logo

ETCTI CC3 DataSheet

No. parte # Fabricante Descripción Hoja de Datos
1
UCC3808A-2

Texas Instruments
Low-Power Current-Mode Push-Pull PWM

•1 Dual-Output Drive Stages in Push-Pull Configuration
• Current-Sense Discharge Transistor to Improve Dynamic Response
• 130-μA Typical Starting Current
• 1-mA Typical Run Current
• Operation to 1 MHz
• Internal Soft Start
• On-Chip Error Amplifier
Datasheet
2
UCC3802

Texas Instruments
Low-Power BiCMOS Current-Mode PWM Controllers

•1 100-μA Typical Starting Supply Current
• 500-μA Typical Operating Supply Current
• Operation up to 1 MHz
• Internal Soft Start
• Internal Fault Soft Start
• Internal Leading-Edge Blanking of the Current Sense Signal
• 1-A Totem-Pole Output
• 70-ns
Datasheet
3
UCC3804

Texas Instruments
Low-Power BiCMOS Current-Mode PWM Controllers

•1 100-μA Typical Starting Supply Current
• 500-μA Typical Operating Supply Current
• Operation up to 1 MHz
• Internal Soft Start
• Internal Fault Soft Start
• Internal Leading-Edge Blanking of the Current Sense Signal
• 1-A Totem-Pole Output
• 70-ns
Datasheet
4
UCC38083P

Texas Instruments
8-Pin Current Mode Push-Pull PWM Controllers
D Programmable Slope Compensation D Internal Soft-Start on the UCC38083/4 D Cycle-by-Cycle Current Limiting D Low Start-Up Current of 120 µA and 1.5 mA Typical Run Current D Single External Component Oscillator Programmable from 50 kHz to 1 MHz D Hig
Datasheet
5
CC3301

Texas Instruments
Wi-Fi 6 and Bluetooth Low Energy companion-IC
Key Features
• Wi-Fi 6 (802.11ax)
• Bluetooth® low energy 5.3 in CC33x1 devices
• Companion IC to any processor or MCU host capable of running a TCP/IP stack
• Integrated 2.4-GHz PA for complete wireless solution with up to +20-dBm output power.
• Op
Datasheet
6
UCC37321

Texas Instruments
Single 9-A High-Speed Low-Side Mosfet Driver

•1 Industry-Standard Pin-Out With Addition of Enable Function
• High-Peak Current Drive Capability of ±9 A at theMiller plateau region Using TrueDrive
• Efficient Constant Current Sourcing Using a Unique BiPolar and CMOS Output Stage
• TTL/CMOS Compa
Datasheet
7
UCC38085

Texas Instruments
8-Pin Current Mode Push-Pull PWM Controllers
D Programmable Slope Compensation D Internal Soft-Start on the UCC38083/4 D Cycle-by-Cycle Current Limiting D Low Start-Up Current of 120 µA and 1.5 mA Typical Run Current D Single External Component Oscillator Programmable from 50 kHz to 1 MHz D Hig
Datasheet
8
UCC38C43

Texas Instruments
BiCMOS Low-Power Current-Mode PWM Controller

• Enhanced replacement for UCx84x and UCx84xA family with pin-to-pin compatibility
• Operating frequency: 1MHz Maximum
• 50μA Startup Current, 100μA Maximum
• Low operating current: 2.3mA (at fOSC = 52kHz)
• Fast, cycle-by-cycle overcurrent limiting:
Datasheet
9
UCC38531

ETCTI
Universal Serial Bus Power Controller
Datasheet
10
UCC38051

Texas Instruments
Transition Mode PFC Controller

•1 Transition Mode PFC Controller for Low Implementation Cost
• Industry Pin Compatibility With Improved Feature Set
• Improved Transient Response With Slew-Rate Comparator
• Zero Power Detect to Prevent Overvoltage Protection (OVP) During Light Load
Datasheet
11
UCC3803

Texas Instruments
Low-Power BiCMOS Current-Mode PWM Controllers

•1 100-μA Typical Starting Supply Current
• 500-μA Typical Operating Supply Current
• Operation up to 1 MHz
• Internal Soft Start
• Internal Fault Soft Start
• Internal Leading-Edge Blanking of the Current Sense Signal
• 1-A Totem-Pole Output
• 70-ns
Datasheet
12
UCC35705

Texas Instruments
HIGH-SPEED VOLTAGE MODE PULSE WIDTH MODULATOR
a high speed oscillator with integrated feed-forward compensation for improved converter performance. A typical current sense to output delay time of 25 ns provides fast response to overload conditions. The IC also provides an accurate programmable m
Datasheet
13
UCC38C40

Texas Instruments
BiCMOS Low-Power Current-Mode PWM Controller

• Enhanced replacement for UCx84x and UCx84xA family with pin-to-pin compatibility
• Operating frequency: 1MHz Maximum
• 50μA Startup Current, 100μA Maximum
• Low operating current: 2.3mA (at fOSC = 52kHz)
• Fast, cycle-by-cycle overcurrent limiting:
Datasheet
14
UCC3801

Texas Instruments
Low-Power BiCMOS Current-Mode PWM Controllers

•1 100-μA Typical Starting Supply Current
• 500-μA Typical Operating Supply Current
• Operation up to 1 MHz
• Internal Soft Start
• Internal Fault Soft Start
• Internal Leading-Edge Blanking of the Current Sense Signal
• 1-A Totem-Pole Output
• 70-ns
Datasheet
15
UCC3580-4

Texas Instruments
Single Ended Active Clamp/Reset PWM
Provides Auxiliary Switch Activation Complementary to Main Power Switch Drive Programmable deadtime (Turn-on Delay) Between Activation of Each Switch Voltage Mode Control with Feedforward Operation Programmable Limits for Both Transformer Volt- Secon
Datasheet
16
UCC38503

Texas Instruments
BiCMOS PFC/PWM Combination Controller
D Combines PFC and Downstream Converter Controls D Controls Boost Preregulator to Near-Unity Power Factor D Accurate Power Limiting D Improved Feedforward Line Regulation D Peak Current-Mode Control in Second Stage D Programmable Oscillator D Leading
Datasheet
17
UCC39002

Texas Instruments
Advanced 8-Pin Load-Share Controller

•1 High Accuracy, Better Than 1% Current Share Error at Full Load
• High-Side or Low-Side (GND Reference) CurrentSense Capability
• Ultra-Low Offset Current Sense Amplifier
• Single Wire Load Share Bus
• Full Scale Adjustability
• Intel® SSI Load Sha
Datasheet
18
CC3235S

Texas Instruments
SoC

• Multiple-core architecture, system-on-chip (SoC)
• 802.11 a/b/g/n: 2.4 GHz and 5 GHz
• FIPS 140-2 Level 1 Certification
• Multilayered security features, help developers protect identities, data, and software IP
• Low-Power Modes for battery powere
Datasheet
19
UCC38084

Texas Instruments
8-Pin Current Mode Push-Pull PWM Controllers
D Programmable Slope Compensation D Internal Soft-Start on the UCC38083/4 D Cycle-by-Cycle Current Limiting D Low Start-Up Current of 120 µA and 1.5 mA Typical Run Current D Single External Component Oscillator Programmable from 50 kHz to 1 MHz D Hig
Datasheet
20
UCC38083

Texas Instruments
8-Pin Current Mode Push-Pull PWM Controllers
D Programmable Slope Compensation D Internal Soft-Start on the UCC38083/4 D Cycle-by-Cycle Current Limiting D Low Start-Up Current of 120 µA and 1.5 mA Typical Run Current D Single External Component Oscillator Programmable from 50 kHz to 1 MHz D Hig
Datasheet



logo    Desde 2024. D4U Semiconductor.   |   Contáctenos   |   Política de Privacidad