| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Panasonic Semiconductor |
External excitation flyback AC-DC switching power supply controller • Supports operation at switching frequencies up to 700 kHz and achieves a 35 ns output rise time and a 25 ns output fall time. • Extremely low pre-startup current consumption of 70 µA (typical) allows a significantly smaller startup resistor to be u |
|
|
|
|
Panasonic Semiconductor |
3-pin/ positive output/ low dropout voltage regulator • Input/output voltage difference: 0.3V max. • Output current of up to 50mA • Low bias current: 0.6mA typ. • Output voltage: 2V, 2.5V, 3V, 3.5V (SSIP003-P-0000 only), 4V, 4.5V, 5V, 6V, 7V, 8V, 8.5V, 9V, and 10V • Built-in overcurrent protection circu |
|
|
|
|
Panasonic Semiconductor |
3-pin Positive Output Low Dropout Voltage Regulator 2 3 1 • Input/output voltage difference : 0.3V (max.) • Output current of up to 50mA • Low bias current ; 0.6mA (typ.) • Output voltage ; 2V, 2.5V, 3V, 3.5V (TO-92 only) , 4V, 4.5V, 5V, 6V, 7V, 8V, 8.5V, 9V, and 10V. • Over-voltage protective circui |
|
|
|
|
Panasonic Semiconductor |
3-pin Positive Output Low Dropout Voltage Regulator 50mA Type 2 3 1 • Input/output voltage difference : 0.3V (max.) • Output current of up to 50mA • Low bias current ; 0.6mA (typ.) • Output voltage ; 2V, 2.5V, 3V, 3.5V (TO-92 only) , 4V, 4.5V, 5V, 6V, 7V, 8V, 8.5V, 9V, and 10V. • Over-voltage protective circui |
|
|
|
|
Panasonic Semiconductor |
Spindle motor driver • 3-phase full-wave 120° duty factor system • Low power consumption due to a direct PWM system • D-MOS transistor with low ON resistance (0.6 Ω typ.) on the output stage • With start and stop pins • Thermal shut-down function built-in • With FG outpu |
|
|
|
|
Panasonic Semiconductor |
4-channel linear driver • Little phase delay due to current feedback method (2-channel for actuator) • Channels for loading motor (H-bridge system) are available for three modes of forward rotation, reverse rotation and braking • Muting SW with 2 modes: A loading channel is |
|
|
|
|
Panasonic Semiconductor |
3-pin Positive Output Low Dropout Voltage Regulator 50mA Type 2 3 1 • Input/output voltage difference : 0.3V (max.) • Output current of up to 50mA • Low bias current ; 0.6mA (typ.) • Output voltage ; 2V, 2.5V, 3V, 3.5V (TO-92 only) , 4V, 4.5V, 5V, 6V, 7V, 8V, 8.5V, 9V, and 10V. • Over-voltage protective circui |
|
|
|
|
Panasonic Semiconductor |
Step-down/ step-up/ or inverting DC-DC converter controller • Wide operating supply voltage range (3.6 V to 34 V) (The voltage is limited within a range between 3.6 V and 17 V if it is connected to a step-down volt1.27 (0.605) 0.40±0.25 age circuit.) Seating plane • Totem pole output circuit: output peak cur |
|
|
|
|
Panasonic Semiconductor |
Step-down/ step-up/ or inverting DC-DC converter controller • Wide operating supply voltage range (3.6 V to 34 V) (The voltage is limited within a range between 3.6 V and 17 V if it is connected to a step-down volt1.27 (0.605) 0.40±0.25 age circuit.) Seating plane • Totem pole output circuit: output peak cur |
|
|
|
|
Panasonic Semiconductor |
Single-channel 1.8-volt step-up DC-DC converter controller a low minimum operating voltage of 1.8 V, and due to being provided in a 10-pin surface mount package with a 0.5 mm lead pitch, is optimal for use in miniature high-efficiency power supplies for portable equipment. Unit: mm 0.5 5 6 0.1±0.1 0.625 |
|
|
|
|
Panasonic Semiconductor |
1.8-volt 2-channel step-up DC-DC converter controller low-voltage operation. This IC can obtain the step-up voltage with a small number of external components. The minimum operating voltage is as low as 1.8 V so that it can operate with two dry batteries. In addition, since it uses the 16-pin surface mo |
|
|
|
|
Panasonic Semiconductor |
1.8-volt 2-channel step-up/ step-down/ or inverting DC-DC converter controller low-voltage operation. This IC can obtain the step-up, step-down and inverting voltages with a small number of external components. The minimum operating voltage is as low as 1.8 V so that it can operate with two dry batteries. In addition, since it |
|
|
|
|
Panasonic Semiconductor |
Low Drop Type Negative Output 4V Regulator 6 0.5±0.1 1.2±0.25 s Block Diagram RESET 8 7 6 RSENSE 5 Current Source * VREF – * A + * 1 GND 2 VI 3 VO 4 CADJ *↓ = to VIN s Absolute Maximum Ratings (Ta=25˚C) Parameter Supply voltage Supply current Power dissipation Operating ambien |
|
|
|
|
Panasonic Semiconductor |
OVERVOLTAGE PROTECTIVE |
|
|
|
|
Panasonic Semiconductor |
Low-drop type positive output voltage regulator 1.1 –0.1 +0.2 0 to 0.1 0.1 to 0.3 0.4±0.2 Mini-type 5-pin Type name indication symbol : XX s Applications • Cellular phone, PHS, analog cordless phone, other small sized potable equipment s Block diagram IN 1 2 OUT Current source CONT 5 |
|
|
|
|
Panasonic Semiconductor |
Low-drop type positive output voltage regulator 1.1 –0.1 +0.2 0 to 0.1 0.1 to 0.3 0.4±0.2 Mini-type 5-pin Type name indication symbol : XX s Applications • Cellular phone, PHS, analog cordless phone, other small sized potable equipment s Block diagram IN 1 2 OUT Current source CONT 5 |
|
|
|
|
Panasonic Semiconductor |
Low-drop type positive output voltage regulator 1.1 –0.1 +0.2 0 to 0.1 0.1 to 0.3 0.4±0.2 Mini-type 5-pin Type name indication symbol : XX s Applications • Cellular phone, PHS, analog cordless phone, other small sized potable equipment s Block diagram IN 1 2 OUT Current source CONT 5 |
|
|
|
|
Panasonic Semiconductor |
Brushless Motor Driver • Operating supply voltage range : VCC= 4.5 to 7V • 3-phase full-wave drive, external power transistor • Built-in low-voltage protective circuit • Built-in thermal protective comparator circuit • Built-in Hall amplifiers with hysteresis 16 s Applic |
|
|
|
|
Panasonic Semiconductor |
Semiconductor laser power controller • Digital setting of playback current, peak current, bias current and abnormal light emitting level • Peak current and bias current can be modulated by the external signal. • Driving current set-up (digital set-up) For playback: 8-bit + 4-bit (0 mA t |
|
|
|
|
Panasonic Semiconductor |
4-channel driver 11.6±0.3 1 AN8730SB s Block Diagram ICs for Compact Disc/CD-ROM Player SGND PGND 8 Power cut 21 25 BTL 24 Absolute value 23 BTL 22 Absolute value 19 BTL 20 Absolute value 17 BTL 18 Absolute value 12 STNBY Thermal shut-down VREF detection 3 |
|
Desde 2024. D4U Semiconductor.
|