CT Micro CT1 Hoja de datos

No.	parte #	Fabricante	Descripción
1	M54HCT126	ST Microelectronics	QUAD BUS BUFFERS 3-STATE interface HSC2MOS systems with TTL and NMOS components. They are also plug in replacements for LSTTL devices giving a reduction of power consumption. All inputs are equipped with protection circuits against static discharge and transient excess volt
2	CT1013	CT Micro	Phototransistor Optocoupler • High isolation 5000 VRMS • CTR flexibility available see order information • Extra low coupling capacitance • DC input with transistor output • Temperature range - 55 °C to 110 °C • Regulatory Approvals  UL - UL1577 (E364000)  VDE - EN60747-5-5(V
3	CT1112-W	CT Micro	DC Input 5-Pin Long Mini-Flat Phototransistor Optocoupler CT1110-W, CT1111-W, CT1112-W, CT1113-W, CT1114-W CT1115-W, CT1116-W, CT1117-W, CT1118-W, CT1119-W DC Input 5-Pin Long Mini-Flat Phototransistor Optocoupler Applications  High isolation 5000 VRMS  CTR flexibility available see order information 
4	CT1117-W	CT Micro	DC Input 5-Pin Long Mini-Flat Phototransistor Optocoupler CT1110-W, CT1111-W, CT1112-W, CT1113-W, CT1114-W CT1115-W, CT1116-W, CT1117-W, CT1118-W, CT1119-W DC Input 5-Pin Long Mini-Flat Phototransistor Optocoupler Applications  High isolation 5000 VRMS  CTR flexibility available see order information 
5	CT1115-W	CT Micro	DC Input 5-Pin Long Mini-Flat Phototransistor Optocoupler CT1110-W, CT1111-W, CT1112-W, CT1113-W, CT1114-W CT1115-W, CT1116-W, CT1117-W, CT1118-W, CT1119-W DC Input 5-Pin Long Mini-Flat Phototransistor Optocoupler Applications  High isolation 5000 VRMS  CTR flexibility available see order information 
6	M54HCT137	ST Microelectronics	3 TO 8 LINE DECODER/LATCH INVERTING control the state of the outputs independently ofthe select orlatch-enable inputs. All theoutputs are high unless G1 is high and G2 is low. The HC137 is ideally suited for the implementation of glitch-free decoders in stored-address applications in b
7	74VHCT126A	STMicroelectronics	QUAD BUS BUFFERS n inputs with no regard to the supply voltage. This device can be used to interface 5V to 3V. All inputs and outputs are equipped with protection circuits against static discharge, giving them 2KV ESD immunity and transient excess voltage. PIN CONNE
8	74ACT138	STMicroelectronics	3 TO 8 LINE DECODER INVERTING s TTL-compatible inputs s A Ports have standard 4 mA totem pole outputs s Typical input hysteresis of 0.5V s B Port high drive source/sink capability of 14 mA s Bidirectional non-inverting buffers s Supports IEEE P1284 Level 1 and Level 2 signaling s
9	74ACT157	STMicroelectronics	QUAD 2 CHANNEL MULTIPLEXER d High selection of data is inhibit and all the outputs become low. The SELECT decoding determines whether the A or B inputs get routed to their corresponding Y outputs. The device is designed to interface directly High Speed CMOS systems with TTL, N
10	74ACT161	STMicroelectronics	SYNCHRONOUS PRESETTABLE 4-BIT COUNTER
11	M54HCT165	ST Microelectronics	8 BIT PISO SHIFT REGISTER entrens when the shift/load input is low. The parallel data can change while shift/load is low, provided that the recommended set-up and hold times are observed. For clocked operation, shift/load must be high. The two clock input perform identically;
12	M74HCT163	ST Microelectronics	SYNCHRONOUS PRESETTABLE 4-BIT COUNTER 161/163 are 4 bit binary counters. The CLOCK input is active on the rising edge. Both LOAD and CLEAR inputs are active Low. Presetting of all four IC’s is synchronous on the rising edge of the CLOCK. The function on the M54/74HCT162/163 is synchronou
13	74VHCT16245A	ST Microelectronics	16-BIT BUS TRANSCEIVER ectively isolated. All inputs and outputs are equipped with protection circuits against static discharge, giving them 2KV ESD immunity and transient excess voltage. All floating bus terminals during High Z State must be held HIGH or LOW. December 20
14	CT1019	CT Micro	Phototransistor Optocoupler • High isolation 5000 VRMS • CTR flexibility available see order information • Extra low coupling capacitance • DC input with transistor output • Temperature range - 55 °C to 110 °C • Regulatory Approvals  UL - UL1577 (E364000)  VDE - EN60747-5-5(V
15	CT1114-W	CT Micro	DC Input 5-Pin Long Mini-Flat Phototransistor Optocoupler CT1110-W, CT1111-W, CT1112-W, CT1113-W, CT1114-W CT1115-W, CT1116-W, CT1117-W, CT1118-W, CT1119-W DC Input 5-Pin Long Mini-Flat Phototransistor Optocoupler Applications  High isolation 5000 VRMS  CTR flexibility available see order information 
16	74VHCT14A	STMicroelectronics	HEX SCHMITT INVERTER ■ High speed: tPD = 5.5ns (typ.) at VCC = 5V ■ Low power dissipation: ICC = 2 µA (Max.) at TA = 25°C ■ Typical hysteresis: Vh = 0.7V at VCC = 4.5V ■ Power down protection on inputs & outputs ■ Symmetrical output impedance: \|IOH\| = IOL = 8 mA (Min) ■
17	74ACT10	STMicroelectronics	TRIPLE 3-INPUT NAND GATE s ICC reduced by 50% on 74AC only s Outputs source/sink 24 mA Ordering Code: Order Number 74AC08SC 74AC08SJ 74AC08MTC 74AC08PC 74ACT08SC 74ACT08MTC 74ACT08PC Package Number M14A M14D MTC14 N14A M14A MTC14 N14A Package Description 14-Lead Small Outli
18	74ACT158	STMicroelectronics	QUAD 2 CHANNEL MULTIPLEXER
19	M54HCT162	ST Microelectronics	SYNCHRONOUS PRESETTABLE 4-BIT COUNTER 161/163 are 4 bit binary counters. The CLOCK input is active on the rising edge. Both LOAD and CLEAR inputs are active Low. Presetting of all four IC’s is synchronous on the rising edge of the CLOCK. The function on the M54/74HCT162/163 is synchronou
20	M74HCT137	ST Microelectronics	3 TO 8 LINE DECODER/LATCH INVERTING control the state of the outputs independently ofthe select orlatch-enable inputs. All theoutputs are high unless G1 is high and G2 is low. The HC137 is ideally suited for the implementation of glitch-free decoders in stored-address applications in b