No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
Mitsubishi Electric Semiconductor |
1.55 um DFB-LD MODULE Input impedance is 25W Multi qu antum wells (MQW) DFB Laser Diode module Emission wavelength is in 1.55mm band Polarization maintaining optical fiber pig-tail Built-in optical isolator Built-in thermal electric cooler Butterfly package With photodiod |
|
|
|
Mitsubishi |
MOTOR DRIVER FOR CAMERA |
|
|
|
Mitsubishi |
Smart battery protection and monitoring IC l l l l l Built-in high gain op-amps for monitoring charge/discharge current Built-in over current detection circuit for FET protection 20P-TSSOP All FETs are controlled by microcomputer Various powers saving function to reduce total power dissipat |
|
|
|
Mitsubishi |
TONE CONTROL/VOLUME CONTROL Built-in "QSurround" sound technology Electronic volume. 0 ~ -84dB, infinitesimal 2-band tone control Bass(0 ~ +21dB/3dB STEP) Treble(0 ~ +9dB/3dB STEP) 5 input selector(The fifth input can be used as REC OUT or MIC MIX.) RECOMMENDED OPERATING CONDI |
|
|
|
Mitsubishi |
TONE CONTROL/VOLUME CONTROL Built-in "BBE surround" sound technology Electronic volume. 0 ~ -84dB,the infinitesimal 2-band tone control Bass(0 ~ +21dB/3dB STEP) Treble(0 ~ +9dB/3dB STEP) RECOMMENDED OPERATING CONDITIONS Supply voltage range + 2.25~+ 2.75V SYSTEM BLOCK DIAGRAM |
|
|
|
Mitsubishi |
DIGITAL SOUND CONTROLLER WITH SURROUND Built-in 4ch input selector. Built-in input volume (2dB step/3 bit) IC for Dolby-pro-logic Interface. Built-in Surround (ON/OFF,High/Middle/Low <3 variation>) Tone control (Bass/Mid/Treble) Built-in Loudness. Vocal cut (Surround OFF setting only) Mai |
|
|
|
Mitsubishi |
Peak hold IC for 5 band spectrum analyzer displays 5 band peak hold elements for spectrum analyzer displays. Discharge time constant circuit for each band is on the chip. Single 5V power supply. RECOMMENDED OPERATING CONDITIONS Supply voltage range Rated supply voltage 4.5 to 6.5V 5.0 V SYSTEM BLOC |
|
|
|
Mitsubishi Electric Semiconductor |
I2C BUS CONTROLLED VIDEO PRE-AMP Frequency Band Width RGB: 180MHz (3Vp-p at -3dB) OSD: 80MHz Input RGB: 0.7Vp-p(typical) OSD: 3.5V~5V(positive) OSD BLK: 3.5V~5V(positive) Retrace BLK: 2.5V~5V(positive) Clamp Pulse: 2.5V~5V(positive) Output RGB: OSD: Sync OUT: 5Vp-p (at Brightness le |
|
|
|
Mitsubishi Electric Semiconductor |
EAM/DFB-LD MODULE Input impedance is 50 W Integrated Electroabsorption Modulator(EAM) Distributed feedback (DFB) Laser Diode Emission wavelength is the 1.55mm band Single-mode optical fiber pig-tail Built-in optical isolator Built-in thermal electric cooler Butterfly |
|
|
|
Mitsubishi Electric Semiconductor |
1.55 um EAM/DFB-LD MODULE WITH SINGLEMODE FIBER PIGTAIL(WDM) Input impedance is 50 W Integrated Electroabsorption Modulator(EAM) Distributed feedback (DFB) Laser Diode Emission wavelength is the 1.55mm band Single-mode optical fiber pig-tail Built-in optical isolator Built-in thermal electric cooler Butterfly |
|
|
|
Mitsubishi |
BUILTIN 2-CHANNEL SPD SENSOR DETECT AMOUNT OF LIGHT |
|
|
|
Mitsubishi |
Smart battery protection and monitoring IC l l l l l Built-in high gain op-amps for monitoring charge/discharge current Built-in over current detection circuit for FET protection 20P-TSSOP All FETs are controlled by microcomputer Various powers saving function to reduce total power dissipat |
|
|
|
Mitsubishi |
TONE CONTROL/VOLUME CONTROL Built-in "QXpander" sound technology Electronic volume. 0 ~ -84dB, infinitesimal 2-band tone control Bass(0 ~ +21dB/3dB STEP) Treble(0 ~ +9dB/3dB STEP) 5 input selector(The fifth input can be used as REC OUT or MIC MIX.) RECOMMENDED OPERATING CONDIT |
|
|
|
Mitsubishi |
AUDIO SIGNAL PROCESSOR WITH SURROUND • 2ch Master Volume (L,R Independent Control) Main Volume : 0dB to –76dB (2dB or 4dB step), -∞ Trim Volume : 0dB to –15dB (1dB step) • Tone Control (Bass/Mid/Treble) ±8dB(2dB step) • 4 Input Selector with Mute • Surround Function • Vocal Cut Function |
|
|
|
Mitsubishi |
NTSC TV SIGNAL PROCESSOR Various signal output for Intelligent Monitoring function Alignment-free sound demodulator Built-in H OSC resonator Built-in sync sep.(auto-slicer type) Built-in black peak hold capacitor ACL / ABCL Vertical count-down circuit Built-in vertical saw t |
|
|
|
Mitsubishi Electric Semiconductor |
SOUND PROCESSOR ICs 7.1ch ELECTRONIC VOLUME FUNCTION FEATURE Electronic Volume (1)8 channel Independent Electronic Volume with High Voltage Transistor. (0~-92dB/1dBstep,-95,- dB) www.DataSheet4U.com (2)Built-in Zero-Crossing Detector Circuit for reduce click noise at changing volume value. Ton |
|
|
|
Mitsubishi Electric Semiconductor |
1.55 um DFB-LD MODULE Multi qu antum wells (MQW) DFB Laser Diode module Input impedance is 25W Emission wavelength is in 1.55mm band Polarization maintaining optical fiber pig-tail Built-in optical isolator Built-in thermal electric cooler Butterfly package With photodiod |
|
|
|
Mitsubishi Electric Semiconductor |
DFB-LD MODULE Multi qu antum wells (MQW) DFB Laser Diode module Input impedance is 25W Emission wavelength is in 1.55mm band High-speed response Built-in optical isolator Built-in thermal electric cooler Butterfly package With photodiode for optical output monitor |
|
|
|
Mitsubishi Electric Semiconductor |
DFB-LD MODULE Multi qu antum wells (MQW) DFB Laser Diode module Input impedance is 25W Emission wavelength is in 1.55mm band High-speed response Built-in optical isolator Built-in thermal electric cooler Butterfly package With photodiode for optical output monitor |
|
|
|
Mitsubishi |
MOTOR DRIVER FOR CAMERA |
|