| No. | parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
|
|
|
Texas Instruments |
Ultra-HD Analog-Input Class-D Amplifier •1 Differential Analog Inputs • Total Output Power at 10%THD+N – 175-W Stereo into 4 Ω in BTL Configuration – 220-W Stereo into 3 Ω in BTL Configuration – 350-W Mono into 2 Ω in PBTL Configuration • Total Output Power at 1%THD+N – 140-W Stereo into 4 |
|
|
|
|
ETC |
DUAL TRANSISTOR |
|
|
|
|
Texas Instruments |
Low-Power SoC The small 6x6 mm package makes it very suited for applications with size limitations. The CC2510Fx/CC2511Fx is highly suited for systems where very low power consumption is required. This is ensured by several advanced low-power operating modes. The |
|
|
|
|
Texas Instruments |
CAN TRANSCEIVER • Qualified for Automotive Applications • Drop-In Improved Replacement for the PCA82C250 and PCA82C251 • Bus-Fault Protection of ±36 V • Meets or Exceeds ISO 11898 • Signaling Rates(1) up to 1 Mbps • High Input Impedance Allows up to 120 SN65HVD251 N |
|
|
|
|
ETC |
Chip Beads |
|
|
|
|
Texas Instruments |
Small 8-Channel 12-Bit ADC •1 Small package size: – WQFN 3 mm × 3 mm • 8 channels configurable as any combination of: – Up to 8 analog inputs, digital inputs, or digital outputs • GPIOs for I/O expansion: – Open-drain, push-pull digital outputs • Wide operating ranges: – AVDD: |
|
|
|
|
Texas Instruments |
8-Input Multiplexer • Selects one of eight binary data inputs • Three-state output capability • True and complement outputs • Typical (data to output) propagation delay of 14 ns at VCC = 5 V, CL = 15 pF, TA = 25 ℃ • Fanout (over temperature range) – Standard outputs : 1 |
|
|
|
|
Texas Instruments |
3.3-V PHASE-LOCK LOOP CLOCK DRIVER 1 • Designed to Meet and Exceed PC133 SDRAM Registered DIMM Specification Rev. 1.1 • Spread Spectrum Clock Compatible • Operating Frequency 20 MHz to 175 MHz • Static Phase Error Distribution at 66 MHz to 166 MHz is ±125 ps • Jitter (cyc –cyc) at 66 M |
|
|
|
|
ETC |
Multilayer Chip Beads |
|
|
|
|
ETC |
SAA1251 ezpośrednieqo): stan wysoki -UIH £ stan niski Napięcie sygnału wejściowego (wejście IR) -UlL ULR 16/1 Napięcie wyjściowe (wyjście requlacyjne) stan wysoki przy -lo = 1 mA -U0H 4 0,5 0,8 [V] rvi [V] 0 , 6 rvi Częstotliwość syqnału wyjścioweqo |
|
|
|
|
ETC |
Chip Beads |
|
|
|
|
ETC |
General Purpose High Current NPN Transistor Arrays |
|
|
|
|
Texas Instruments |
PROGRAMMABLE LOW-POWER OPERATIONAL AMPLIFIERS operation down to a 1.4-V supply and is stable at unity gain. These devices have internal electrostatic-discharge (ESD) protection circuits that prevent catastrophic failures at voltages up to 2000 V as tested under MIL-STD-883C, Method 3015.1. Howe |
|
|
|
|
Texas Instruments |
Wide Input Range Synchronous Buck Controller •1 LM25117-Q1 is Qualified for Automotive Applications • AEC-Q100 Qualified With the Following Results: – Device Temperature Grade 1: -40°C to 125°C Ambient Operating Temperature Range • Emulated Peak Current Mode Control • Wide Operating Range from |
|
|
|
|
Texas Instruments |
Half-Bridge Gate Drivers •1 Independent High and Low Driver Logic Inputs • Bootstrap Supply Voltage up to 100-V DC • Drives Both a High-Side and Low-Side N-Channel MOSFETs • Fast Propagation Times (25 ns Typical) • Drives 1000-pF Load With 8-ns Rise and Fall Times • Excellen |
|
|
|
|
Texas Instruments |
8-Input Multiplexer • Selects one of eight binary data inputs • Three-state output capability • True and complement outputs • Typical (data to output) propagation delay of 14 ns at VCC = 5 V, CL = 15 pF, TA = 25 ℃ • Fanout (over temperature range) – Standard outputs : 1 |
|
|
|
|
Texas Instruments |
1-Cell 500-mA Linear Battery Charger •1 Linear battery charger with 1.25-mA to 500-mA fast charge current range – 0.5% Accurate I2C programmable battery regulation voltage ranging from 3.6 V to 4.6 V in 10-mV steps – Configurable termination current supporting down to 0.5 mA – 20-V Tole |
|
|
|
|
Texas Instruments |
PSR Flyback DC/DC Converter • Functional Safety-Capable – Documentation available to aid functional safety system design • Designed for reliable and rugged applications – Wide input voltage range of 4.5 V to 42 V with operation down to 3.5 V after start-up – Robust solution wit |
|
|
|
|
Texas Instruments |
Data Selectors/Multiplexers • 3-state version of ’HC151 • Wide operating voltage range of 2 V to 6 V • High-current 3-state outputs interface directly with system bus or can drive up to 15 LSTTL loads • Low power consumption, 80-μA max ICC • Typical tpd = 9 ns • ±6-mA output dr |
|
|
|
|
ETC |
Multilayer Chip Beads |
|
Desde 2024. D4U Semiconductor.
|