| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Texas Instruments |
Industrial Piezo Driver •1 100-V Boost or 1-kV Flyback Configuration • ±100-V Piezo Driver in Boost + Amplifier Configuration – 4 GPIO-Adjustable Gains – Differential or Single-Ended Output – Low-Voltage Control – AC and DC Output Control • 0 to 1-kV Piezo Driver in Flyback |
|
|
|
|
Texas Instruments |
Piezo Haptic Driver •1 Integrated Digital Front End – Up to 400-kHz I2C Bus Control – 100-Byte Internal FIFO Interface – Immersion TS5000-Compliant – Optional Analog Inputs • High Voltage Piezo-Haptic Driver – Drives up to 100 nF at 200 VPP and 300 Hz – Drives up to 150 |
|
|
|
|
Texas Instruments |
Piezo Haptic Driver •1 Integrated Digital Front End – Up to 400-kHz I2C Bus Control – Advanced Waveform Synthesizer – 2-kB Internal Waveform Memory – 100-Byte Internal FIFO Interface – Immersion TS5000-Compliant – Optional Analog Inputs • High-Voltage Piezo-Haptic Drive |
|
|
|
|
ETC |
Snap-in Insulated / Metal Shaft Series |
|
|
|
|
ETC |
Snap-in Insulated / Metal Shaft Series |
|
|
|
|
ETC |
Snap-in Insulated / Metal Shaft Series |
|
|
|
|
Texas Instruments |
Haptic Driver •1 Flexible Haptic and Vibration Driver – LRA (Linear Resonance Actuator) – ERM (Eccentric Rotating Mass) • I2C-Controlled Digital Playback Engine – Waveform Sequencer and Trigger – Real-Time Playback Mode through I2C – I2C Dual-Mode Drive (Open and |
|
|
|
|
Texas Instruments |
Haptic Driver •1 Flexible Haptic/Vibra Driver – LRA (Linear Resonance Actuator) – ERM (Eccentric Rotating Mass) • I2C Controlled Digital Playback Engine – Real-Time Playback Mode via I2C • Smart Loop Architecture(1) – Automatic Overdrive/Braking (ERM/LRA) – Automa |
|
|
|
|
Texas Instruments |
8-A Automotive Haptic Drivers •1 AEC-Q100 Qualified for automotive applications: – Temperature grade 1: –40°C to 125°C, TA – Device HBM ESD classification level H2 – Device CDM ESD classification level C3 • Wide operating voltage (4.5 V - 18 V) • Capable of handling voltage of 30 |
|
|
|
|
Texas Instruments |
3-A Automotive Haptic Driver •1 AEC-Q100 Qualified for automotive applications: – Temperature grade 1: –40°C to 125°C, TA • Wide operating voltage (4.5 V - 18 V) • Integrated load-dump protection (40 V) • High current drive (3 A Peak) • Low RDS(on), full H-bridge output • Integr |
|
|
|
|
Texas Instruments |
Voice Coil Motor Driver •1 Configurable for Linear or PWM Mode VCM Current Generation • High Efficiency PWM Current Control for VCM • Advanced Ringing Compensation • Integrated 10-bit D/A Converter for VCM Current Control • Protection – Open and Short-Circuit Detection – Un |
|
|
|
|
Texas Instruments |
Voice Coil Motor Driver •1 Configurable for Linear or PWM Mode VCM Current Generation • High Efficiency PWM Current Control for VCM • Advanced Ringing Compensation • Integrated 10-bit D/A Converter for VCM Current Control • Protection – Open and Short-Circuit Detection on V |
|
|
|
|
ETC |
Snap-in Insulated / Metal Shaft Series |
|
|
|
|
ETC |
Snap-in Insulated / Metal Shaft Series |
|
|
|
|
ETC |
Snap-in Insulated / Metal Shaft Series |
|
|
|
|
ETC |
Snap-in Insulated / Metal Shaft Series |
|
|
|
|
ETC |
Snap-in Insulated / Metal Shaft Series |
|
|
|
|
Texas Instruments |
Ultra Low Power Closed-Loop LRA/ERM Haptic Driver •1 Ultra Low-Power Shutdown Mode • Low-Power Standby State • Resistance-Based Actuator Diagnostics • SimpleDrive One-Wire Vibration Scheme • Automatic Resonance Tracking and Reporting • Automatic Overdrive and Braking • Automatic Level Calibration • |
|
|
|
|
Texas Instruments |
Ultra Low Power Closed-Loop LRA/ERM Haptic Driver •1 Ultra Low-Power Shutdown Mode • Low-Power Standby State • Resistance-Based Actuator Diagnostics • SimpleDrive One-Wire Vibration Scheme • Automatic Resonance Tracking and Reporting • Automatic Overdrive and Braking • Automatic Level Calibration • |
|
|
|
|
Texas Instruments |
Haptic Driver •1 Flexible Haptic and Vibration Driver – LRA (Linear Resonance Actuator) – ERM (Eccentric Rotating Mass) • I2C-Controlled Digital Playback Engine – Waveform Sequencer and Trigger – Real-Time Playback Mode through I2C – Internal RAM for Customized Wa |
|
Desde 2024. D4U Semiconductor.
|