| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
ETC |
High Performance Current Mode PWM Switching Power Supply Controller RS=1Ω 53 57 61 3.5 % % Vcc=8V 8.6 4.0 9.4 4.3 1.6 2.0 55 2.8 9.2 4.5 10 2.4 80 mA uA mA V V V :,,。 5 6 -CN-02 6 6 -CN-02 |
|
|
|
|
ETC |
Luminosity Sensor Hookup Guide that allow it to handle this huge dynamic range. These settings are similar to a camera; one can change both the sensitivity (which is like an ASA film rating), and the integration time, (which is like the shutter speed). Like a camera, you can balan |
|
|
|
|
Texas Instruments |
VDSL2 Line Driver Amplifiers •1 Low Power Consumption: – Full Bias Mode: 21 mA per Port – Mid Bias Mode: 16.2 mA per Port – Low Bias Mode: 11.2 mA per Port – Low-Power Shutdown Mode – IADJ Pin for Variable Bias • Low Noise: – Voltage Noise: 2.7 nV/√Hz – Inverting Current Noise: |
|
|
|
|
Texas Instruments |
VDSL2 Line Driver 1 •23 WIDEBAND +12V OPERATION: 420MHz (G = +5V/V) • HIGH OUTPUT CURRENT: 700mA • OUTPUT VOLTAGE SWING: 9.4VPP into 10Ω Single-Ended Load • HIGH DIFFERENTIAL SLEW RATE: 5000V/ms • LOW SUPPLY CURRENT: 30.5mA • FLEXIBLE POWER CONTROL APPLICATIONS • POWE |
|
|
|
|
Texas Instruments |
Dual-Port VDSL2 Line Driver •1 Digitally-Adjustable Quiescent Current: 9.4 mA to 24.8 mA • Bias Current Step: 1.0 mA • Independent Voltage Boost and Main Line Driver Disable • Low-Power Line Termination Mode • Full Capacitor Recharge: 200 µs • Low Input Voltage Noise Density: 6 |
|
|
|
|
ETC |
128 *1 LINEAR SENSOR ARRAY reading, optical character recognition (OCR) and contact imaging, edge detection and positioning as well as optical linear and rotary encoding. Functional Block Diagram (each section — pin numbers apply to section 1) Pixel 1 Integrator Reset Pixel |
|
|
|
|
ETC |
Low-power off-line switching power supply control chip 3.6V Vcc=4.6V，Fb=1.6V---2.8V Vcc=4.6V，Fb=1.6V---3.6V Vcc=4.6V，Fb=1.6V---3.6V AC 85V------265V 4 4.8 3.6 10 --460 700 600 650 50 0.05 0.8 120 5 1.6 5 5 4 20 --480 --660 720 65 --1 125 ---- 6 5.2 4.2 30 500 500 --700 800 70 65 1.2 130 75 3.6 V V V |
|
|
|
|
ETC |
Built-in high-voltage MOSFET current-mode PWM controller V Drain V GS ID V VCC PD Tj Ta m b Ts t g 650 ±20 0.5 1.0 2.0 4.0 25 -0.3 ~ 7.0 1.5 +160 -20 ~ +85 -55 ~ +150 V V A V V W ℃ ℃ ℃ SX-DOC-870X -3- REV:A Oct.2008 `Ìi`ÊÜÌ ÊÌ iÊ`iÊÛiÀÃÊvÊ vÝÊ*ÀÊ* Ê `ÌÀÊ /ÊÀ iÛiÊÌ ÃÊÌVi]ÊÛÃÌ |
|
|
|
|
ETC |
Built-in high-voltage MOSFET current-mode PWM controller V Drain V GS ID V VCC PD Tj Ta m b Ts t g 650 ±20 0.5 1.0 2.0 4.0 25 -0.3 ~ 7.0 1.5 +160 -20 ~ +85 -55 ~ +150 V V A V V W ℃ ℃ ℃ SX-DOC-870X -3- REV:A Oct.2008 `Ìi`ÊÜÌ ÊÌ iÊ`iÊÛiÀÃÊvÊ vÝÊ*ÀÊ* Ê `ÌÀÊ /ÊÀ iÛiÊÌ ÃÊÌVi]ÊÛÃÌ |
|
|
|
|
Texas Instruments |
Differential VDSL2 Line Driver Amplifiers 1 •23 Low Power Consumption: – 21mA/Port Full Bias Mode – 16.2mA/Port Mid Bias Mode – 11.2mA/Port Low Bias Mode – Low-Power Shutdown Mode – IADJ Pin for Variable Bias • Low Noise: – 2.5nV/√Hz Voltage Noise – 17pA/√Hz Inverting Current Noise – 1.2pA/√ |
|
|
|
|
Texas Instruments |
Dual-Port VDSL2 Line Driver 1 •23 Digitally-Adjustable Quiescent Current: 7.6mA to 23.0mA • 1.0mA Bias Current Step • Independent Voltage Boost and Main Line Driver Disable • Low-Power Line Termination Mode • Full Capacitor Recharge: 3ms • Low Input Voltage Noise Density: 6.3 n |
|
Desde 2024. D4U Semiconductor.
|