No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
ROHM |
Automotive 3ch Half Bridge Driver ■ AEC-Q100 Qualified(Note 1) ■ 1.0A DMOS Half Bridge 3 Circuits ■ Three Mode Output Control (High, Low & High Impedance) ■ Low Standby Current ■ Built-in Protection Diode Against Output Reverse Voltage ■ Over Current Detection(OCD) ■ Under Load Detec |
|
|
|
Rohm |
500mA Variable/Fixed Output LDO Regulators Output voltage precision: ±1% Low-saturation voltage with PMOS output: 0.12V Typ.(Io=200mA) Built-in over-current protection circuit Built-in thermal shutdown circuit Shutdown switch (BDxxKA5WFP and BDxxKA5WF series) Ceramic capacitor com |
|
|
|
Rohm |
500mA Variable/Fixed Output LDO Regulators Output voltage precision: ±1% Low-saturation voltage with PMOS output: 0.12V Typ.(Io=200mA) Built-in over-current protection circuit Built-in thermal shutdown circuit Shutdown switch (BDxxKA5WFP and BDxxKA5WF series) Ceramic capacitor com |
|
|
|
Rohm |
Cell Balance LSI of 4 to 6 Series Power Storage Element Cells circuit Cell Balance LSI of 4 to 6 Series Power Storage Element Cells for Automotive BD14000EFV-C General Description BD14000EFV is a LSI IC designed as a self-controlled cell balancer. It has a built-in shunt-type power storage element balancer fu |
|
|
|
Rohm |
Synchronous Buck Converter integrated FET Low ESR Output Ceramic Capacitors are Available Low Standby Current during Shutdown Mode 380 kHz Fixed Operating Frequency Feedback voltage 0.923V ± 1.5%(Ta=25℃), 0.923V ± 2.0%(Ta=-25℃ to 85℃) Protection Circuits Under Voltage Lockout |
|
|
|
Rohm |
1ch High-side switch ■ Built-in overcurrent protection circuit ■ Built-in Thermal Shut Down(TSD) ■ Built-in Open Load Detection circuit(When Output is OFF) ■ Possibility to control directly from CMOS logic IC ■ Low standby current ■ Built-in Under Voltage Lock Out circui |
|
|
|
ROHM |
USB Switch Dual Power-Supply Architecture, VCC and VBUS. Power Supply Range (VBUS) : 3.8V to 28V. Power Supply Range (VCC) : 3.0V to 5.5V. 5Ωswitches between the input and the output. Low Capacity 2ch Analog SW. Applications Mobile phones, Tablet PC, |
|
|
|
ROHM |
Low Supply Current Input/Output Full Swing Operational Amplifier of low operating supply voltage, low supply current, low input referred noise voltage and high phase margin. These are suitable for audio applications and battery management. Features Low Operating Supply Voltage Input/Output Full Swing Low Sup |
|
|
|
Rohm |
Low ESR Capacitor any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or c |
|
|
|
Rohm |
Low ESR Capacitor any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or c |
|
|
|
Rohm |
Low ESR Capacitor any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or c |
|
|
|
Rohm |
500mA Variable/Fixed Output LDO Regulators Output voltage precision: ±1% Low-saturation voltage with PMOS output: 0.12V Typ.(Io=200mA) Built-in over-current protection circuit Built-in thermal shutdown circuit Shutdown switch (BDxxKA5WFP and BDxxKA5WF series) Ceramic capacitor com |
|
|
|
Rohm |
500mA Variable/Fixed Output LDO Regulators Output voltage precision: ±1% Low-saturation voltage with PMOS output: 0.12V Typ.(Io=200mA) Built-in over-current protection circuit Built-in thermal shutdown circuit Shutdown switch (BDxxKA5WFP and BDxxKA5WF series) Ceramic capacitor com |
|
|
|
ROHM |
Ground Sense Low Power General Purpose Operational Amplifiers Operable with Low Voltage Input Ground Sense, Output Full Swing High Open Loop Voltage Gain Low Supply Current Low Input Offset Voltage Packages SSOP5 W(Typ) x D(Typ) x H(Max) 2.90mm x 2.80mm x 1.25mm Applications Portable Equipment |
|
|
|
Rohm |
Synchronous Buck Converter integrated FET Low ESR Output Ceramic Capacitors are Available Low Standby Current during Shutdown Mode 380 kHz Fixed Operating Frequency Feedback voltage 0.925V ± 1.5%(Ta=25℃), 0.925V ± 2.0%(Ta=-25℃ to 85℃) Protection Circuits Under Voltage Lockout |
|
|
|
ROHM |
LDO Regulators +/-1% output voltage accuracy Built-in Over Current Protection circuit (OCP) Built-in Thermal Shut Down circuit (TSD) Zero μA shutdown mode ●Key Specifications Input Power Supply Voltage range: 4.5V to 8.0V Output voltage: 1.5V/1.8V/2 |
|
|
|
ROHM |
2ch Half-Bridge Gate Driver ■ AEC-Q100 Qualified(Note1) ■ 2ch Half-Bridge Gate Drivers ■ 4 external MOSFETs are Controlled Independently ■ Half-Bridge Control Modes are Selected by SPI ■ Slew Rates are Controlled with Constant Source /Sink Current. ■ 500 kHz Oscillation for Cha |
|
|
|
ROHM |
Low Supply Current Input/Output Full Swing Operational Amplifier of low operating supply voltage, low supply current, low input referred noise voltage and high phase margin. These are suitable for audio applications and battery management. Features Low Operating Supply Voltage Input/Output Full Swing Low Sup |
|
|
|
ROHM |
Low Supply Current Input/Output Full Swing Operational Amplifier of low operating supply voltage, low supply current, low input referred noise voltage and high phase margin. These are suitable for audio applications and battery management. Features Low Operating Supply Voltage Input/Output Full Swing Low Sup |
|
|
|
ROHM |
Low Supply Current Input/Output Full Swing Operational Amplifier of low operating supply voltage, low supply current, low input referred noise voltage and high phase margin. These are suitable for audio applications and battery management. Features Low Operating Supply Voltage Input/Output Full Swing Low Sup |
|