| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
ETC |
Current Mode PWM Power Converter |
|
|
|
|
Texas Instruments |
1- to 4-Cell Hybrid Power Boost Mode Battery Charge Controller •1 Industrial Innovative Charge Controller With Hybrid Power Boost Mode – Adapter and Battery Provides Power to System Together for Intel® CPU Turbo Mode – Ultra-Fast Transient Response of 150 µs to Enter Boost Mode – Hybrid Power Boost Mode from 4.5 |
|
|
|
|
ETC |
CurrentMode PWM Controller • Low Start-Up and Operating Current • High Current Totem Pole Output • Undervoltage Lockout With Hysteresis • Operating Frequency Up To 300KHz (384XA) 500KHz (384XAM) BLOCK DIAGRAM (toggle flip flop used only in UC3844, UC3845) PIN CONNECTION (TO |
|
|
|
|
ETC |
Laser module disipación Longitud de Onda Corriente Rango de Temperatura Dimensiones 5V 5mW 650nm 40mA -10°C ~ 40°C [14°F to 104°F] 18.5mm x 15mm [0.728in x 0.591in] 3.0 Materiales 1 Arduino uno 1 Cable AB 1 Modulo sensor Laser KY-008 3 Cables ma |
|
|
|
|
ETC |
CurrentMode PWM Controller • Low Start-Up and Operating Current • High Current Totem Pole Output • Undervoltage Lockout With Hysteresis • Operating Frequency Up To 300KHz (384XA) 500KHz (384XAM) BLOCK DIAGRAM (toggle flip flop used only in UC3844, UC3845) PIN CONNECTION (TO |
|
|
|
|
ETC |
CurrentMode PWM Controller • Low Start-Up and Operating Current • High Current Totem Pole Output • Undervoltage Lockout With Hysteresis • Operating Frequency Up To 300KHz (384XA) 500KHz (384XAM) BLOCK DIAGRAM (toggle flip flop used only in UC3844, UC3845) PIN CONNECTION (TO |
|
|
|
|
ETC |
Infrared Receiver Module |
|
|
|
|
ETC |
Current Mode PWM Power Converter |
|
|
|
|
ETC |
Current Mode PWM Power Converter |
|
|
|
|
Texas Instruments |
Pulse-Width-Modulation Controller •1 Complete PWM Power-Control Circuitry • Uncommitted Outputs for 200-mA Sink or Source Current • Output Control Selects Single-Ended or Push-Pull Operation • Internal Circuitry Prohibits Double Pulse at Either Output • Variable Dead Time Provides Co |
|
|
|
|
ETC |
Green Energy Saving Current Mode PWM Power Converter |
|
|
|
|
ETC |
Current Mode PWM Controller ■ Extended Burst Mode Control For Improved ■Efficiency and Minimum Standby Power Design loss. Lower standby power and higher conversion ■Audio Noise Free Operation efficiency is thus achieved. VDD low startup current and ■External Programmable PWM |
|
|
|
|
ETC |
10/100BASE-Tx Magnetics Module |
|
|
|
|
ETC |
LCD Module •Display construction…………… 240*128 DOTS •Display mode ……………………… STN OR FSTN( Y/G) •Display type ……………………… Positive Transflective •Backlight…………………………… W/G/B/5.0V •Viewing direction………………… 6 o’clock •Operating temperature…………… Indoor •Driving voltage… |
|
|
|
|
ETC |
LCD Display Module . Display construction . Display mode . Display color . Viewing direction . Operating Power . Type . MCU I/F . Backlight - 128 * 64 Dots - STN - Yellow Green / Blue - 6 o’ clock - VCC 5V - COB (Chip On Board) - 8-bit parallel or serial - LED 2. Rea |
|
|
|
|
Texas Instruments |
Low-Power Current-Mode Push-Pull PWM •1 Dual-Output Drive Stages in Push-Pull Configuration • Current-Sense Discharge Transistor to Improve Dynamic Response • 130-μA Typical Starting Current • 1-mA Typical Run Current • Operation to 1 MHz • Internal Soft Start • On-Chip Error Amplifier |
|
|
|
|
ETC |
Analog Output Module S S 4 outputs in 4 channel groups 12 bits has the following characteristic The individual output channels can be programmed as – Voltage outputs – Current outputs S S S S S Resolution 12 bits Programmable diagnostics Programmable diagnostic inte |
|
|
|
|
ETC |
High Performance Current Mode PWM Switching Power Supply Controller RS=1Ω 53 57 61 3.5 % % Vcc=8V 8.6 4.0 9.4 4.3 1.6 2.0 55 2.8 9.2 4.5 10 2.4 80 mA uA mA V V V :,,。 5 6 -CN-02 6 6 -CN-02 |
|
|
|
|
Texas Instruments |
BiCMOS Low-Power Current-Mode PWM Controller • Enhanced replacement for UCx84x and UCx84xA family with pin-to-pin compatibility • Operating frequency: 1MHz Maximum • 50μA Startup Current, 100μA Maximum • Low operating current: 2.3mA (at fOSC = 52kHz) • Fast, cycle-by-cycle overcurrent limiting: |
|
|
|
|
Texas Instruments |
8-Pin Current Mode Push-Pull PWM Controllers D Programmable Slope Compensation D Internal Soft-Start on the UCC38083/4 D Cycle-by-Cycle Current Limiting D Low Start-Up Current of 120 µA and 1.5 mA Typical Run Current D Single External Component Oscillator Programmable from 50 kHz to 1 MHz D Hig |
|
Desde 2024. D4U Semiconductor.
|