No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
International Resistive |
(LRC / LRF Series) Low Value Flat Chip Resistor mm2 100 mm2 200 mm2 LR1206 / 2010 / 2512 D L LR1225 D bottom 2 places D w H 60/40 Solder Plating Nickel Barrier Layer Copper Wraparound Termination Alumina Substrate Protective Overcoat Resistive Element W Copper Termination BOTTOM TOP |
|
|
|
LRC |
HVR-2X062H 1 |
|
|
|
LRC |
EEPROM Two-wire Serial Interface VCC = 1.8V to 5.5V Bi-directional Data Transfer Protocol Internally Organized LR24C128, 16,384 X 8 (128K bits) LR24C256, 32,768 X 8 (256K bits) 400 kHz (1.8V, 2.7V, 5V) Compatibility 64-byte Page (128K/256K) Write Modes Part |
|
|
|
LRC |
LOW DROP FIXED AND ADJUSTABLE POSITIVE VOLTAGE REGULATORS *Low dropout voltage (1V Typ.) *2.85V device performances are suitable for SCSI-2 active termination www.DataSheet4U.com *Output current up to 0.8/1.0A *Fixed output voltage of: 1.5V, 1.8V, 2.5V, 2,85V, 3.0V, 3.3V, *3.6V, 5.0V *Adjustable version ava |
|
|
|
LRC |
Bias Resistor Transistor 1) Built-in bias resistors enable the configuration of an inverter circuit without connecting external input resistors (see equivalent circuit). 2) The bias resistors consist of thin-film resistors with complete isolation to allow positive biasing of |
|
|
|
LRC |
1A Bipolar Linear Regulator a very low standby current 2mA compared to 5mA of competitor. Other than a fixed version, Vout = 1.2V, 1.5V, 1.8V, 2.5V, 3.3V, 5V, and 12V, LR1117C has an adjustable version, which can provide an output voltage from 1.25 to 12V with only two external |
|
|
|
LRC |
1A Adjustable/Fixed Low Dropout Linear Regulator • Low dropout voltage • Load regulation: 0.05% typical • Trimmed current limit • On-chip thermal limiting • Standard SOT-223, TO-220, and TO-252 packages • Three-terminal adjustable or fixed 1.8V, 2.5V, 2.85V, 3.3V, 5V Applications • Active SCSI termi |
|
|
|
LRC |
Surface Mount Glass Passivated Junction Rectifiers * Plastic package has Underwriters Laboratory Flammability Classification 94V-0 * High temperature metallurgically bonded construction * Cavity-free glass passivated junction * Capable of meeting environmental standards of MIL-S-19500 * 1.5 A operati |
|
|
|
LRC |
High Current Glass Passivated Molding Single-Phase Bridge Rectifier Plastic Package has Underwriters Laboratory Flammability Classification 94V-0 www.DataSheet4U.com This series is UL listed under the Recognized Component index,file number E231047 Single-in-line package High current capality with small package Supe |
|
|
|
LRC |
Bias Resistor Transistor 1) Built-in bias resistors enable the configuration of an inverter circuit without connecting external input resistors. 2) The bias resistors consist of thin-film resistors with complete isolation to allow positive biasing of the input, and parasitic |
|
|
|
LRC |
Bias Resistor Transistor 1) Built-in bias resistors enable the configuration of an inverter circuit without connecting external input resistors (see equivalent circuit). 2) The bias resistors consist of thin-film resistors with complete isolation to allow positive biasing of |
|
|
|
LRC |
Dual Bias Resistor Transistors |
|
|
|
LRC |
Schmitt-Trigger Inverter/ CMOS Logic Level Shifter ltage. This allows the L74VHC1GT14 to be used to interface 5 V circuits to 3 V circuits. The output structures also provide protection when V CC = 0 V. These input and output structures help prevent device destruction caused by supply voltage – input |
|
|
|
LRC |
Bridge rectifiers & Dimension Plastic Package has Underwriters Laboratory Flammability Classification 94V-0 This series is UL listed under the Recognized Component index,file number E231047 Single-in-line package High current capality with small package Superior therm |
|
|
|
LRC |
Glass Passivated Junction Fast Switching Rectifiers * Plastic package has Underwriters Laboratory Flammability Classification 94V-0 * High temperature metallurgically bonded construction * Cavity-free glass passivated junction * Capable of meeting environmental standards of MIL-S-19500 * Fast |
|
|
|
LRC |
Schottky Barrier Rectifiers & Dimensions * Plastic package has Underwriters Laboratory Flammability Classification 94V-0 * Low power loss,high efficiency * For use in low voltage high frequency inverters, free wheeling,and polarity protection applications * Guarding for over vo |
|
|
|
LRC |
GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR * Plastic package has Underwriters Laboratory Flammability Classification 94V-O * Glass passivated chip junction in DO-41 package * 400W surge capability at 1ms * Excellent clamping capability * Low zener impedance * Fast response time: typica |
|
|
|
LRC |
Surface Mount Glass Passivated Junction Rectifiers * Plastic package has Underwriters Laboratory Flammability Classification 94V-0 * High temperature metallurgically bonded construction * Cavity-free glass passivated junction * Capable of meeting environmental standards of MIL-S-19500 * 1.5 A operati |
|
|
|
LRC |
SILICON BRIDGE RECTIFIER & Dimension Plastic Package has Underwriters Laboratory Flammability Classification 94V-0 Glass passivated chip junctions Surge overload rating of 50 Amperes peak Ideal for printed circuit board MECHANICAL DATA Case: Molded plastic Weight: 0.04 ounce |
|
|
|
LRC |
Single-Phase Bridge Rectifier z Plastic Package has Underwriters Laboratory Flammability Classification 94V-0 z High current capacity with small package z Glass passivated chip junctions z Superior thermal conductivity z High IFSM 1. Maximum & Thermal Characteristics Ratings at |
|