Low Rds (on) MOSFET (High side+ Low side=0.6 Ω (typ.)) • B |
|
|
|
|
Toshiba |
PHASE-in controlled Bipolar Stepping Motor Driver ・BiCD process integrated monolithic IC. ・Capable of controlling 1 bipolar stepping motor. ・PWM controlled constant-current drive. ・Allows full, half, quarter step operation. ・Low on-resistance (High + Low side=0.49Ω(typ)) MOSFET output stage. ・High e |
|
|
|
|
Toshiba |
Active Gain Control Serial Control Bipolar stepping motor driver P-VQFN48-0707-0.50-004 Weight: 0.14 g (typ.) ・ Built-in Anti-stall architecture (AGC: Active Gain Control) ・ Built-in sense resistor less current control architecture (ACDS: Advanced Current Detection System) ・ Low Rds (on) MOSFET (High side+ Low |
|
|
|
|
Toshiba |
3-Phase Full-Wave Sine-Wave PWM Brushless Motor Controller • • • • • • • • Sine-wave PWM control Built-in triangular-wave generator (Carrier cycle = fOSC/252 (Hz)) Built-in lead angle control function (0° to 58° in 32 steps) Built-in dead time function (setting 2.6 μs or 3.8 μs) Bootstrap circuit compliant O |
|
|
|
|
Toshiba Semiconductor |
Stepping Motor Driver • Motor power supply voltage: VM = 15 V (max) Weight: 0.09 g (typ.) • Control power supply voltage: VCC = 2.7 to 6 V • Output current: Iout ≤ 0.8 A (max) • Output ON-resistance: Ron = 1.5 Ω (upper and lower sum@VM = 5 V) • Decoder that enables m |
|
|
|
|
Toshiba |
7-SEGMENT DRIVERS WITH BUILT-IN DECODERS • • • • • • • • Constant Current segment drivers for consistent display brightness. Single device saves labor and board space. Internal character set simplifies design efforts. Automatically handles multiplex and display refresh tasks. 16 step progra |
|
|
|
|
Toshiba |
16BIT SHIFT REGISTER / LATCHES & CONSTANT CURRENT DRIVERS Constant Current Output : Can set up all output current with one resister for 5 to 90 mA. Maximum Clock Frequency : fCLK = 15 (MHz) (Cascade Connected Operate, Topr = 25°C) 5 V C−MOS Compatible Input Package : SDIP24−P−300−1.78~1.778mmPitch~ (TB |
|
|
|
|
Toshiba |
Single-Stepping Motor Driver IC • One stepping motor driven by micro-step pseudo sine wave is controlled by a single driver IC Weight: 0.79 g (typ.) • Enables to drive two-way supply voltage using a pair of step-down DC/DC converters • Monolithic Bi-CMOS IC Low ON-resistance of R |
|
|
|
|
Toshiba |
DC-DC Converter and Reset function-IC • The following motor combinations can be used. Stepper (1) (2) (3) (4) (5) (6) Dual motors Single motor Single motor ⎯ ⎯ ⎯ DC Large DC (L) ⎯ Single motor ⎯ Single motor Dual motors ⎯ DC Small DC (S) ⎯ ⎯ Dual motors Dual motors ⎯ Quadruple motors No |
|
|
|
|
Toshiba |
10 BIT SERIAL-IN PARALLEL-OUT SHIFT REGISTER/ LATCH/10SEGMENT LED DRIVERS 10bit serial−in parallel−out shift register / latch / 10segment LED driver (Bi−CMOS process) CMOS compatible inputs Open−drain DMOS outputs Low steady−state power consumption Serial data output for cascade operation Packge ; P−type DIP−20−P−300A F−ty |
|
|
|
|
Toshiba |
10 BIT SERIAL-IN PARALLEL-OUT SHIFT REGISTER/ LATCH/10SEGMENT LED DRIVERS 10bit serial−in parallel−out shift register / latch / 10segment LED driver (Bi−CMOS process) CMOS compatible inputs Open−drain DMOS outputs Low steady−state power consumption Serial data output for cascade operation Packge ; P−type DIP−20−P−300A F−ty |
|
|
|
|
Toshiba |
8BIT SHIFT REGISTER / LATCHES & CONSTANT CURRENT DRIVERS z Constant-current Output : current with one resistor for 5 to 90mA. z Maximum Clock Frequency : fCLK = 15 (MHz) (Cascade Connecte Operate, Topr = 25°C) z 5V C−MOS Compatible Input z Package : DIP16−P−300−2.54A (TB62705CP) SSOP16−P−225−1.00A (T |
|
|
|
|
Toshiba |
8BIT CONSTANT CURRENT LED DRIVER OF OPERATING VOLTAGE 3.3V *Output Current Capability and the number of the output : 90mA X 8 outputs *Constant Current Range : 5 to 90mA *Application Output Voltage : 0.7V (output current 40 to 80 mA) 0.4V (output current 5 to 40 mA) *For Annode Common LED *Input Signal Volta |
|
|
|
|
Toshiba |
PWM method CLK-IN bipolar stepping motor driver • Drive control is possible in a bipolar stepping motor at 1 chip. • PWM controlled constant-current drive • Allows full, half and quarter ,1/8,1/16,1/32 step resolutions. P-WQFN48-0707-0.50-003 • Low on-resistance of output stage transistor is l |
|
|
|
|
Toshiba |
CLOCK-in controlled Bipolar Stepping Motor Driver ・BiCD process integrated monolithic IC. ・Capable of controlling 1 bipolar stepping motor. ・PWM controlled constant-current drive.Allows full, half, quarter step operation. ・Low on-resistance (High + Low side=0.6Ω(typ.)) MOSFET output stage. ・High vol |
|
Desde 2024. D4U Semiconductor.
|