No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
Maxim Integrated Products |
1-Wire SHA-1 Authenticator 1Kb EEPROM ♦ 1024 Bits of EEPROM Memory Partitioned Into Four Pages of 256 Bits ♦ On-Chip 512-Bit SHA-1 Engine to Compute 160Bit Message Authentication Codes (MACs) and to Generate Secrets ♦ Write Access Requires Knowledge of the Secret and the Capability of Co |
|
|
|
Maxim Integrated |
1-Wire to I2C/SPI Bridge ● Operate Remote I2C or SPI Devices Using SingleContact 1-Wire Interface • Extending I2C/SPI Communication Distance • Reduce Six Wires (for SPI) or Four Wires (for I2C) to Two Wires • 512-Byte Sequencer for Autonomous Operation of Attached Devices • |
|
|
|
Maxim Integrated |
1-Wire-to-I2C Master Bridge ● ● Converts 1-Wire Communication Protocol to I2C Master I/O • Operates I2C Slave Peripherals over the SingleContact, 1-Wire Interface ● ● Extend I2C Communication Distance with 1-Wire Protocol • 100 Meters (typ) in Standard Speed for a Properly Conf |
|
|
|
Maxim Integrated Products |
Stand-Alone Fuel Gauge Precision Voltage, Temperature, and Current Measurement System TYPICAL OPERATING CIRCUIT Accurate Stable Internal Time Base Absolute and Relative Capacity Estimated from Coulomb Count, Discharge Rate, Temperature and Battery Cell Characteri |
|
|
|
Maxim Integrated |
5-Cell to 10-Cell Li+ Protector ♦ Complete Protection for 5-Cell to 10-Cell Li+ Packs ♦ Pin Programmable for 5 to 10 Cells ♦ Internal Cell-Balancing Circuit, Shunts Up to 300mA ♦ Pin-Programmable VOV Threshold ♦ Pin-Programmable Cell-Balance Voltage ♦ Overdischarge Current and Shor |
|
|
|
Maxim Integrated |
DeepCover Secure Authenticator |
|
|
|
Maxim Integrated Products |
2-Cell Stand-Alone Li+ Fuel-Gauge Precision measurements of voltage, temperature, and current, along with a cell characteristics table and application parameters, are used for capacity estimation calculations. The capacity registers report a conservative estimate of the amount of ch |
|
|
|
Maxim Integrated Products |
1-Wire SHA-1 Authenticator |
|
|
|
Maxim Integrated |
20Kb 1-Wire EEPROM 20480 Bits of Nonvolatile (NV) EEPROM Partitioned into Eighty 256-Bit Pages Individual 8-Page Groups of Memory Pages (Blocks) can be Permanently Write Protected or Put in OTP EPROM-Emulation Mode ("Write to 0") Read and Write Access Highly Back |
|
|
|
Maxim Integrated |
DeepCover Secure ECDSA Bidirectional Authenticator ● ● Robust Countermeasures Protect Against Security Attacks • Patented Physically Unclonable Function Secures Device Data • Actively Monitored Die Shield Detects and Reacts to Intrusion Attempts • All Stored Data Cryptographically Protected from Di |
|
|
|
Maxim Integrated |
1-Wire Secure SHA-3 Authenticator ● ● Robust Countermeasures Protect Against Security Attacks • All Stored Data Cryptographically Protected from Discovery ● ● Efficient Secure Hash Algorithm Authenticates Peripherals • FIPS 202-Compliant SHA-3 Algorithm for Challenge/Response Authent |
|
|
|
Maxim Integrated |
4kbit 1-Wire RAM 4096 bits of SRAM Four 32-bit, read-only counters Active-low external trigger inputs for two of the counters with on-chip debouncing compatible with reed and Wiegand switches Unique, factory-lasered and tested 64-bit registration number (8-bi |
|
|
|
Maxim Integrated |
4Kb 1-Wire EEPROM 4096 Bits Electrically Erasable Programmable Read-Only Memory (EEPROM) Unique, Factory-Lasered and Tested 64-Bit Registration Number (8-Bit Family Code + 48-Bit Serial Number + 8-Bit CRC Tester) Assures Absolute Identity Because No Two Parts Are |
|
|
|
Maxim Integrated |
4096-Bit Addressable 1-Wire EEPROM |
|
|
|
Maxim Integrated Products |
EEPROM 4kbit (512 x 8) EEPROM Organized in Two 256Byte Blocks Single Byte and up to 16-Byte EEPROM Write Sequences Write-Protect Control Pin for the Entire EEPROM Array Endurance 200k Cycles per Block at 25°C; 10ms max EEPROM Write Cyc |
|
|
|
Maxim Integrated Products |
1Kbit I2C/SMBus EEPROM are supported for each memory page. Each DS28CN01 has a guaranteed unique factory-programmed 64-bit registration number. Communication with the DS28CN01 is accomplished through an industrystandard I2C-compatible and SMBus™-compatible interface. The S |
|
|
|
Maxim Integrated Products |
Low-Cost I2C Battery Monitor 16-Bit Bidirectional Current Measurement 1.56V LSB, ±51.2mV Dynamic Range 104A LSB, ±3.4A Dynamic Range (RSNS = 15m) Current Accumulation Register Resolution 6.25Vhr LSB, ±204.8mVh Range 0.417mAhr LSB, ±13.65Ah Range (RSNS = 15m) 11-Bit Voltage |
|
|
|
Maxim Integrated Products |
2-Cell Stand-Alone Li+ Fuel-Gauge Precision measurements of voltage, temperature, and current, along with a cell characteristics table and application parameters, are used for capacity estimation calculations. The capacity registers report a conservative estimate of the amount of ch |
|
|
|
Maxim Integrated |
DeepCover Secure Authenticator |
|
|
|
Maxim Integrated Products |
Single-Channel 1-Wire Master support 1-Wire power delivery to 1-Wire devices such as EEPROMs and sensors. When not in use, the DS2484 can be put in sleep mode where power consumption is minimal. Applications Printers Medical Instruments Industrial Sensors Cell Phones Benefits a |
|