| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
ON Semiconductor |
Wired M-BUS Slave Transceiver and adds two low power modes: a 2−wire low power mode dedicated to System for meter Communication and Readout for powerless meters (SCR) and a 3−wire low power mode allowing support for wireless applications. When configured in low power mode, the tr |
|
|
|
|
ON Semiconductor |
Dual SIM/SAM/Smart Card Power Supply and Level Shifter • Supports 1.8 V or 3.0 V Operating SIM/SAM/Smart Cards • The LDOs are able to Supply more than 50 mA Under 1.8 V and 3.0 V • Built−in Active and Passive Pullup Resistor for I/O and CRD_IOA/B Pins in Both Directions • All Pins are Fully ESD Protected |
|
|
|
|
ON Semiconductor |
6-Channel Differential 1:2 Switch http://onsemi.com MARKING DIAGRAM NCN3612B AWLYYWWG WQFN56 CASE 510AK A WL YY WW G 1 • • • • • • • • • • BTX Pinout VDD Power Supply from 3 V to 3.6 V Low Supply Current: 250 mA typ 6 Differential Channels, 2:1 MUX/DEMUX Compatible with Display Por |
|
|
|
|
ON Semiconductor |
Power Line Carrier Modem http://onsemi.com 1 52 QFN52 8x8, 0.5P CASE 485M • • • • • • • • • • • • • • • • • Power Line Carrier Modem for 50 and 60 Hz Mains Fully compliant to IEC 61334−5−1 and CENELEC EN 50065−1 Complete Handling of Protocol Layers Physical to MAC Progr |
|
|
|
|
ON Semiconductor |
10 Mb/s Industrial Ethernet MAC + PHY IC Controller • 10BASE−T1S – IEEE 802.3cg Compliant • 3.3 V Supply Voltage • Two Configurable Digital Outputs that can Drive Low Current LEDs • Low Profile 4 mm x 4 mm QFN 32 • Integrated MAC and 10BASE−T1S PHY • Open Alliance Compatible SPI Interface for Exchangi |
|
|
|
|
ON Semiconductor |
Power Line Carrier Modem such as a smart synchronization and in−band statistics. Fully reprogrammable, the modem firmware can be updated in the field. Multiple royalty−free firmware options are available from MARKING DIAGRAMS 56 ON Semiconductor; refer to the separate dat |
|
|
|
|
ON Semiconductor |
Compact Low Power Smart-Card Interface usually required for STB smart card interface. QFN24 MN SUFFIX CASE 485L MARKING DIAGRAMS NCN 8026A ALYWG G A = Assembly Location L = Wafer Lot Y = Year W = Work Week G = Pb−Free Package (Note: Microdot may be in either location) ORDERING INFORMA |
|
|
|
|
ON Semiconductor |
SIM Card Power Supply and Level Shifter • Supports 1.8 V or 3.0 V Operating SIM Card • The LDO is able to Supply More than 50 mA under 1.8 V and 3.0 V • Built−in Pullup Resistor for I/O Pin in Both Directions • All Pins are Fully ESD Protected According to ISO−7816 Specifications – ESD Pro |
|
|
|
|
ON Semiconductor |
4-Differential Channel 1:2 Mux/Demux Switch http://onsemi.com MARKING DIAGRAM NCN3411 AWLYYWWG 1 • • • • • • • • • • • • VDD Power Supply from 1.5 V to 2.0 V 4 Differential Channels 2:1 MUX/DEMUX Compatible with PCIe 3.0 Data Rate: Supports 8 Gbps Low Crosstalk −30 dB @ 4 GHz Low Bit−to−Bit |
|
|
|
|
muRata |
Common Mode Noise Filter (9) Number of Line (10) Packaging Code D : Taping / B : Bulk Customer Part Number MURATA Part Number Common Mode Impedance (Ωtyp.) at 100MHz Common Mode Insertion Loss Characteristic (dB Typ.) @700MHz @900MHz @1.7GHz @2.4GHz NFP0NCN901HL3D 65 |
|
|
|
|
muRata |
Common Mode Noise Filter Applications Other Usage For general 1. Small size and tight dimensional tolerance Size: 0.85×0.65×0.30mm Tolerance: +-0.05mm 2. Common mode noise suppression effect (The effect become maximum at 1.0GHz to 2.0GHz ) 3. Compatible with high speed, la |
|
|
|
|
ON Semiconductor |
HART Modem • Single−chip, Half−duplex 1200 Bits per Second FSK Modem • Bell 202 Shift Frequencies of 1200 Hz and 2200 Hz • 1.8 V − 3.5 V Power Supply • Transmit−signal Wave Shaping • Receive Band−pass Filter • Low Power: Opt |
|
|
|
|
ON Semiconductor |
Compact SMART-CARD Interface usually QFN24 MN SUFFIX CASE 485L NCN 8025A ALYWG G required for STB smart card interface. It is also offered in a very compact package profile, QFN−16 (NCN8025), satisfying the requirements of cost−efficiency and space−saving reque |
|
|
|
|
ON Semiconductor |
Compact SMART-CARD Interface usually QFN24 MN SUFFIX CASE 485L NCN 8025A ALYWG G required for STB smart card interface. It is also offered in a very compact package profile, QFN−16 (NCN8025), satisfying the requirements of cost−efficiency and space−saving reque |
|
|
|
|
ON Semiconductor |
Compact Smart-Card Interface |
|
|
|
|
ON Semiconductor |
USB Single Channel Transceiver http://onsemi.com MARKING DIAGRAM 16 1 • Compliant to the USB Specification, Version 2.0, Low and Full • • • • Speed Very Small Footprint Due to the QFN−16 Package Integrated D+/D− Pullup Resistors Operates Over the Full 1.5 V to 3.6 V Supply Pb−Fr |
|
|
|
|
ON Semiconductor |
Dual Smart-Card Interface Dual Smart Card / SAM Interface with SPI Programming Bus Fully Compatible with ISO 7816−3, EMV and GIE−CB Standards One Protected Bidirectional Buffered I/O Line per Card Port Wide Power Supply Voltage Range: 2.7V < VDDPA/B & VDD < 5.5 V Pr |
|
|
|
|
ON Semiconductor |
DP3T USB 2.0 High Speed / Audio Switch shunt resistors on the audio ports. These resistors are switched in when the audio channel is off and provide a safe path to ground for any charge that may build up on the audio lines. This reduces Pop & Click noise in the audio system. The NCN1154 i |
|
|
|
|
ON Semiconductor |
Compact and Low Cost Smart Card Interface IC http://onsemi.com MARKING DIAGRAMS 28 NCN6024 AWLYYWWG SOIC−28* CASE 751F 1 • Single IC Card Interface • Fully Compatible with ISO 7816−3, EMV and Related Standards • • • • • • • • • • • • Including STB Standards Three Protected Bidirectional Buffe |
|
|
|
|
ON Semiconductor |
Smart-Card Interface Single IC Card Interface Fully Compatible with ISO 7816−3, EMV and Related Standards Including NDS Three Bidirectional Buffered I/O Level Shifters (C4, C7 and C8 Card Pins) 3.0 V or 5.0 V 5% Regulated Card Power Supply such as ICC 75 mA a |
|
Desde 2024. D4U Semiconductor.
|