logo

Analog Devices ADP DataSheet

No. parte # Fabricante Descripción Hoja de Datos
1
ADP2114

Analog Devices
Synchronous Step-Down DC-to-DC Regulator
Configurable 2 A/2 A or 3 A/1 A dual output load combinations or 4 A combined single output High efficiency: up to 95% Input voltage VIN: 2.75 V to 5.5 V Selectable fixed output: 0.8 V, 1.2 V, 1.5 V, 1.8 V, 2.5 V, 3.3 V or adjustable output voltage t
Datasheet
2
ADP2127

Analog Devices
DC-to-DC Converters
1.20 V and 1.26 V fixed output voltage options Clock signal enable Logic signal enable also available on certain models 6 MHz operating frequency Spread spectrum frequency modulation to reduce EMI 500 mA continuous output current Input voltage: 2.1 V
Datasheet
3
ADP2147

Analog Devices
Buck Regulator
Input voltage: 2.3 V to 5.5 V Peak efficiency: 95% 3 MHz fixed frequency operation Low quiescent current: 23 μA Ultralow shutdown current: 0.2 μA (typical) VSEL pin for simple dynamic voltage scaling (DVS) 100% duty cycle low dropout mode Internal sy
Datasheet
4
ADP2450

Analog Devices
Power Management
Boost shunt controller Adjustable output voltage range: 4.5 V to 36 V Integrated boost shunt driver Programmable power detection threshold Buck regulator Input voltage range: 4.5 V to 36 V Continuous output current: 500 mA Adjustable output voltage d
Datasheet
5
ADP1147-5

Analog Devices
Step-Down Switching Regulator Controllers
Greater Than 95% Efficiency Current Mode Switching Architecture Provides Superior Load and Line Transient Response Wide Input Voltage Range 3.5 V* to 16 V User Defined Current Limit Short Circuit Protection Shutdown Pin Low Dropout Voltage Low Standb
Datasheet
6
ADP1762

Analog Devices
CMOS Linear Regulator
2 A maximum output current Low input voltage supply range VIN = 1.10 V to 1.98 V, no external bias supply required Fixed output voltage range: VOUT_FIXED = 0.9 V to 1.5 V Adjustable output voltage range: VOUT_ADJ = 0.5 V to 1.5 V Ultralow noise: 2 μV
Datasheet
7
ADPD2211

Analog Devices
High Sensitivity Optical Sensor
Ultrahigh detectivity photodetector 90 fA/√Hz (typical) ultralow noise floor Signal-to-noise ratio (SNR) near shot noise limit 137 µA (typical) of supply current when active (EE = 0 µW/cm2) 1 µA (typical) of supply current in standby High speed, deep
Datasheet
8
ADP5587

Analog Devices
Mobile I/O Expander And QWERTY Keypad Controller
18-GPIO port expander or 10 × 8 keypad matrix GPIOs configurable as GPIs, GPOs, and keypad rows or columns I2C interface with auto-increment 1.65 V to 3.6 V operation Keypad lock capability Open-drain interrupt output Key press and key release interr
Datasheet
9
ADP5051

Analog Devices
Integrated Power Solution
Wide input voltage range: 4.5 V to 15.0 V ±1.5% output accuracy over full temperature range 250 kHz to 1.4 MHz adjustable switching frequency Adjustable/fixed output options via factory fuse or I2C interface I2C interface with interrupt on fault cond
Datasheet
10
ADP1108

Analog Devices
DC-to-DC Converter
Operates at Supply Voltages From 2.0 V to 30 V Consumes Only 110 ␮A Supply Current Step-Up or Step-Down Mode Operation Minimum External Components Required Low Battery Detector Comparator On-Chip User-Adjustable Current Limit Internal 1 A Power Switc
Datasheet
11
ADP1111

Analog Devices
Step-Up/Step-Down SW Regulator
Operates from 2 V to 30 V Input Voltage Range 72 kHz Frequency Operation Utilizes Surface Mount Inductors Very Few External Components Required Operates in Step-Up/Step-Down or Inverting Mode Low Battery Detector User Adjustable Current Limit Interna
Datasheet
12
ADP3629

Analog Devices
2A MOSFET Driver
Industry-standard-compatible pinout High current drive capability Precise threshold shutdown comparator UVLO with hysteresis Overtemperature warning signal Overtemperature shutdown 3.3 V-compatible inputs Rise time and fall time: 10 ns typical at 2.2
Datasheet
13
ADP3631

Analog Devices
2A MOSFET Driver
Industry-standard-compatible pinout High current drive capability Precise threshold shutdown comparator UVLO with hysteresis Overtemperature warning signal Overtemperature shutdown 3.3 V-compatible inputs Rise time and fall time: 10 ns typical at 2.2
Datasheet
14
ADP5070

Analog Devices
DC-to-DC Switching Regulator
Wide input supply voltage range: 2.85 V to 15 V Generates well regulated, independently resistor programmable VPOS and VNEG outputs Boost regulator to generate VPOS output Adjustable positive output to 39 V Integrated 1.0 A main switch Optional sing
Datasheet
15
ADP5075

Analog Devices
DC-to-DC Inverting Regulator
Wide input voltage range: 2.85 V to 15 V Adjustable negative output to VIN − 39 V Integrated 800 mA main switch 1.2 MHz/2.4 MHz switching frequency with optional external frequency synchronization from 1.0 MHz to 2.6 MHz Resistor programmable soft st
Datasheet
16
ADPD1081

Analog Devices
Photometric Front Ends
Multifunction photometric front end Fully integrated AFE, ADC, LED drivers, and timing core Enables ambient light rejection capability without the need for photodiode optical filters Three 370 mA LED peak current drivers Flexible, multiple, short LED
Datasheet
17
ADP3502

Analog Devices
CDMA Power Management System
11 LDOs Optimized for Specific CDMA Subsystems 4 Backup LDOs for Standby Mode Operation Ultra Low Standby Supply Current High Accuracy Battery Charger (0.7%) 3 Li-Ion Battery Charge Modes 5 mA Precharge Low Current Charge Full Current Charge Integrat
Datasheet
18
ADP1711

Analog Devices
(ADP1710 / ADP1711) CMOS Linear Regulator
Maximum output current: 150 mA Input voltage range: 2.5 V to 5.5 V Light load efficient IGND = 35 μA with zero load IGND = 40 μA with 100 μA load Low shutdown current: <1 μA Low dropout voltage: 150 mV @ 150 mA load Initial accuracy: ±1% Accuracy ove
Datasheet
19
ADP2107

Analog Devices
Step-Down DC-to-DC Converter
Extremely high 97% efficiency Ultralow quiescent current: 20 μA 1.2 MHz switching frequency 0.1 μA shutdown supply current Maximum load current ADP2105: 1 A ADP2106: 1.5 A ADP2107: 2 A Input voltage: 2.7 V to 5.5 V Output voltage: 0.8 V to VIN Maximu
Datasheet
20
ADP1712

Analog Devices
CMOS Linear Regulator
Maximum output current: 300 mA Input voltage range: 2.5 V to 5.5 V Light load efficient IGND = 75 μA with 100 μA load Low shutdown current: <1 μA Very low dropout voltage: 170 mV @ 300 mA load Initial accuracy: ±1% www.DataSheet4U.com Accuracy over l
Datasheet



logo    Desde 2024. D4U Semiconductor.   |   Contáctenos   |   Política de Privacidad