Motorola MMA Hoja de datos

No.	parte #	Fabricante	Descripción
1	TL431	Motorola	three-terminal programmable shunt regulator diode yp @ 25°C (TL431B) Low Dynamic Output Impedance, 0.22 Ω Typical Sink Current Capability of 1.0 mA to 100 mA Equivalent Full –Range Temperature Coefficient of 50 ppm/°C Typical Temperature Compensated for Operation over Full Rated Operating Temperature
2	MMA1220D	Motorola	Sensor signal conditioning, a 4-pole low pass filter and temperature compensation. Zero-g offset full scale span and filter cut-off are factory set and require no external devices. A full system self-test capability verifies system functionality. Features •
3	MMAD1103	Motorola	Monolithic Diode Arrays
4	MC1776C	Motorola	PROGRAMMABLE OPERATIONAL AMPLIFIER low power consumption and high input impedance. In addition, the quiescent currents within the device may be programmed by the choice of an external resistor value or current source applied to the Iset input. This allows the amplifier’s characteristi
5	MC14536B	Motorola	PROGRAMMABLE TIMER Loads or One Low –power Schottky TTL Load Over the Rated Temperature Range MAXIMUM RATINGS* (Voltages Referenced to VSS) Symbol VDD Parameter DC Supply Voltage L SUFFIX CERAMIC CASE 620 P SUFFIX PLASTIC CASE 648 DW SUFFIX SOIC CASE 751G ORDERING I
6	MC6840	Motorola	Programmable Timer Module tion as well as system interrupts. ,>~+ ‘$tt5, -*, .,d:P:.. 3... ~
7	MPC604E	Motorola	PowerPC 604e-TM RISC Microprocessor Technical Summary including a block diagram showing the major functional components. It provides information about how the 604e implementation complies with the PowerPC™ architecture deﬁnition. This document is divided into two parts: • Part 1,“PowerPC 604e Microproc
8	MC10E195	Motorola	PROGRAMMABLE DELAY CHIP gates that have been modified to have delays 1.25 and 1.5 times the basic gate delay of approximately 80 ps. These two elements provide the E195 with a digitally-selectable resolution of approximately 20 ps. The required device delay is selected by t
9	MMA1201P	Motorola	Sensor signal conditioning, a 4 –pole low pass filter and temperature compensation. Zero –g offset full scale span and filter cut –off are factory set and require no external devices. A full system self –test capability verifies system functionality. Features •
10	MMA2200W	Motorola	Sensor signal conditioning, a 4 –pole low pass filter and temperature compensation. Zero –g offset full scale span and filter cut –off are factory set and require no external devices. A full system self –test capability verifies system functionality. Features •
11	MMA2201D	Motorola	Micromachined Accelerometer signal conditioning, a 4 –pole low pass filter and temperature compensation. Zero –g offset full scale span and filter cut –off are factory set and require no external devices. A full system self –test capability verifies system functionality. Features •
12	MMA5106KWR2	Motorola	PSI5 Inertial Sensor ±60g to ±480g Full-Scale Range Selectable 400 Hz, 3 Pole, or 4 pole Low Pass Filter Single Pole High Pass Filter with Fast Start-Up & Output Rate Limiting PSI5 Version 1.3 Compatible – PSI5-P10P-500/3L Compatible – Programmable Time Slots with 0.5 μs
13	ACE3600	Motorola	programmable Remote Terminal Unit Manual e purchase of Motorola products shall not be deemed to grant either directly or by implication, estoppel, or otherwise, any license under the copyrights, patents or patent applications of Motorola, except for the normal non-exclusive, royalty free li
14	MMAD1109	Motorola	Monolithic Diode Arrays
15	MC145165	Motorola	Low-Voltage 60 MHz Universal Programmable Dual PLL Frequency Synthesizer fully programmable receive, transmit, reference, and auxiliary reference counters accessed through an MCU serial interface. This feature allows this device to operate in any CT –1 cordless phone application. The device consists of two independent phas
16	MC14573	Motorola	(MC14574 / MC14575) CMOS MSI(PROGRAMMABLE DUAL OP AMP / DUAL COMPARATOR
17	MC34216	Motorola	PROGRAMMABLE TELEPHONE LINE INTERFACE CIRCUIT WITH LOUDSPEAKER AMPLIFIER Line Driver and Supply • DC and AC Termination of the Line 28 1 • • • • • • • • • • • • • • • • • • • • • • Selectable Masks: France, U.K., Low Voltage Current Protection Adjustable Set Impedance for Resistive and Complex Termination Efficient Supp
18	MCM2801	Motorola	ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY
19	MC1776	Motorola	PROGRAMMABLE OPERATIONAL AMPLIFIER
20	MMA2202D	Motorola	Micromachined Accelerometer signal conditioning, a 4 –pole low pass filter and temperature compensation. Zero –g offset full scale span and filter cut –off are factory set and require no external devices. A full system self –test capability verifies system functionality. Features •