| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
ON Semiconductor |
MC7805BT • Output Current in Excess of 1.0 A • No External Components Required • Internal Thermal Overload Protection • Internal Short Circuit Current Limiting • Output Transistor Safe−Area Compensation • Output Voltage Offered in 1.5%, 2% and 4% Tolerance • |
|
|
|
|
ON Semiconductor |
1.0A Negative Voltage Regulators le. The G−Suffix Denotes a Pb−Free Lead Finish Heatsink surface connected to Pin 2. 1 2 3 Pin 1. Ground 2. Input 3. Output D2PAK D2T SUFFIX CASE 936 12 3 Heatsink surface (shown as terminal 4 in case outline drawing) is connected to Pin 2. STA |
|
|
|
|
ON Semiconductor |
Hex Schmitt-Trigger Inverter • Output Drive Capability: 10 LSTTL Loads • Outputs Directly Interface to CMOS, NMOS and TTL • Operating Voltage Range: 2.0 to 6.0 V • Low Input Current: 1.0 mA • High Noise Immunity Characteristic of CMOS Devices • In Compliance With the JEDEC Stand |
|
|
|
|
ON Semiconductor |
Low-Voltage CMOS Octal Transceiver/Registered Transceiver ntrols (SBA, SAB) can multiplex stored and real−time (transparent mode) data. In the isolation mode (both outputs disabled), A data may be stored in the B register or B data may be stored in the A register. When in the real−time mode, it is possible |
|
|
|
|
ON Semiconductor |
Negative Voltage Regulators thermal shutdown and current limiting, making them remarkably rugged. In most applications, no external components are required for operation. The MC79L00A devices are useful for on−card regulation or any other application where a regulated negative |
|
|
|
|
ON Semiconductor |
Negative Voltage Regulators thermal shutdown and current limiting, making them remarkably rugged. In most applications, no external components are required for operation. The MC79L00A devices are useful for on−card regulation or any other application where a regulated negative |
|
|
|
|
ETC |
Adjustable Constant Current LED Driver y Sink current: 10mA to 400mA adjustable with an external resistor y Current and voltage range extendable by adding an external NMOS or NPN transistor y Power supply voltage: 2.7-6V y Low drop out voltage: 100mV@350mA y Low quiescent current: 250uA y |
|
|
|
|
Taiwan Semiconductor |
Surface Mount Transient Voltage Suppressor ● Ideal for automated placement ● Glass passivated chip junction ● Excellent clamping capability ● Fast response time: Typically less than 1.0ps ● Typical IR less than 1μA above 10V ● Meets ISO 7637-2 (Pulse 1/2a/2b/3a/3b) ● Moisture sensitivity leve |
|
|
|
|
ON Semiconductor |
1.0A Negative Voltage Regulators le. The G−Suffix Denotes a Pb−Free Lead Finish Heatsink surface connected to Pin 2. 1 2 3 Pin 1. Ground 2. Input 3. Output D2PAK D2T SUFFIX CASE 936 12 3 Heatsink surface (shown as terminal 4 in case outline drawing) is connected to Pin 2. STA |
|
|
|
|
Micrel Semiconductor |
Low-Power Operational Amplifier rail-to-rail input and output performance in Micrel’s IttyBitty™ SOT-23-5 package. The LMC7101 is a 500kHz gain bandwidth amplifier designed to operate from 2.7V to 12V single-ended power supplies with guaranteed performance at supply voltages of 2.7 |
|
|
|
|
ON Semiconductor |
8-Bit Serial or Parallel-Input/Serial-Output Shift Register • Output Drive Capability: 10 LSTTL Loads • Outputs Directly Interface to CMOS, NMOS, and TTL • Operating Voltage Range: 2.0 to 6.0 V • Low Input Current: 1 mA • High Noise Immunity Characteristic of CMOS Devices • In Compliance with the Requirements |
|
|
|
|
ON Semiconductor |
Analog Multiplexers/Demultiplexers • Injection Current Cross−Coupling Less than 1 mV/mA (See Figure 10) • Pin Compatible to HC405X and MC1405XB Devices • Power Supply Range (VCC − GND) = 2.0 to 6.0 V • In Compliance With the Requirements of JEDEC Standard No. 7 A • Chip Complexity: 15 |
|
|
|
|
ON Semiconductor |
MC7812A Packages are Available MAXIMUM RATINGS (TA = 25°C, unless otherwise noted) Value Rating Input Voltage Power Dissipation Thermal Resistance, Junction−to−Ambient Thermal Resistance, Junction−to−Case Storage Junction Temperature Range Operating Junctio |
|
|
|
|
ON Semiconductor |
Low-Voltage CMOS Octal Transceiver/Registered Transceiver multiplex stored and real−time (transparent mode) data. The direction control (DIR) determines which bus will receive data when the enable OE is active LOW. In the isolation mode (OE HIGH), A data may be stored in the B register or B data may be sto |
|
|
|
|
ON Semiconductor |
1.0A Negative Voltage Regulators le. The G−Suffix Denotes a Pb−Free Lead Finish Heatsink surface connected to Pin 2. 1 2 3 Pin 1. Ground 2. Input 3. Output D2PAK D2T SUFFIX CASE 936 12 3 Heatsink surface (shown as terminal 4 in case outline drawing) is connected to Pin 2. STA |
|
|
|
|
ON |
3.0A Positive Voltage Regulators −Free Packages are Available Input Cin* 0.33 mF MC78TXX Output CO** Figure 1. Simplified Application A common ground is required between the input and the output voltages. The input voltage must remain typically 2.2 V above the output voltage eve |
|
|
|
|
ON Semiconductor |
Quad 2-Input NAND Schmitt Trigger • Schmitt Trigger Inputs • Outputs Source/Sink 24 mA • ′ACT132 Has TTL Compatible Inputs • These are Pb−Free Devices VCC 14 13 12 11 10 9 8 DATA SHEET www.onsemi.com MARKING DIAGRAM 14 14 1 SOIC−14 D SUFFIX CASE 751A XXXXXXG AWLYWW 1 XXX A WL Y |
|
|
|
|
ON Semiconductor |
Quad Analog Switch/Multiplexer/Demultiplexer • Fast Switching and Propagation Speeds • High ON/OFF Output Voltage Ratio • Low Crosstalk Between Switches • Diode Protection on All Inputs/Outputs • Wide Power−Supply Voltage Range (VCC − GND) = 2.0 to 6.0 Volts • Analog Input Voltage Range (VCC − |
|
|
|
|
ON Semiconductor |
Quad Analog Switch/Multiplexer/Demultiplexer • Fast Switching and Propagation Speeds • High ON/OFF Output Voltage Ratio • Low Crosstalk Between Switches • Diode Protection on All Inputs/Outputs • Wide Power−Supply Voltage Range (VCC − GND) = 2.0 to 6.0 V • Analog Input Voltage Range (VCC − GND) |
|
|
|
|
ON Semiconductor |
500mA Negative Voltage Regulators • No External Components Required • Internal Thermal Overload Protection • Internal Short Circuit Current Limiting • Output Transistor Safe−Area Compensation • Also Available in Surface Mount DPAK (DT) Package • Pb−Free Packages are Available DEVICE |
|
Desde 2024. D4U Semiconductor.
|