Analog Devices AD8 Hoja de datos

No.	parte #	Fabricante	Descripción
1	AD8330	Analog Devices	Variable Gain Amplifier Fully differential signal path, also used with single-sided signals Inputs from 0.3 mV to 1 V rms, rail-to-rail outputs Differential RIN = 1 kΩ; ROUT (each output) 75 Ω Automatic offset compensation (optional) Linear-in-dB and linear-in-magnitude gai
2	AD8353	Analog Devices	RF Gain Block Fixed gain of 20 dB Operational frequency of 1 MHz to 2.7 GHz Linear output power up to 9 dBm Input/output internally matched to 50 Ω Temperature and power supply stable Noise figure: 5.3 dB Power supply: 3 V or 5 V APPLICATIONS VCO buffers General T
3	AD8479	Analog Devices	Very High Common-Mode Voltage Precision Difference Amplifier ±600 V common-mode voltage range Rail-to-rail output Fixed gain of 1 Wide power supply range of ±2.5 V to ±18 V 550 μA typical power supply current Excellent ac specifications 90 dB minimum CMRR 310 kHz bandwidth High accuracy dc performance 5 ppm ma
4	AD8143	Analog Devices	Triple Differential Receiver High speed 160 MHz large signal bandwidth 1000 V/µs slew rate at G = 1, VO = 2 V p-p High CMRR: 65 dB at 10 MHz High differential input impedance: 5 MΩ Input common-mode range: ±10.5 V (±12 V supplies) User-adjustable gain Wide power supply range: +5
5	AD8398	Analog Devices	VDSL / Dual Line Driver Current feedback Wide output swing 18.8 V p-p differential, (50 Ω RLOAD) from 12 V supply 20.0 V p-p differential, (100 Ω RLOAD) from 12 V supply High output current Linear output current of 250 mA peak Low distortion −100 dBc typical at 200 kHz −76
6	AD8309	Analog Devices	5 MHz.500 MHz 100 dB Demodulating Logarithmic Amplifier with Limiter Output Complete Multistage Log-Limiting IF Amplifier 100 dB Dynamic Range: –78 dBm to +22 dBm (Re 50 ⍀ ) Stable RSSI Scaling Over Temperature and Supplies: 20 mV/dB Slope, –95 dBm Intercept ؎0.4 dB RSSI Linearity up to 200 MHz Programmable Limiter Gain and
7	AD8367	Analog Devices	Linear-in-dB VGA Broad-range analog variable gain: −2.5 dB to +42.5 dB 3 dB cutoff frequency of 500 MHz Gain up and gain down modes Linear-in-dB, scaled 20 mV/dB Resistive ground referenced input Nominal ZIN = 200 Ω On-chip, square-law detector Single-supply operatio
8	AD8137	Analog Devices	Low Power 12-Bit Differential ADC Driver Fully differential Extremely low power with power-down feature 2.6 mA quiescent supply current @ 5 V 450 µA in power-down mode @ 5 V High speed 110 MHz large signal 3 dB bandwidth @ G = 1 450 V/µs slew rate 12-bit SFDR performance @ 500 kHz Fast sett
9	AD8142	Analog Devices	Triple Differential Drivers Triple, high speed differential drivers 255 MHz, −3 dB large signal bandwidth 65 MHz, 0.1 dB flatness 1150 V/μs slew rate 12 ns settling time Single 5 V or split supply operation Fixed gain of 2 Internal common-mode feedback network Output balance er
10	AD8062	Analog Devices	Rail-to-Rail Amplifiers Low cost Single (AD8061), dual (AD8062) Single with disable (AD8063) Rail-to-rail output swing Low offset voltage: 6 mV High speed 300 MHz, −3 dB bandwidth (G = 1) 650 V/µs slew rate 8.5 nV/√Hz at 5 V 35 ns settling time to 0.1% with 1 V step Operate
11	AD823	Analog Devices	Dual/ 16 MHz/ Rail-to-Rail FET Input Amplifier Single-supply operation Output swings rail-to-rail Input voltage range extends below ground Single-supply capability from 3 V to 36 V High load drive Capacitive load drive of 500 pF, G = +1 Output current of 15 mA, 0.5 V from supplies Excellent ac pe
12	AD8313	Analog Devices	Logarithmic Detector/Controller ► Wide bandwidth: 0.1 GHz to 2.5 GHz min ► High dynamic range: 70 dB to ±3.0 dB ► High accuracy: ±1.0 dB over 65 dB range (@ 1.9 GHz) ► Fast response: 40 ns full-scale typical ► Controller mode with error output ► Scaling stable over supply and temp
13	AD8603	Analog Devices	Rail-to-Rail Input/Output Operational Amplifiers PIN CONFIGURATIONS ► Low offset voltage: 50 µV maximum ► Low input bias current: 1 pA maximum ► Single-supply operation: 1.8 V to 5 V ► Low noise: 22 nV/√Hz ► Micropower: 50 µA maximum ► Low distortion ► No phase reversal ► Unity gain stable Figur
14	AD8611	Analog Devices	Ultrafast 4 ns Single Supply Comparators 4 ns propagation delay at 5 V Single-supply operation: 3 V to 5 V 100 MHz input Latch function APPLICATIONS High speed timing Clock recovery and clock distribution Line receivers Digital communications Phase detectors High speed sampling Read channel
15	AD8465	Analog Devices	Single-Supply LVDS Comparator Fully specified rail to rail at VCCI = 2.5 V to 5.5 V Input common-mode voltage from −0.2 V to VCCI + 0.2 V Low glitch LVDS-compatible output stage Propagation delay: 1.6 ns Power dissipation: 37 mW at 2.5 V Shutdown pin Single-pin control for progra
16	AD8610	Analog Devices	Wide Bandwidth JFET Operational Amplifier Low noise: 6 nV/√Hz Low offset voltage: 100 μV maximum Low input bias current: 10 pA maximum Fast settling: 600 ns to 0.01% Low distortion Unity gain stable No phase reversal Dual-supply operation: ±5 V to ±13 V APPLICATIONS Photodiode amplifiers ATE
17	AD827	Analog Devices	Low Power Dual Op Amp High Speed 50 MHz Unity Gain Stable Operation 300 V/ms Slew Rate 120 ns Settling Time Drives Unlimited Capacitive Loads Excellent Video Performance 0.04% Differential Gain @ 4.4 MHz 0.198 Differential Phase @ 4.4 MHz Good DC Performance 2 mV max Inpu
18	AD823A	Analog Devices	Rail-to-Rail FET Input Amplifier Wide Supply Dual, 17 MHz, Rail-to-Rail FET Input Amplifier AD823A CONNECTION DIAGRAM OUT1 1 –IN1 2 +IN1 3 –VS 4 8 7 6 5 Single-supply operation Output swings rail-to-rail Input voltage range extends below ground Single-supply capability from 3 V to
19	AD8351-EP	Analog Devices	Low Distortion Differential RF/IF Amplifier −3 dB bandwidth of 2.2 GHz for AV = 12 dB Single-resistor programmable gain: 0 dB ≤ AV ≤ 26 dB Differential interface Low noise input stage: 2.70 nV/√Hz at 70 MHz, AV = 10 dB Low harmonic distortion −79 dBc second at 70 MHz −81 dBc third at 70 MHz Ou
20	AD8158	Analog Devices	6.5 Gbps Quad Buffer Mux/Demux Quad 2:1 mux/1:2 demux Optimized for dc to 6.5 Gbps NRZ data Per-lane P/N pair inversion for routing ease Programmable input equalization Compensates up to 40 inches of FR4 Loss-of-signal detection Programmable output pre-emphasis up to 12 dB Program