| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Sanyo Semicon Device |
Chopper Type Parallel 2-Output Voltage Regulators • ICs ha ving 2 outputs for microcomputer po wer suppl y (5V) and motor drive power supply (12, 15, 24, 36V) and being capable of deli vering 2 r egulated outputs fr om 1 rectifier. • Good efficiency due to chopper type and no bea t trouble due to fi |
|
|
|
|
Sanyo |
Power Amplifier |
|
|
|
|
Sanyo |
4-Output Series Regulator |
|
|
|
|
Sanyo |
2 Channel Class AB Audio Power Amplifier • Series of pin compatible power amplifiers ranging from 20 W × 2 channels to 120 W × 2 channels (10%/1 kHz) devices. The same printed circuit board can be used depending on the output power grade. • The pin arrangement is compatible with that of the |
|
|
|
|
Sanyo Semicon Device |
(STK417-000 Series) 2-Channel High Effiency AF Power Amplifier 50W x 2 - 100W X 2 |
|
|
|
|
Sanyo |
Two-Channel Class AB Audio Power Amplifier • Series of pin compatible power amplifiers ranging from 20 W × 2 channels to 120 W × 2 channel (10%/1 kHz) devices. The same printed circuit board can be used depending on the output power grade. • The pin arrangement is compatible with that of the |
|
|
|
|
Sanyo |
2-Channel 100W min AF Power Amp |
|
|
|
|
Sanyo |
2-Channel AF Power Amplifier mbol Vcc max(0) Vcc max(1) Vcc min IST OFF max Theta j-c Tj max Tc max Tstg ts Ratings +-65 +-57 +-10 0.6 Per one power TR 1.9 150 Should satisfy Tj max and Tc max 125 -30 to +125 Vcc=+-40V,RL=6ohm,f=50Hz 0.3 PO=80W,1ch drive Conditions Non- signal S |
|
|
|
|
Sanyo |
Audio Amplifier |
|
|
|
|
Sanyo Semiconductor Corporation |
1-Channel Class AB Audio Power Amplifier • Series of pin compatible power amplifiers ranging from 45W to 180W (10%/1kHz) devices. The same printed circuit board can be used depending on the output power grade. • Miniature packages — 30W to 40W (THD=0.4%, f=20Hz to 20kHz); 44.0mm × 25.6mm × |
|
|
|
|
Sanyo Semicon Device |
2ch AF Power Amplifier |
|
|
|
|
Sanyo |
4-channel class AB audio power • Pin-to-pin compatible outputs ranging from 60W to 80W • Can be used to replace the STK433-000/-100 series (30W to 150W/2ch/class-AB), STK415-100Series (80W to 150W/2ch/class H) due to its pin compatibility of ch1/ch2. 2ch class AB (30W to 60W, THD= |
|
|
|
|
Sanyo |
Dual Power Audio Amplifier |
|
|
|
|
Sanyo |
class AB 3 channels AF power amplifier Output Noise Voltage Quiescent Current Output Neutral Voltage *3 VNO ICCO VN ±42 ±42 ±42 Rg=2.2 kΩ 1.0 mVrms 120 mA -70 0 +70 mV Specifications and information herein are subject to change without notice. Note *1.1ch Drive *2.All tests are m |
|
|
|
|
Sanyo |
AF Power Amplifier • The STK4102II series (STK4122II) and STK4101V series (high-grade type) are pin-compatible in the output range of 6W to 50W and enable easy designing. • Small-sized package whose pin assignment is the same as that of the STK4101II series • Built-in |
|
|
|
|
Sanyo |
Single Power Supply / 2Ch Amplifier |
|
|
|
|
Sanyo |
2 CHANNEL HIGH EFFICIENCY AF POWER AMPLIFIER |
|
|
|
|
Sanyo |
14 Pin / Class AB 2 Channels AF Power Amplifier 110 0.2 +0 -3 dB 20 to 50k 55 Rg=2.2 kohm 1.0 80 -70 0 +70 TYP. MAX. Unit W % Hz kohm mVrms mA mV +-38 20 to 20k 70 +-38 +-38 +-46 +-46 +-46 1k 1.0 1.0 *Specifications and information herein are subject to change without notice. Note *1.1ch Drive |
|
|
|
|
Sanyo Semiconductor Corporation |
af Power Amplifier • Series of pin compatible power amplifiers ranging from 20 W × 3 channels to 60 W × 3 channels (10%/1 kHz) devices. The same printed circuit board can be used depending on the output power grade. • The pin arrangement is compatible with that of the |
|
|
|
|
Sanyo |
AF Power Amplifier (Split Power Supply) (50W + 50W min / THD = 0.08%) • Built-in muting circuit to cut off various kinds of pop noise. • Greatly reduced heat sink due to substrate temperature 125°C guaranteed. • Distortion 0.08% due to current mirror circuit. • Pin-compatible with the STK4101II series. The STK4101V ser |
|
Desde 2024. D4U Semiconductor.
|