| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Sanyo Semicon Device |
LA6358N a built-in phase correction circuit. It can also operate from a dual power supply with both positive and negative levels and features low power consumption. The LA6358NT can be used in a wide range of industrial applications as a transducer amplifier |
|
|
|
|
Sanyo Semicon Device |
Four-Channel Bridge Driver for CD Player • • • • • • • • Four bridge-connected (BTL) power amplifier circuits IO max: 1 A Built-in level shifter circuits Muting circuit (on/off control for all outputs) High output voltage (dynamic range): 6.5 V (typical, channel 1 only) Built-in input opera |
|
|
|
|
Sanyo Semicon Device |
Monolithic Linear IC • Four bridge-connected (BTL) power amplifier circuits. • IO max: 1A. • Built-in level shifter circuits. • Muting circuit (on/off control for all outputs). • Independent operational amplifier. • Variable regulator (uses an external pnp transistor for |
|
|
|
|
Sanyo Semicon Device |
6CH driver for optical disk COIL 31 30 CHANGER MOTOR M -29 28 INPUT + 3.3V Regulated Voltage + -10 INPUT 11 12 INPUT 13 14 INPUT 15 16 INPUT 17 18 REGOUT VIN1 VIN1G VIN2 VIN2G VIN3 VIN3G VIN4 VIN4G SVCC SGND VREFIN VCONT6 REV6 FWD6 VCONT5 REV5 FWD5 27 26 25 24 1.65V 23 2 |
|
|
|
|
Sanyo Semicon Device |
Monolithic Linear IC Fan Motor Driver BTL Driver Single-Phase Full-Wave self does not generate much heat. • High impedance of Hall input pin • FG output (rotation speed detection output : open collector output) • Heat protection circuit : When the large current flows because of output short-circuit, raising the IC chip t |
|
|
|
|
Sanyo Semicon Device |
4CH Bridge (BTL) Driver Monolithic Linear IC 4CH Bridge (BTL) Driver for CD The LA6563 is a 4CH bridge (BTL) driver for CD players. • Built-in bridge connection (BTL) POWER AMP 4CH • IO max 1A • MUTE circuit (main power is ON/OFF) with 3 systems • Built-in STBY circuit |
|
|
|
|
Sanyo Semicon Device |
Five-Channel CD Actuator Driver |
|
|
|
|
Sanyo Semicon Device |
Monolithic Linear IC BTL Drive Single-Phase Full-Wave Fan Motor Driver • BTL output single-phase full-wave linear drive (gain resistor : 1 to 360kΩ, 51dB) • Supports low-voltage drive and features a wide usable voltage range (2.2 to 14.0V) • Low saturation output (high side + low side saturation voltage : Vosat (total) |
|
|
|
|
Sanyo Semicon Device |
Monolithic Linear IC Fan Motor Driver BTL Driver Single-Phase Full-Wave ally, IC itself generates only small heat. • Built-in lock protection and automatic reset circuits • Built-in FG & 1/2FG outputs • Built-in Hall bias (VHB = 1.5V) • Thermal protection circuit : When the large current flows due to output short-circuit |
|
|
|
|
Sanyo Semicon Device |
Monolithic Linear IC 24V power supply h coil efficiency and small current drain. Small heat generation from IC itself • Lock protection and automatic return circuits incorporated • Lock protection signal output (L during rotation, H at stop, open collector output) • Output (Rotation dete |
|
|
|
|
Sanyo Semicon Device |
Monolithic Linear IC 5ch driver • Spindle driver block 1) 3-phase sensor-less motor driver 2) Soft switching drive 3) Analog input V type control 4) Current limiter incorporated 5) Counter electromotive FG output 6) Reverse prevention circuit incorporated • Threading, focusing, tra |
|
|
|
|
Sanyo Semicon Device |
Monolithic Linear IC V W °C °C Any and all SANYO Semiconductor Co.,Ltd. products described or contained herein are, with regard to "standard application", intended for the use as general electronics equipment (home appliances, AV equipment, communication device, office |
|
|
|
|
Sanyo Semicon Device |
Monolithic Linear IC DVD System motor Drives re, with regard to "standard application", intended for the use as general electronics equipment (home appliances, AV equipment, communication device, office equipment, industrial equipment etc.). The products mentioned herein shall not be intended f |
|
|
|
|
Sanyo Semicon Device |
6-Channel Driver a soft switching function that minimizes spindle motor drive noise by making the current changes at each phase switch more gradual. The sled motor driver implements two-phase stepping drive and supports direct PWM inputs. The LA6505 uses a BTL amplif |
|
|
|
|
Sanyo Semicon Device |
Serial SPI EEPROM • Capacity • Single supply voltage • Serial interface • Operating clock frequency • Low current dissipation • Page write function • Rewrite time • Number of rewrite times • Data retention period • High reliability : 64Kbits (8K×8bits) : 1.8V to 3.6V |
|
Desde 2024. D4U Semiconductor.
|