No. | parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
|
|
BCD Semiconductor |
RF ULDO REGULATOR an undervoltage monitor with an error flag output, logic compatible enable/shutdown control inputs, a low power shutdown mode for extended battery life, over current protection, over temperature protection as well as reversed-battery protection. The |
|
|
|
BCD |
EXTREMELY LOW NOISE CMOS LDO REGULATOR AP2129 The AP2129 is a 300mA, positive Voltage regulator ICs fabricated by CMOS process. The AP2129 provides two kinds of output voltage operation modes for setting the output voltage. Fixed output voltage mode senses the output voltage on VOUT, ad |
|
|
|
BCD Semiconductor |
2A DDR TERMINATION REGULATOR · · · · · Support Both DDR I (1.25VTT) and DDR II (0.9VTT) Requirements Source and Sink Current up to 2A High Accuracy Output Voltage at Full-load Adjustable VOUT by External Resistors Shutdown for Standby or Suspend Mode Operation with High-impedanc |
|
|
|
BCD |
ULTRA LOW QUIESCENT CURRENT CMOS LDO Data Sheet AP2138/2139 The AP2138/2139 series are CMOS-based positive voltage regulator ICs. Each of these ICs consists of a voltage reference, an error amplifier, a resistor network for setting output voltage and a current limit circuit for curren |
|
|
|
BCD |
300mA HIGH SPEED EXTREMELY LOW NOISE CMOS LDO REGULATOR AP2125 The AP2125 series are 300mA, positive voltage regulator ICs fabricated by CMOS process. Each of these ICs is equipped with a voltage reference, an error amplifier, a resistor network for setting output voltage, a chip enable circuit, a curre |
|
|
|
BCD |
EXTREMELY LOW NOISE LDO REGULATOR Data Sheet AP2121 The AP2121 series are positive voltage regulator ICs fabricated by CMOS process. Each of these ICs consists of a voltage reference, an error amplifier, a resistor network for setting output voltage, a current limit circuit for cur |
|
|
|
BCD |
Ultra Low Output Voltage Linear N-FET Controller enable control, open drain power good signal, under-voltage protection and soft start. The AP2160 is available in 6-pin SOT-23-6 standard package. Features • 0.5V Reference Voltage with 1% Accuracy • Adjustable Output Voltage down to 0.5V • Low ESR |
|
|
|
BCD Semiconductor |
LOW DROPOUT LINEAR REGULATOR · · · · · · · Minimum Guaranteed Output Current: 1A Dropout Voltage at IOUT=1A: 300mV Output Accuracy: ± 1% Low Ground Current Internal Current Limit and Thermal Protection Reversed-battery and Reversed-lead Insertion Protection Fast Transient Respon |
|
|
|
BCD Semiconductor |
3A DDR TERMINATION REGULATOR · · · · · Support Both DDR I (1.25VTT) and DDR II (0.9VTT) Requirements Source and Sink Current up to 3A High Accuracy Output Voltage at Full-load Adjustable VOUT by External Resistors Shutdown for Standby or Suspend Operation with High-impedance Out |
|
|
|
BCD |
EXTREMELY LOW NOISE CMOS LDO REGULATOR AP2128 The AP2128 series are positive voltage regulator ICs · Wide Operating Voltage: 2.5V to 6V fabricated by CMOS process. The AP2128 provides · Low Dropout Voltage:170mV@300mA for two kinds of output voltage operation modes for setting the out |
|
|
|
BCD |
600mA CMOS LDO REGULATOR low power consumption, and provides SOT-23-5, SOT-89-5, and SOIC-8 packages. Features • Output Voltage Accuracy: ±1.5% • Output Current: 600mA (Min.) • Foldback Short Current Protection: 50mA • Enable Function to Turn ON/OFF VOUT • Low Dropout Volta |
|
|
|
BCD Semiconductor |
LOW NOISE LDO REGULATOR individual logic compatible enable/shutdown control inputs, a low power shutdown mode for extended battery life, over current protection, over temperature protection, as well as reversed-battery protection. The AP2213 has 2.5V, 3.0V and 3.3V versions |
|
|
|
BCD Semiconductor |
RF ULDO REGULATOR Data Sheet AP2202 The AP2202 is a 150mA ULDO regulator which provides very low noise, ultra low dropout voltage (typically 165mV at 150mA), very low standby current (1µA maximum) and excellent power supply ripple rejection (PSRR 75dB at 100Hz) in b |
|
|
|
BCD Semiconductor |
1.5A DDR TERMINATION REGULATOR · · · · · Support Both DDR I (1.25VTT) and DDR II (0.9VTT) Requirements Source and Sink Current up to 1.5A High Accuracy Output Voltage at Full-load Adjustable VOUT by External Resistors Shutdown for Standby or Suspend Mode Operation with High-impeda |
|
|
|
BCD Semiconductor |
LOW DROPOUT LINEAR REGULATOR · · · · · · · · Low Dropout Voltage: 1.1V at 600mA Output Current Output Noise from 10Hz to 10KHz: 0.003% of VOUT PSRR at IOUT=300mA and f=120Hz: 75dB Output Voltage Accuracy: ± 1% On-chip Thermal Shutdown Maximum Quiescent Current: IQMAX=5mA ESD (Hu |
|
|
|
BCD |
EXTREMELY LOW NOISE CMOS LDO REGULATOR of high ripple rejection, low dropout voltage, low noise, high output voltage accuracy, and low current consumption which make it ideal for use in various battery-powered apparatus. AP2126 has 3.3V fixed voltage version. It is available in SOT-23-5 P |
|
|
|
BCD |
EXTREMELY LOW NOISE CMOS LDO REGULATOR of low dropout voltage, low noise, high output voltage accuracy, and low current consumption which make them ideal for use in various battery-powered devices. AP2127 has 1.0V, 1.2V, 1.5V, 1.8V, 2.5V, 2.8V, 3.0V, 3.3V, 4.2V, 4.75V, 5.2V fixed voltage |
|
|
|
BCD Semiconductor |
DUAL 300mA LDO REGULATORS · · · · · · · · Minimum Output Current Capability per Channel: 300mA High Output Voltage Accuracy: ±2% Low Quiescent Current per Channel: 50µA Typical Low Standby Current: 0.1µA Typical High PSRR: 70dB Typical (f=1kHz) Extremely Low Noise: 30µVrms (1 |
|
|
|
BCD |
600mA CMOS LDO REGULATOR low power consumption. The AP2111 is available in SOIC-8, PSOP-8 SOT-223 and SOT-23-5 packages. Features • Output Voltage Accuracy: ±1.5% • Output Current: 600mA (Min) • Foldback Short Current Protection: 50mA • Enable Function to Turn On/Off VOUT • |
|
|
|
BCD |
1.6x Linear DC Fan Driver • Output Voltage in Adjustable Mode Follows 1.6 Times of VSET (VOUT/VSET=1.6±3%) • Low Quiescent Current: 70µA (Typ) • Guarantee 0.6A Continuous Load • Switchable Adjustable Mode/Full Speed Mode • Over Current Protection • Short Current Protection wi |
|