No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
ON Semiconductor |
Power Operational Amplifier • High output current (IO max = 1.0A) • High gain • With current limiter • Capable of being operated from single supply Specifications Maximum Ratings at Ta = 25°C Parameter Maximum supply voltage Differential input voltage Common-mode input voltag |
|
|
|
Sanyo Semiconductor Corporation |
LA6458DS |
|
|
|
Sanyo Semiconductor Corporation |
High-Performance Dual Operational Amplifiers |
|
|
|
Sanyo Semiconductor Corporation |
High-Performance Dual Operational Amplifiers LA6458M : 8-pin MFP package, LA6458S : 9-pin SIP package . Phase compensation circuit built in. . High gain, low noise. . Slew rate : l.1V/µs typ. Package Dimensions unit : mm 3032B-MFP8 [LA6458M] Specifications Maximum Ratings at Ta = 25°C Param |
|
|
|
ON Semiconductor |
BTL Driver Single-Phase Full-Wave Fan Motor Driver all package (Micro10) Specitications Absolute Maximum Ratings at Ta = 25 °C Parameter Symbol Conditions Ratings Unit Output voltage Allowable power dissipation VCC max Pd max Mounted on a specified board* 15 V 400 mW Output current Output |
|
|
|
Sanyo Semiconductor |
High Performance Quad Operational Amp |
|
|
|
Sanyo Semiconductor |
4Ch Bridge BTL Driver (Japanese) (80mV : typ) www.DataSheet4U.com VORH (3.25V) VORL (100mV) Td Td A12789 |
|
|
|
ON Semiconductor |
Single-phase Full-wave Fan Motor IC tself • Diffusion of generated heat : Connection of external resistor between VM and VCC enables reduction of heat generation of IC itself. (Upper side + lower side saturation voltage: Vosat (total) = 0.85Vtyp, IO = 300mA, RM = 1Ω) • Lock protection |
|
|
|
ON Semiconductor |
5CH Driver • Power amplifier 5-channel built-in. • IO max 1A • Level shift circuit built-in. • Mute circuit (output ON/OFF) with three built-in channels (2-2-1). (Operates independently for each of MUTE1: CH1 and 2, MUTE2: CH3 and 4, and MUTE3: CH5. Not operati |
|
|
|
Sanyo Semiconductor |
5ch Driver For CD And CD Changers |
|
|
|
IK Semiconductor |
Triple Video Output Amplifier • • • • • • • • • Typical bandwidth of 5.5 MHz for an output signal of 60 V (p-p) High slew rate of 900 V/µs No external components required Very simple application Single supply voltage of 200 V Internal reference voltage of 2.5 V Fixed gain of 50 B |
|
|
|
IK Semiconductor |
PWM Power Controller w ·Pulse width modulation up to 2 kHz clock frequency w ·Protection against short circuit, load dump S U 4 t m o .c TECHNICAL DATA ILA6083 ·Duty cycle 15 to 100% continuously ·Reduced internal pulse slope of lamp’s voltage ·High side switch ·Int |
|
|
|
Sanyo Semiconductor |
4Ch Bridge BTL Driver URCE current RESET output SINK current Symbol VCC IORH IORL Conditions Ratings 4 to 13 0 to 200 0 to 2 Unit V µA mA 52504 JO IM No.7886-1/3 LA6548 Electrical Characteristics at Ta = 25°C, VCC = 6V, VREF = 1.65V Parameter [Whole] No-load current con |
|
|
|
Sanyo Semiconductor |
4CH Bridge (BTL) Driver for CD |
|
|
|
ON Semiconductor |
High-Performance Quad Operational Amplifier • No phase compensation required • Wide operating voltage range: 3.0 V to 30.0 V (single supply) ±1.5 V to ±15.0 V (dual supplies) • Highly resistant to dielectric breakdown • Input voltag range includes the neighborhood of GND level and output volta |
|
|
|
ON Semiconductor |
BTL Driver Single-Phase Full-Wave quite, low power, high efficiency drive that suppresses reactive current. It is optimal for use in applications that require miniaturization and low noise, such as CPU cooling fan motors and 5 to 12V electronic game products. Functions • Single-phas |
|
|
|
ON Semiconductor |
BTL Driver Single-Phase Full-Wave th low current drain. Additionally, IC itself generates only small heat. • Built-in lock protection and automatic reset circuits • Built-in FG & RD outputs • Built-in Hall bias (VHB = 1.5V) • Thermal protection circuit : When the large current flows |
|
|
|
ON Semiconductor |
Single-phase Fan Motor IC efficiency and small current drain. Small heat generation from IC itself • Lock protection and automatic return circuits incorporated • Lock protection signal output (L during rotation, H at stop, open collector output) • Output (Rotation detection |
|
|
|
ON Semiconductor |
Single-phase Full-wave Fan Motor IC cuit : The heat protection circuit suppresses the drive current to prevent burn or damage of IC when the large current flows due to output short-circuit and the IC chip temperature exceeds 180°C. • Small package with high heat capacity Specification |
|
|
|
ON Semiconductor |
BTL Drive Single-Phase Full-Wave Fan Motor Driver • BTL output single-phase full-wave linear drive (gain resistor : 1 to 360kΩ, 51dB) • Supports low-voltage drive and features a wide usable voltage range (2.2 to 14.0V) • Low saturation output (high side + low side saturation voltage : Vosat (total) |
|