No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
National Semiconductor |
Complete Baseband Processor for DECT Base Stations s Integrated DECT base band transceiver optimized for GAP base stations according to ETS 300 175-2, 175-3 & 175-8. s 3.0 to 5.5 Volt operating voltage. s Embedded 16 bit CompactRISCTM CR16A Microprocessor with In System Emulation (ISE) mode. _______ |
|
|
|
National Semiconductor |
Baseband Processor for FP & PP DECT and WDCT ■ Complies with DECT ETS 300 175-2,3 & 8 SWAP-CA V1.3 Rev 1.3 20000616 ■ 1.8Volt operating voltage with 2.65V (typ) IO pads. ■ Two chip low drop voltage regulators ■ 16 bit CompactRISCTM CR16C Microprocessor with programmable clock speeds up to 20.73 |
|
|
|
National Semiconductor |
MOLDED PACKAGE SSOP/ EIAJ |
|
|
|
National Semiconductor |
Information Appliance On a Chip combined with the device’s small form factor and low power consumption, make it ideal as the core for an advanced set-top box, consumer access device, residential gateway, thin client, or embedded system. Block Diagram Geode™ GX1 Memory Controller |
|
|
|
National Semiconductor |
SCAN Bridge Hierarchical and Multidrop Addressable JTAG Port not described in this datasheet such as 8 slot inputs for enhanced address capability and additional instructions. For a completed description of the additional instructions supported, refer to the SCANPSC110 supplemental datasheet. Features n True |
|
|
|
National Semiconductor |
Complete Baseband Processor for DECT Handsets s Integrated DECT Baseband transceiver optimized for GAP handsets according to ETS 300 175-2, 175-3 & 175-8. ________________________________________________________________________________________________ System Diagram SC14401 SC14402 SC14422 |
|
|
|
National Semiconductor |
Complete Baseband Processor for DECT Handsets n Integrated DECT Baseband transceiver optimized for GAP handsets according to ETS 300 175-2, 175-3 & 175-8. n Two on board low drop voltage regulators with 2.85V and 3.0- 3.8V (with external resistors the voltage can be determined) output. n 2V upto |
|
|
|
National Semiconductor |
Complete Baseband Processor for DECT Handsets I Integrated DECT Baseband transceiver optimized for GAP handsets according to ETS 300 175-2, 175-3 & 175-8. I Two on board low drop voltage regulators with 2.5V and 3.0- 3.8V (with external resistors the voltage can be determined) output. I 2V upto |
|
|
|
National Semiconductor |
Complete Baseband processor for DECT Base Stations with Caller-id and Handsfree n Integrated DECT base band transceiver optimized for GAP base stations according to ETS 300 175-2,3 & 8. n 2.7 to 3.3 Volt operating voltage. n Embedded 16 bit CompactRISCT M CR16B Microprocessor with In System Emulation (ISE) mode. n On-chip 6kByte |
|