| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
ETC |
155Mbps / 2Km / 1x9 SC Duplex Optical Transceiver Module for Fast Ethernet / ATM / SONET/SDH STM-1/OC-3 Full Compliance with the Optical Performance Requirements of the ATM 100Mbps and 100 Base-FX Version of IEEE 802.3u. Industry Standard 1x9 Footprint and Duplex SC Connector Interface. Single 5V OPT-155A1H1A or 3.3V OPT-155A2H1A Power Supply. PECL Dif |
|
|
|
|
STMicroelectronics |
SERIAL INTERFACE CODEC/FILTER The encode portion of each device consists of an input gain adjust amplifier, an active RC pre-filter which eliminates very high frequency noise prior to entering a switched-capacitor band-pass filter that rejects signals below 200 Hz and above 3400 |
|
|
|
|
ETC |
EASTMAN Fine Grain Duplicating Panchromatic Negative Film 2234/ 3234/ 5234/ 7234 sing times may require modification for a particular machine. Note: Observe precautionary information on product labels and on the Material Safety Data Sheets. Processing Step Temperature Time Replenishment Rate (mL per 100 ft) 35 mm KODAK Developer |
|
|
|
|
STMicroelectronics |
SERIAL INTERFACE CODEC/FILTER The encode portion of each device consists of an input gain adjust amplifier, an active RC pre-filter which eliminates very high frequency noise prior to entering a switched-capacitor band-pass filter that rejects signals below 200 Hz and above 3400 |
|
|
|
|
ETC |
155Mbps / 2Km / 1x9 SC Duplex Optical Transceiver Module for Fast Ethernet / ATM / SONET/SDH STM-1/OC-3 Full Compliance with the Optical Performance Requirements of the ATM 100Mbps and 100 Base-FX Version of IEEE 802.3u. Industry Standard 1x9 Footprint and Duplex SC Connector Interface. Single 5V OPT-155A1H1A or 3.3V OPT-155A2H1A Power Supply. PECL Dif |
|
|
|
|
ETC |
155Mbps / 2Km / 1x9 SC Duplex Optical Transceiver Module for Fast Ethernet / ATM / SONET/SDH STM-1/OC-3 Full Compliance with the Optical Performance Requirements of the ATM 100Mbps and 100 Base-FX Version of IEEE 802.3u. Industry Standard 1x9 Footprint and Duplex SC Connector Interface. Single 5V OPT-155A1H1A or 3.3V OPT-155A2H1A Power Supply. PECL Dif |
|
|
|
|
STMicroelectronics |
POWER AMPLIFIER SERIAL INTERFACE CODEC/FILTERWITH RECEIVE an additional Receive Power Amplifier to provide push-pull balanced output drive capability. The receive gain can be adjusted by means of two external resistors for an output level of up to ± 6.6 V across a balanced 600Ω load. Also included is an Ana |
|
|
|
|
ETC |
No-adjustment Sync Separator Monolithic IC 1. 2. 3. 4. 5. 6. 7. 8. Low current consumption 4.4mA typ. Open collector output Built-in 3V regulator handles power supply ripple Built-in capacitor for vertical sync separation Time from vertical signal to H. SYNC output re-sync reduced (relative t |
|
|
|
|
ETC |
RS-232 to RS-485 Passive Converter |
|
|
|
|
ETC |
800 - 1000 MHz High Linearity Active Transmit Mixer Functional Block Diagram VEE VCC VEE RFN RFP VEE VCC IFN 1 2 3 4 5 6 7 8 16 15 14 13 12 11 10 9 VEE VCC VEE LON LOP VEE VCC IFP Product Specifications Parameters RF Frequency Range LO Frequency Range IF Frequency Range Conversion Gain SSB Noise Fig |
|
|
|
|
ETC |
SPECIFICATIONS FOR NICHIA FULL COLOR LED on Min. IF=20[mA] VR= 5[V] IF=20[mA] 86 Blue Typ. 3.6 125 Max. Min. 4.0 50 425 Green Typ. 3.5 600 Max. Min. 4.0 50 125 (Ta=25°C) Red Typ. 1.9 175 Max. 2.4 50 V µA Data mcd Unit m et4U.co DataSheet4U.com Shee ! Measurement Uncertainty of the Lum |
|
|
|
|
ETC |
(OM3910xxx / OM3911xxx) POSITIVE ADJUSTABLE VOLTAGE REGULATOR APPROVED TO DESC DRAWING 5962-87675 • Approved To DESC Standardized Military Drawing 5962-8767501UX/TX and 5962-8767502UX/TX • Isolated Hermetic Package, JEDEC TO-257AA Outline • Reference Voltages Set To ±1% and ±2% • Built-In Thermal Overload Protection • Short Circuit Current Limiti |
|
|
|
|
ETC |
(OM3910xxx / OM3911xxx) POSITIVE ADJUSTABLE VOLTAGE REGULATOR APPROVED TO DESC DRAWING 5962-87675 • Approved To DESC Standardized Military Drawing 5962-8767501UX/TX and 5962-8767502UX/TX • Isolated Hermetic Package, JEDEC TO-257AA Outline • Reference Voltages Set To ±1% and ±2% • Built-In Thermal Overload Protection • Short Circuit Current Limiti |
|
|
|
|
ETC |
NEGATIVE ADJUSTABLE REGULATOR APPROVED TO DESC DRAWING 5962-87741 • • • • • • • • Similar To Industry Standard LT1033 Approved To DESC Standardized Military Drawing Number 5962-8774101 Adjustable Output Voltage Built In Thermal Overload Protection Short Circuit Current Limiting Maximum Output Voltage Tolerance is G |
|
|
|
|
ETC |
LOW DROPOUT 3.3 FIXED VOLTAGE REGULATOR APPROVED TO SMD 5962-98590 • • • • • • • Similar To Industry Standard LT1086 -3.3 Approved To DS C C Standardized Military Drawing Number 5962-98590 Built In Thermal Overload Protection Short Circuit Current Limiting Available In Isolated Package Output Voltage Tolerance is Gu |
|
|
|
|
STMicroelectronics |
ETC2732Q-3 |
|
|
|
|
ETC |
RS-232 to RS-485 Passive Converter |
|
|
|
|
STMicroelectronics |
16K BIT CMOS UV ERASABLE PROM |
|
|
|
|
STMicroelectronics |
POWER AMPLIFIER SERIAL INTERFACE CODEC/FILTERWITH RECEIVE an additional Receive Power Amplifier to provide push-pull balanced output drive capability. The receive gain can be adjusted by means of two external resistors for an output level of up to ± 6.6 V across a balanced 600Ω load. Also included is an Ana |
|
|
|
|
STMicroelectronics |
POWER AMPLIFIER SERIAL INTERFACE CODEC/FILTERWITH RECEIVE an additional Receive Power Amplifier to provide push-pull balanced output drive capability. The receive gain can be adjusted by means of two external resistors for an output level of up to ± 6.6 V across a balanced 600Ω load. Also included is an Ana |
|
Desde 2024. D4U Semiconductor.
|