No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
ETC |
USB bus convert 2.1.Introduction ● Full speed USB device interface, conforms to USB Specification Version 2.0, only needs crystal and capacitance external. ● Optional: define Vender ID, production ID and list number through external low-cost serial EEPROM. ● Support |
|
|
|
ETC |
High capacitance Code K P P Prduct thickness 0.85mm 2.3mm 2.5mm Packing specification Y5V Characteristic 16V 0.2 47,000,000 20% K P External dimensions (Unit : mm) 0.2Min. 1.0Min. Production designation T Product thickness(mm) 2.0 0.2 2.3 0.2 2.5 0.3 Reel Basic |
|
|
|
ETC |
Triode - Hexode |
|
|
|
ETC |
USB Bus Interface Chip ● Full-speed USB-HOST interface, conforms to USB Specification Version 2.0, only needs crystal and capacitance external. ● Full-speed USB device interface, compatible with CH372, supports exchanging USB-HOST mode and USB-DEVICE/SLAVE mode dynamically |
|
|
|
ETC |
USB to serial chip l Full-speed USB device interface, USB 2.0 compatible. l Emulate standard UART interface, used to upgrade the original serial peripheral or expand additional UART via USB. l Original UART applications are totally compatible without any modification i |
|
|
|
ETC |
file manage control chip ● Supports 1.5Mbps low-speed and 12Mbps full-speed, compatible with USB V2.0, only needs crystal and http://www.Datasheet4U.com The DataSheet of CH376 (the first) 2 capacitance external. ● USB-HOST Mode and USB-DEVICE Mode, automatically switch H |
|
|
|
ETC |
USB bus converter |
|
|
|
ETC |
USB signal isolation controller ● supports 12Mbps full-speed and 1.5Mbps low-speed USB transfer, compatible with USB 2.0. ● supports USB control transfer, bulk transfer, interrupt transfer, synchronous/isochronous transfer. The DataSheet of CH315 (the first) 2 ● automatically de |
|
|
|
Texas Instruments |
32-BIT DUAL-SUPPLY BUS TRANSCEIVER − If Either VCC Input Is at GND, Both Ports Are in the High-Impedance State D Overvoltage-Tolerant Inputs/Outputs Allow Mixed-Voltage-Mode Data Communications D Fully Configurable Dual-Rail Design Allows Each Port to Operate Over the Full 1.2-V to 3. |
|
|
|
ETC |
USB bus interface ● Supports low-speed of 1.5Mbps and full-speed of 12Mbps, conforms to USB Specification Version 2.0, only needs crystal and capacitor as peripherals. ● Supports USB host interface and USB device interface, and supports exchanging USB-HOST and USB-DEV |
|
|
|
ETCTI |
32-BIT BUFFER/DRIVER (Rev. D) |
|
|
|
ETCTI |
32-BIT BUS TRANSCEIVER (Rev. D) |
|
|
|
ETCTI |
32-BIT EDGE-TRIGGERED D-TYPE FLIP-FLOP (Rev. D) |
|
|
|
ETCTI |
36-BIT UNIVERSAL BUS TRANSCEIVER (Rev. G) |
|
|
|
ETCTI |
16-BIT BUS TRANSCEIVER AND TRANSPARENT D-TYPE LATCH (Rev. C) |
|
|
|
ETCTI |
OCTAL TRANSPARENT D-TYPE LATCH (Rev. H) |
|
|
|
ETCTI |
OCTAL POSITIVE EDGE-TRIGGERED D-TYPE FLIP-FLOP (Rev. G) |
|
|
|
ETC |
3axis mach3 cnc Stepper Motor Controller operation instruction of ST6560-T3...................................................................................................................3 Ⅱ、Applications: ......................................................................................................... |
|
|
|
ETC |
USB extension controller ● supports 12Mbps full-speed and 1.5Mbps low-speed USB transfer, compatible with USB 2.0. ● supports USB control transfer, bulk transfer, interrupt transfer, synchronous/isochronous transfer. The DataSheet of CH315 (the first) 2 ● automatically de |
|
|
|
Texas Instruments |
32-BIT EDGE-TRIGGERED D-TYPE FLIP-FLOP ng registers. It can be used as four 8-bit flip-flops, two 16-bit flip-flops, or one 32-bit flip-flop. On the positive transition of the clock (CLK) input, the Q outputs of the flip-flop take on the logic levels set up at the data (D) inputs. A buffe |
|