No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
Freescale Semiconductor |
ISO K Line Serial Link Interface • • • • • • • • • • • Device Operates Over Wide Supply Voltage of 8.0 to 18 V Operating Temperature of -40 to 125°C MC33290D/R2 Interfaces Directly to Standard CMOS Microprocessors MCZ33290EF/R2 ISO K Line Pin Protected Against Shorts to Ground Therm |
|
|
|
Freescale Semiconductor |
System Basis Chip • VDD1: 5.0 V low drop voltage regulator, current limitation, overtemperature detection, monitoring and reset function with total current capability 200 mA • V2: tracking function of VDD1 regulator; control circuitry for external bipolar ballast tran |
|
|
|
Freescale Semiconductor |
Multiple Switch Detection Interface a 22-to-1 analog multiplexer for reading inputs as analog. The analog input signal is buffered and provided on the AMUX output pin for the MCU to read. The 33972 device has two modes of operation, Normal and Sleep. Normal mode allows programming of t |
|
|
|
Freescale Semiconductor |
Local Area Network (LIN) Enhanced Physical Interface of CAN are not required. The 33661 is a Physical Layer component dedicated to automotive LIN sub-bus applications. It offers slew rate selection for optimized operation at 10 kbps and 20 kbps, fast baud rate (above 100 kbps) for test and programming |
|
|
|
Freescale Semiconductor |
16-Output Switch that reduces the MCU’s fault management burden. 33999 POWER DUAL OCTAL SERIAL SWITCH WITH SERIAL PERIPHERAL INTERFACE I/O EK SUFFIX (PB-FREE) 98ASA10506D 54-PIN SOICW EXPOSED PAD Features ORDERING INFORMATION • Designed to Operate 5.0 V < VPWR < 2 |
|
|
|
Freescale Semiconductor |
Configurable Octal Serial Switch include very low standby currents, “cascadable” fault reporting, internal 40 V output clamping for low-side configurations, internal -20 V output clamping for high-side configurations, output-specific diagnostics, and independent shutdown of outputs. |
|
|
|
Freescale Semiconductor |
Two-Channel Distributed System Interface (DSI) Physical Interface Device • • • • • • • • • • Two Independent DSI Compatible Buses Pinout Matched to MC68HC55 (SPI to DSI Logic) Wave-Shaped Bus Output Voltage Independent Thermal Shutdown and Current Limit Return Signalling Current Detection Internal Logic Input Pull ups and |
|
|
|
Freescale Semiconductor |
Three-Phase Gate Driver IC • Drives Six N-Channel Low RDS(ON) Power MOSFETs • Built-In Charge Pump Circuitry • Built-In Current Sense Comparator and Output Drive Current Limiting • Built-In PWM Mode Control Logic • Built-In Circuit Protection • Designed for Fractional to Integ |
|
|
|
Freescale Semiconductor |
Eight Output Switch include very low standby current. Features 33298 LOW-SIDE SWITCH DW SUFFIX EG SUFFIX (PB-FREE) 98ASB42344B 24 SOICW ORDERING INFORMATION Device MC33298DW/R2 -40°C to 125°C 24 SOIC Temperature Range (TA) Package • Designed to Operate Over Wide Sup |
|
|
|
Freescale Semiconductor |
Dual Gauge Driver •MMT-Licensed Two-Phase Step Motor Compatible •Switec MS-X15.xxx Step Motor Compatible •Minimal Processor Overhead Required •Fully Integrated Pointer Movement and Position State Machine with Channel-Independent Configurable Pointer Movement •4096 Pos |
|
|
|
Freescale Semiconductor |
Multiple Switch Detection Interface a 22-to-1 analog multiplexer for reading inputs as analog. The analog input signal is buffered and provided on the AMUX output pin for the MCU to read. The 33972 device has two modes of operation, Normal and Sleep. Normal mode allows programming of t |
|
|
|
Freescale Semiconductor |
Contact Monitoring and Dual Low-Side Protected Driver • • • • Eight High-Voltage Sense Inputs Direct Interfacing to Microcontroller Two Current Limited Low-Side Drivers Drivers Internally Overvoltage Clamped and Thermally Protected • 55 µA Standby Current • Pb-Free Packaging Designated by Suffix Code EG |
|
|
|
Freescale Semiconductor |
Dual High-Side TMOS Driver • PWM Capability • Power TMOS Number One (OUT1) Short-Circuit Detection and Short-Circuit Protection • Voltage Range 7.0 V ≤ 40 V • Extended Temperature Range from -40°C ≤ 125°C • Load Dump Protected • Overvoltage Detection and Activation of OUT2 Dur |
|
|
|
Freescale Semiconductor |
System Basis Chip • 1.0 Mbps CAN Transceiver Bus Interface with Bus Diagnostic Capability • SPI Control at Frequencies up to 4.0 Mhz • 5.0 V Low Dropout Voltage Regulator with Current Limiting, Overtemperature Pre-Warning, and Output Monitoring and Reset • A Second 5. |
|
|
|
Freescale Semiconductor |
Distributed System Interface (DSI) Sensor Interface • Conforms to DSI Specification Version 1 • 4-Channel, 8-Bit Analog-to-Digital Converter (ADC) • 4 Pins Configurable as Analog or Logic Inputs or as Logic Outputs • Provides Regulated +5.0 V Output for Sensor Power from Bus • Additional High-Drive Lo |
|
|
|
Freescale Semiconductor |
Distributed System Interface (DSI) Sensor Interface • Conforms to DSI Specification Version 1 • 4-Channel, 8-Bit Analog-to-Digital Converter (ADC) • 4 Pins Configurable as Analog or Logic Inputs or as Logic Outputs • Provides Regulated +5.0 V Output for Sensor Power from Bus • Additional High-Drive Lo |
|
|
|
Freescale Semiconductor |
Four Channel Squib Driver IC are incorporated to provide fail-safe operation. The device contains a serial peripheral interface (SPI) compatible 8-bit interface to allow microprocessor control. The device has the capability to be used in a standard four-channel squib driver IC o |
|
|
|
Freescale Semiconductor |
Automotive High-Side TMOS Driver • Designed for Automotive High Side Driver Application • Works with a Wide Variety of N-Channel Power MOSFETs ORDERING INFORMATION • PWM Capability • On Board Charge Pump Capable of Charging 25nF in less than 1ms Temperature Device Package with No Ex |
|
|
|
Freescale Semiconductor |
Eight-Output Switch include very low standby current, SPI cascade fault reporting capability, internal 53 V clamp on each output, output-specific diagnostics, and independent shutdown of outputs. The device is parametrically specified over an ambient temperature range o |
|
|
|
Freescale Semiconductor |
Class B Serial Transceiver • Designed for SAE J-1850 Class B Data Rates • Full Operational Bus Dynamics Over a Supply Voltage of 9.0 to 16 V • Ambient Operating Temperature of -40°C to 125°C • Interfaces Directly to Standard 5.0 V CMOS Microcontroller • BUS Pin Protected Again |
|