No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
msksemi |
TVS For surface mount application Excellent clamping capability Low profile package Fast response time: Typically less than 1.0ps from 0V to 7.22V Low inductance GPP Mechanical Data Case: Molded plastic Mounting position: Any Weight: 0. |
|
|
|
Msksemi |
Transient Voltage Suppressor Small Body Outline Dimensions: nom 0.039″ x 0.024″ (1.0x0.6 mm) Low Body Height: nom 0.0 19″ (0.5 mm) Low Capacitance 12 pF Low Clamping Voltage Reverse Working (Stand-off) Voltage: 5.0 V Low Leakage Response Time is Typically < 1 ns |
|
|
|
msksemi |
Schottky Barrier Diode QRM SOD923 Shipping 8,000 pcs / 7” Reel Tape wide 8 mm Embos pitch 2 mm Tape specification Conductive Notes Package Dimensions DS-923-SB-07-02 2 Aug.2016, |
|
|
|
MSK |
WIDE BANDWIDTH HIGH VOLTAGE AMPLIFIER WIDE BANDWIDTH HIGH VOLTAGE AMPLIFIER 600 (315) 701-6751 4707 Dey Road Liverpool, N.Y. 13088 Ultra Low Quiescent Current - ±15mA for High Voltage 150V Peak to Peak Output Voltage Swing Slew Rate - 4200V/µS Typical Gain Bandwidth Product - 550 MHz |
|
|
|
Consumer Microcircuits Limited |
GMSK Packet Data Modem • GMSK Modulation/Demodulation • On-chip Packet Detection • Rx or Tx up to 38.4kbits/sec • Parallel Host Processor Interface • Full and Short Data Packet Framing • Low Power 3.0V/5.0V Operation • Mobitex Compatible including R14N Short Block Fra |
|
|
|
msksemi |
Low Capacitance High ESD Level Protection Array ESD Protect for 4 high-speed I/O lines and one VDD line Provide ESD protection for each line to IEC 61000-4-2,(ESD) ±27kV (air), ±16kV (contact) IEC 61000-4-4 (EFT) Level-3, 55A (5/50ns) IEC 61000-4-5 (Lightning) 6A (8/20µs) For low operating voltage |
|
|
|
MSK |
H-BRIDGE MOSFET STEPPER MOTOR DRIVE Total Dose Hardened to 100 Krads(Si) (Method 1019.7 Condition A) 70V Maximum Operating Motor Supply Voltage 100V Absolute Maximum Output Stage Rating 10Amp Continuous Output Switch Capability Two Independent H Bridge MOSFET Output Stages Plus Gate D |
|
|
|
msksemi |
Transient Voltage Suppressing Device ESD/Surge Protection for 1 Line with Unidirectional. Provide ESD protection for each line to IEC 61000-4-2 (ESD) ±30kV (air / contact) IEC 61000-4-5 (Lightning) 60A (8/20µs) For operating voltage of 5.0V and below 1.6mm x 1.0mm DFN package saves boar |
|
|
|
msksemi |
Transient Voltage Suppressors Working voltage Peak power (tp=8/20us) Peak current (tp=8/20us) Transient protection IEC61000-4-2 Low clamping voltage Low leakage current Small package Applications Cell phone PMP MID PDA Digital camera Other electronics eq |
|
|
|
msksemi |
Transient Voltage Suppressors 150 Watts Peak Pulse Power per Line (tp = 8/20μs) Replacement for MLV (0603) Protects one I/O or power line Low Clamping Voltage Ultra Low Capacitance:0.5pF Working Voltage: 5 V Low Leakage Current Response Time is Typically < 1 ns IEC COMPATIBILITY |
|
|
|
msksemi |
MLV 150W peak pulse power (8/20μs) Protects one data or power line Ultra low leakage:nA level Operating voltage:15V Ultra low clamping voltage Complies with following standards: – IEC 61000-4-2 (ESD) immunity test Air discharge: ±30kV Contact |
|
|
|
MSK |
HIGH SPEED/VOLTAGE OP AMP Extremely Fast - 500v/µS Wide Supply Range ±15V to ±45V VMOS Output, No S.O.A. Restrictions Large Gain-Bandwidth Product FET Input Electrically Isolated Case 800mA Typical Output Current MIL-PRF-38534 CERTIFIED DESCRIPTION: The MSK 1461 is a state |
|
|
|
MSK |
FET INPUT HIGH SPEED VOLTAGE FOLLOWER/BUFFER AMPLIFIER Industry Wide LH0033/EL2005 Replacement Low Input Offset - 2mV Low Input Offset Drift - 25µV/°C FET Input, Low Input Current - 50pA High Slew Rate - 1500V/µS Wide Bandwidth - 140MHz High Output Current - ±100mA Available to DSCC SMD 5962-80014 DESC |
|
|
|
Analog Devices |
ISM Band FSK/GFSK/MSK/GMSK Transceiver Ultralow power, high performance transceiver Frequency bands: 902 MHz to 958 MHz Data rates supported: 1 kbps to 300 kbps 2.2 V to 3.6 V power supply Single-ended and differential power amplifiers (PAs) Low IF receiver with programmable IF bandwidths |
|
|
|
American First Semiconductor |
Schottky Barrier Rectifier • Plastic package has Underwriters Laboratory Flammability Classification 94V-0 • Metal silicon junction, majority carrier conduction • Guard ring for overvoltage protection • Low power loss, high efficiency • High current capability, Low forward vol |
|
|
|
ETC |
MOTOR DRIVE POWER HYBRID 25 AMP, 500 VOLT IGBT PLUS DIODE FULLY ISOLATED SMART POWER 3-PHASE MOTOR DRIVE POWER HYBRID 4358 (315) 701-6751 4707 Dey Road Liverpool, N.Y. 13088 500V, 25 Amp Capability at 110°C Fully Isolated Bridge Ultra Low Thermal Resistance Integral Free |
|
|
|
MSK |
HIGH VOLTAGE 4 AMP SURFACE MOUNT SWITCHING REGULATORS HIGH EFFICIENCY, HIGH VOLTAGE 4 AMP SURFACE MOUNT SWITCHING REGULATORS 5045 SERIES (315) 701-6751 4707 Dey Road Liverpool, N.Y. 13088 Up To 88% Efficiency For 5V Version 4 Amp Output Current 1.2 x VOUT to 80V Input Range with Separate Bias 12V to |
|
|
|
American First Semiconductor |
Schottky Barrier Rectifier • Plastic package has Underwriters Laboratory Flammability Classification 94V-0 • Metal silicon junction, majority carrier conduction • Guard ring for overvoltage protection • Low power loss, high efficiency • High current capability, Low forward vol |
|
|
|
MSK |
BUFFER AMPLIFIER Total Dose Tested to 300 Krads (Si) RAD Tolerant LH0002 Replacement High Input Impedance-180KΩ Min Low Output Impedance-10Ω Max Low Harmonic Distortion DC to 30 MHz Bandwidth Slew Rate is Typically 400 V/µS Operating Range from±5V to ±20V Contact MS |
|
|
|
MSK |
SMART POWER 3-PHASE MOTOR DRIVE HYBRID 200V, 20 Amp Capability Self-Contained, Smart Lowside/Highside Drive Circuitry Under-Voltage Lockout, Internal 2μS Deadtime Capable of Switching Frequencies to 25KHz Non-Hermetic Isolated Case Allows Direct Heat Sinking Case Bolt-down Design Allows |
|