No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
ETC |
Voltage Regulator Why you might ask?This is because the LM7810 pins are opposite of the original TCA700Y. Note: A brass spacer is provided if you purchase a new replacement 171 919 803. Since the TCA700Y is no longer made, its just makes sense to use the cheaper LM78 |
|
|
|
Texas Instruments |
Low-Voltage 8-Channel I2C Switch •1 1-to-8 Bidirectional translating switches • I2C Bus and SMBus compatible • Active-low reset input • Three address pins, allowing up to eight TCA9548A devices on the I2C bus • Channel selection through an I2C Bus, in any combination • Power up with |
|
|
|
Texas Instruments |
Low-Voltage 16-Bit I2C and SMBus I/O Expander • I2C to parallel port expander • Operating power-supply voltage range of 1.65 V to 5.5 V • Allows bidirectional voltage-level translation and GPIO expansion between 1.8-V, 2.5-V, 3.3-V, and 5-V I2C Bus and P-ports • Low standby current consumption o |
|
|
|
Texas Instruments |
Automotive High Speed CAN Transceiver •1 AEC Q100: Qualified for Automotive Applications – Device Temperature Grade 1: –40°C to 125°C TA • Meets the Requirements of ISO 11898-2:2016 and ISO 11898-5:2007 Physical Layer Standards • Support of Classical CAN and CAN FD up to 5 Mbps – Short a |
|
|
|
Texas Instruments |
Low-Power Fault Protected CAN Transceiver • AEC Q100: Qualified for automotive applications – Temperature Grade 1: –55°C to 125°C, TA – Device HBM classification level: ±16 kV – Device CDM classification level: ±1500 V • Functional Safety-Capable – Documentation available to aid functional s |
|
|
|
Texas Instruments |
Low Voltage 8-Bit I2C and SMBUS Low-Power I/O Expander •1 Low Standby Current Consumption • I2C to Parallel Port Expander • Open-Drain Active-Low Interrupt Output • Operating Power-Supply Voltage Range of 1.65 V to 5.5 V • 5-V Tolerant I/O Ports • 400-kHz Fast I2C Bus • Three Hardware Address Pins Allow |
|
|
|
ETC |
TCA350 |
|
|
|
Texas Instruments |
Automotive Control Area Network Flexible Data-Rate Controller •1 AEC Q100: qualified for automotive applications – Temperature grade 1: –40°C to 125°C TA • CAN FD controller with integrated CAN FD transceiver and serial peripheral interface (SPI) • CAN FD controller supports both ISO 118981:2015 and Bosch M_CAN |
|
|
|
Texas Instruments |
3.3-V CAN Transceivers •1 3.3-V Single Supply Operation • Data Rates up to 5 Mbps (TCAN33xG Devices) • Compatible With ISO 11898-2 • SOIC-8 and SOT-23 Package Options • Operating Modes: – Normal Mode (All Devices) – Low Power Standby Mode With Wake (TCAN334) – Silent Mode |
|
|
|
ETC |
STEREO DECODER |
|
|
|
Texas Instruments |
Automotive Fault Protected CAN Transceiver •1 AEC Q100: Qualified for Automotive Applications – Device Temperature Grade 1: -40°C to 125°C Ambient Operating Temperature – Device HBM Classification Level: ±16 kV – Device CDM Classification Level ±1500 V • Meets the ISO 11898-2:2016 and ISO 118 |
|
|
|
Texas Instruments |
Automotive fault protected CAN transceiver • AEC-Q100 (grade 1): Qualified for automotive applications • Meets the ISO 11898-2:2016 and ISO 11898-5:2007 physical layer standards • Functional Safety-Capable – Documentation available to aid functional safety system design • 'Turbo' CAN: – All d |
|
|
|
Texas Instruments |
Fault Protected CAN Transceiver •1 Meets the ISO 11898-2:2016 and ISO 11898-5:2007 Physical Layer Standards • 'Turbo' CAN: – All Devices Support Classic CAN and 2 Mbps CAN FD (Flexible Data Rate) and "G" Options Support 5 Mbps – Short and Symmetrical Propagation Delay Times and Fas |
|
|
|
Texas Instruments |
Ultra-Low-Voltage I2C Translator • 2-bit bidirectional translator for SDA and SCL lines in I2C applications • Provides bidirectional voltage translation with no direction pin • High-impedance output SCL_A, SDA_A, SCL_B, SDA_B pins when OE = 0 V or VCC = 0 V • Internal 10-kΩ pull-up |
|
|
|
ETC |
Fensterdiskriminator-IS |
|
|
|
Texas Instruments |
LOW VOLTAGE 16-BIT I2C I/O EXPANDER 1 • I2C to Parallel Port Expander • Supports partial power down i.e. SDA and SCL are 5V tolerant (<1uA leakage) even when Vcc=0 • Supports 1.8V I2C operation • Open-Drain Active-Low Interrupt Output • Active-Low Reset Input • I/O Ports are 5V toleran |
|
|
|
Texas Instruments |
Hot Swappable 2-Wire Bus Buffers •1 Operating Power-Supply Voltage Range of 2.7-V to 5.5-V • Supports Bidirectional Data Transfer of I2C Bus Signals • SDA and SCL Lines Are Buffered Which Increases Fanout • 1-V Precharge on All SDA and SCL Lines Prevents Corruption During Live Board |
|
|
|
Texas Instruments |
3.3-V CAN Transceivers •1 3.3-V Single Supply Operation • Data Rates up to 5 Mbps (TCAN33xG Devices) • Compatible With ISO 11898-2 • SOIC-8 and SOT-23 Package Options • Operating Modes: – Normal Mode (All Devices) – Low Power Standby Mode With Wake (TCAN334) – Silent Mode |
|
|
|
Texas Instruments |
3.3-V CAN Transceivers •1 3.3-V Single Supply Operation • Data Rates up to 5 Mbps (TCAN33xG Devices) • Compatible With ISO 11898-2 • SOIC-8 and SOT-23 Package Options • Operating Modes: – Normal Mode (All Devices) – Low Power Standby Mode With Wake (TCAN334) – Silent Mode |
|
|
|
Texas Instruments |
3.3-V CAN Transceivers •1 3.3-V Single Supply Operation • Data Rates up to 5 Mbps (TCAN33xG Devices) • Compatible With ISO 11898-2 • SOIC-8 and SOT-23 Package Options • Operating Modes: – Normal Mode (All Devices) – Low Power Standby Mode With Wake (TCAN334) – Silent Mode |
|