| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Intel Corporation |
Single-Port 10/100 Mbps PHY Transceiver ■ ■ ■ ■ ■ 3.3V Operation IEEE 802.3-compliant 10BASE-T or 100BASE-TX with integrated filters Auto-negotiation and parallel detection MII interface with extended register capability Robust baseline wander correction ■ ■ ■ ■ ■ Carrier Sense Multipl |
|
|
|
|
Intel Corporation |
Octal E1 Line Interface Unit a differential data receiver architecture with high noise interference margin. The receivers use peak detection and a variable threshold for reliable data recovery down to 500 mV or up to 12 dB of cable attenuation. Each receiver incorporates an anal |
|
|
|
|
Intel Corporation |
(LXT974 / LXT975) Fast Ethernet 10/100 Quad Transceivers s s s s s s Four independent IEEE 802.3compliant 10BASE-T or 100BASETX ports in a single chip. 100BASE-FX fiber-optic capable. Standard CSMA/CD or full-duplex operation. Supports auto-negotiation and legacy systems without auto-negotiation capabil |
|
|
|
|
Intel Corporation |
Advanced 8-Port 10/100 Mbps PHY Transceivers included in the LXT9785E transceiver. The LXT9785E is an enhanced version of the LXT9785 that detects Data Terminal Equipment (DTE) requiring power from the switch over a CAT5 cable. The system uses the information collected by the LXT97985E to apply |
|
|
|
|
Intel Corporation |
T1/E1 Short Haul Transceiver with Crystal-less Jitter Attenuation s s s s s s Fully integrated transceivers for Short-Haul T1 or E1 interfaces Crystal-less digital jitter attenuation — Select either transmit or receive path — No crystal or high speed external clock required Meet or exceed specifications in ANS |
|
|
|
|
Intel Corporation |
E-Rate Multiplexer n Performs four-E1 to one-E2, or four-E2 to one-E3 multiplexing. Five ICs will implement a sixteen-E1 to one-E3 multiplexer. n Fully compliant with the G.742 and G.751 ITU recommendations. Fully compliant with G.703 when used with LXT305/332 Line Int |
|
|
|
|
Intel Corporation |
Dual-Speed Fast Ethernet Transceiver s s s s s IEEE 802.3 Compliant: — 10BASE-T and 100BASE-TX using a single RJ-45 connection. — Supports auto-negotiation and parallel detection for legacy systems. — MII interface with extended register capability. Robust baseline wander correction p |
|
|
|
|
Intel Corporation |
3.3V Dual-Speed Fast Ethernet Transceiver Datasheet s s s s s s 3.3V Operation. Low power consumption (300 mW typical). 10BASE-T and 100BASE-TX using a single RJ-45 connection. Supports auto-negotiation and parallel detection. MII interface with extended register capability. Robust baseline wander co |
|
|
|
|
Intel Corporation |
3.3V Dual-Speed Fast Ethernet Transceiver Datasheet s s s s s s 3.3V Operation. Low power consumption (300 mW typical). 10BASE-T and 100BASE-TX using a single RJ-45 connection. Supports auto-negotiation and parallel detection. MII interface with extended register capability. Robust baseline wander co |
|
|
|
|
Intel Corporation |
Transceiver s Complementary Metal Oxide Semiconductor (CMOS) An inexpensive design technology used in integrated circuit chip design that allows very low power consumption (less than 650mW is typical) for optimal board usage Meets with Bellcore GR-253, ITU-T G |
|
|
|
|
Intel Corporation |
Transceiver Hardware Integrity Function Overview or instructions marked “reserved” or “undefined.” Intel reserves these for future definition and shall have no responsibility whatsoever for conflicts or incompatibilities arising from future changes to them. The LXT9784 may contain design defects or |
|
|
|
|
Intel Corporation |
(LXT974 / LXT975) Fast Ethernet 10/100 Quad Transceivers s s s s s s Four independent IEEE 802.3compliant 10BASE-T or 100BASETX ports in a single chip. 100BASE-FX fiber-optic capable. Standard CSMA/CD or full-duplex operation. Supports auto-negotiation and legacy systems without auto-negotiation capabil |
|
Desde 2024. D4U Semiconductor.
|