No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
Maxim Integrated Products |
1-Wire SHA-1 Authenticator 1Kb EEPROM ♦ 1024 Bits of EEPROM Memory Partitioned Into Four Pages of 256 Bits ♦ On-Chip 512-Bit SHA-1 Engine to Compute 160Bit Message Authentication Codes (MACs) and to Generate Secrets ♦ Write Access Requires Knowledge of the Secret and the Capability of Co |
|
|
|
Maxim Integrated Products |
Stand-Alone Fuel Gauge Precision Voltage, Temperature, and Current Measurement System TYPICAL OPERATING CIRCUIT Accurate Stable Internal Time Base Absolute and Relative Capacity Estimated from Coulomb Count, Discharge Rate, Temperature and Battery Cell Characteri |
|
|
|
Maxim Integrated Products |
EEPROM 4kbit (512 x 8) EEPROM Organized in Two 256Byte Blocks Single Byte and up to 16-Byte EEPROM Write Sequences Write-Protect Control Pin for the Entire EEPROM Array Endurance 200k Cycles per Block at 25°C; 10ms max EEPROM Write Cyc |
|
|
|
Maxim Integrated Products |
1-Wire SHA-1 Authenticator |
|
|
|
Maxim Integrated Products |
1Kbit I2C/SMBus EEPROM are supported for each memory page. Each DS28CN01 has a guaranteed unique factory-programmed 64-bit registration number. Communication with the DS28CN01 is accomplished through an industrystandard I2C-compatible and SMBus™-compatible interface. The S |
|
|
|
Maxim Integrated Products |
2-Cell Stand-Alone Li+ Fuel-Gauge Precision measurements of voltage, temperature, and current, along with a cell characteristics table and application parameters, are used for capacity estimation calculations. The capacity registers report a conservative estimate of the amount of ch |
|
|
|
Maxim Integrated Products |
2-Cell Stand-Alone Li+ Fuel-Gauge Precision measurements of voltage, temperature, and current, along with a cell characteristics table and application parameters, are used for capacity estimation calculations. The capacity registers report a conservative estimate of the amount of ch |
|
|
|
Maxim Integrated Products |
3.3V Single-Piece 256k Nonvolatile SRAM ♦ Single-Piece, Reflowable, PBGA Package Footprint ♦ Internal ML Battery and Charger ♦ Unconditionally Write-Protects SRAM when VCC is Out-of-Tolerance ♦ Automatically Switches to Battery Supply when VCC Power Failures Occur ♦ Internal Power-Supply M |
|
|
|
Maxim Integrated Products |
Low-Cost I2C Battery Monitor 16-Bit Bidirectional Current Measurement 1.56V LSB, ±51.2mV Dynamic Range 104A LSB, ±3.4A Dynamic Range (RSNS = 15m) Current Accumulation Register Resolution 6.25Vhr LSB, ±204.8mVh Range 0.417mAhr LSB, ±13.65Ah Range (RSNS = 15m) 11-Bit Voltage |
|
|
|
Maxim Integrated Products |
Single-Channel 1-Wire Master support 1-Wire power delivery to 1-Wire devices such as EEPROMs and sensors. When not in use, the DS2484 can be put in sleep mode where power consumption is minimal. Applications Printers Medical Instruments Industrial Sensors Cell Phones Benefits a |
|
|
|
Maxim Integrated Products |
Dallas Semiconductor will be used to determine the acceleration factor for failure mechanisms that are temperature accelerated. AfT = exp((Ea/k)*(1/Tu - 1/Ts)) = tu/ts AfT = Acceleration factor due to Temperature tu = Time at use temperature (e.g. 55°C) ts = Time at stre |
|
|
|
Maxim Integrated Products |
RELIABILITY REPORT FOR DS21Q59/ REV A2 rating: The Arrhenius model will be used to determine the acceleration factor for failure mechanisms that are temperature accelerated. AfT = exp((Ea/k)*(1/Tu - 1/Ts)) = tu/ts AfT = Acceleration factor due to Temperature tu = Time at use temperature ( |
|
|
|
Maxim Integrated Products |
Serial 1-Wire Line Driver • Simplifies the Design of a Low-Cost, Universal RS-232 COM Port to 1-Wire® Interface True-Ground o Interface to an RS-232 COM Port for Reading and Writing 1-Wire Devices o Works with Bipolar as well as Unipolar Logic Signals o Slew Rate Controlled 1 |
|
|
|
Maxim Integrated Products |
SCSI Terminator PIN ASSIGNMENT TERMPWR1 R1 R2 R3 R4 R5 VREF1 GND 1 2 3 4 5 6 7 8 16 15 14 13 12 11 10 9 PD VREF2 NC R9 R8 R7 R6 TERMPWR2 • Fully SCSI compliant with SCSI –1, Fast SCSI and Ultra • Backward compatible to the DS2107 and DS2107A • Provides active ter |
|
|
|
Maxim Integrated Products |
High-Accuracy Battery Fuel Gauge |
|
|
|
Maxim Integrated Products |
1-Cell Stand-Alone Fuel Gauge Precision Voltage, Temperature, and Current Measurement System Available Capacity Estimated from Coulomb Count, Discharge Rate, Temperature, and Cell Characteristics Estimates Cell Aging Using Learn Cycles Uses Low-Cost Sen |
|
|
|
Maxim Integrated Products |
Standalone Fuel Gauge § § § Precision Voltage, Temperature, and Current Measurement System Accurate, Temperature Stable Internal Time Base Absolute and Relative Capacity Estimated from Coulomb Count, Discharge Rate, Temperature and Battery Cell Characteristics Accurate Wa |
|
|
|
Maxim Integrated Products |
SHA-1 Authentication Master § § Initiates Challenge-and-Response Authentication based on the SHA-1 Algorithm Dallas 1-Wire Master/Slave Interface Operates at Standard and Overdrive Speeds Input and Output pins for Initiating Challenge and Reporting Authentication Pass/Fail Prog |
|
|
|
Maxim Integrated Products |
(DS2711 / DS2712) Loose Cell NiMH Chargers Charge 1 or 2 NiMH Cells Detect and Avoid Charging Alkaline Cells Precharge Deeply Depleted Cells Fast Charge NiMH with -∆V Termination Sensitivity of 2mV (typ) Monitor Voltage, Temperature, and Time for Safety and Secondary Termination R |
|
|
|
Maxim Integrated Products |
Quad E1 Transceiver § § § § § § § § § § § § § § § Four Complete E1 (CEPT) PCM-30/ISDN-PRI Transceivers Long-Haul and Short-Haul Line Interfaces 32-Bit or 128-Bit Crystal-Less Jitter Attenuator Frames to FAS, CAS, CCS, and CRC4 Formats 4MHz/8MHz/16MHz Clock Synthesizer F |
|