No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
Freescale Semiconductor |
16-Output Switch that reduces the MCU’s fault management burden. Features • Designed to Operate 5.0 V < VPWR < 27 V • 24-Bit SPI for Control and Fault reporting, 3.3 V/5.0 V Compatible • Outputs Are Current Limited (0.9 A to 2.5 A) to Drive Incandescent Lamps • Outpu |
|
|
|
Freescale Semiconductor |
5.0A Throttle Control H-Bridge • 5.0 to 28 V continuous operation (transient operation from 5.0 to 40 V) • 225 m maximum RDS(on) at 150 °C (each H-Bridge MOSFET) • 3.0 V and 5.0 V TTL / CMOS logic compatible inputs • Overcurrent limiting (Regulation) via an internal constant-off- |
|
|
|
Freescale Semiconductor |
Enhanced Class B Serial Transceiver • Designed for SAE J-1850 Class B Data Rates • Full Operational Bus Dynamics Over a Supply Voltage of 9.0 V to 16 V • Ambient Operating Temperature of -40°C to 125°C • Interfaces Directly to Standard 5.0 V CMOS Microcontroller • BUS Pin Protected Aga |
|
|
|
Freescale Semiconductor |
Switching Power Supply • Operating Voltage Range 6.0 V up to 26.5 V (40 V transient) • Step-Down Switching Regulator Output VDDH = 5.0 V @ 1400 mA (total) • Linear Regulator with External Pass Transistor VDDL = 3.3 V @ 400 mA • Low-Power Standby Linear Regulator VKAM = 3.3 |
|
|
|
Freescale Semiconductor |
5.0A Throttle Control H-Bridge provides a proportional (0.24% of the load current) current output suitable for monitoring by a microcon |
|
|
|
Freescale Semiconductor |
Single High Side Switch The 33981 is suitable for loads with high inrush current, as well as motors and all types of resistive and inductive loads. The 33981 is packaged in a 12 x 12 mm non-leaded power-enhanced PQFN package with exposed tabs. Features • Single 4.0 m RDS( |
|
|
|
Freescale Semiconductor |
High-speed CAN Transceiver • Very low-current consumption in standby mode • Compatible with 3.3 V or 5.0 V MCU interface • Standby mode with remote CAN wake-up on some versions. • Pin and function compatible with market standard Cost efficient robustness: • High system level E |
|
|
|
Freescale Semiconductor |
Multiple Switch Detection Interface a 22-to-1 analog multiplexer for reading inputs as analog. The analog input signal is buffered and provided on the AMUX output pin for the MCU to read. MULTIPLE SWITCH DETECTION INTERFACE The 33993 device has two modes of operation, Sleep and Norma |
|
|
|
Freescale Semiconductor |
16-Output Switch that reduce the MCU’s fault management burden. Features • Designed to operate 5.0V < VPWR < 27V • 24 Bit SPI for control and fault reporting, 3.3/5.0V compatible • Outputs are current limited (0.9 to 2.5A) to drive incandescent lamps • Output voltage |
|
|
|
Freescale Semiconductor |
Switch Mode Power Supply include Active Reset circuitry watching VDDH, VDD3_3, VDDL and VKAM, user selectable Hardware Reset Timer (HRT), Power Sequencing circuitry guarantees the core supply voltages never exceed their limits or polarities during system power up and power d |
|
|
|
Freescale Semiconductor |
Three-Phase Gate Driver IC • Drives Six N-Channel Low RDS(ON) Power MOSFETs • Built-In Charge Pump Circuitry • Built-In Current Sense Comparator and Output Drive Current Limiting • Built-In PWM Mode Control Logic • Built-In Circuit Protection • Designed for Fractional to Integ |
|
|
|
Freescale Semiconductor |
Dual Gauge Driver 33970 IMPROVED GAUGE DRIVER INTEGRATED CIRCUIT DW SUFFIX EG SUFFIX (Pb-FREE) 98ASB42344B 24-PIN SOICW ORDERING INFORMATION • MMT-Licensed Two-Phase Step Motor Compatible Temperature Device Package • Minimal Processor Overhead Required Range (TA) • |
|
|
|
Freescale Semiconductor |
Multiple Switch Detection Interface a 22-to-1 analog multiplexer for reading inputs as analog. The analog input signal is buffered and provided on the AMUX output pin for the MCU to read. The 33972 device has two modes of operation, Normal and Sleep. Normal mode allows programming of t |
|
|
|
Freescale Semiconductor |
Multiple Switch Detection Interface a 22-to-1 analog multiplexer for reading inputs as analog. The analog input signal is buffered and provided on the AMUX output pin for the MCU to read. The 33972 device has two modes of operation, Normal and Sleep. Normal mode allows programming of t |
|
|
|
Freescale Semiconductor |
Multiple Switch Detection Interface a 22-to-1 analog multiplexer for reading inputs as analog. The 33975 device has two modes of operation, Normal and Sleep. Normal mode allows programming of the device and supplies switch contacts with pull-up or pull-down current as it monitors switc |
|
|
|
Freescale Semiconductor |
Multiple Switch Detection Interface a 22-to-1 analog multiplexer for reading inputs as analog. The 33975 device has two modes of operation, Normal and Sleep. Normal mode allows programming of the device and supplies switch contacts with pull-up or pull-down current as it monitors switc |
|
|
|
Freescale Semiconductor |
Multiple Switch Detection Interface a 22-to-1 analog multiplexer for reading inputs as analog. The 33975 device has two modes of operation, Normal and Sleep. Normal mode allows programming of the device and supplies switch contacts with pull-up or pull-down current as it monitors switc |
|
|
|
Freescale Semiconductor |
Dual Gauge Driver •MMT-Licensed Two-Phase Step Motor Compatible •Switec MS-X15.xxx Step Motor Compatible •Minimal Processor Overhead Required •Fully Integrated Pointer Movement and Position State Machine with Channel-Independent Configurable Pointer Movement •4096 Pos |
|
|
|
Freescale Semiconductor |
Single Gauge Driver • • • • • • • • • • • • • • MMT-Licensed Two-Phase Stepper Motor Compatible Switec MS-X15.xxx Stepper Motor Compatible Minimal Processor Overhead Required Fully Integrated Pointer Movement and Position State Machine with Air Core Movement Emulation 4 |
|
|
|
Freescale Semiconductor |
System Basis Chip Also, an Interrupt can be generated, for the MCU, based on CAN bus activity as well as mode changes. Features • VDD1: Low Drop Voltage Regulator, Current Limitation, Overtemperature Detection, Monitoring, and Reset Function • VDD1: Total Current Cap |
|