TPT4089 |
Part Number | TPT4089 |
Manufacturer | 3PEAK |
Description | ⚫ Exceeds Requirements of EIA-485 Standard ⚫ Hot Plug Circuitry - Tx and Rx Outputs Remain Three- State During Power-up/Power-down ⚫ Supply voltage: 3.0V ~ 5.5V ⚫ Data Rate: 32Mbps or 500Kbps ⚫ Up to 256 Nodes on a Bus (1/8 unit load) ⚫ Full Fail-safe Receiver (Open, Short, Terminated) ⚫ H/F control to support Half and Full Duplex RS485 ⚫ Polarity Control t. |
Features |
3.3V~5.0V Full Duplex RS-485 Transceivers with polarity control
Description
⚫ Exceeds Requirements of EIA-485 Standard ⚫ Hot Plug Circuitry - Tx and Rx Outputs Remain Three- State During Power-up/Power-down ⚫ Supply voltage: 3.0V ~ 5.5V ⚫ Data Rate: 32Mbps or 500Kbps ⚫ Up to 256 Nodes on a Bus (1/8 unit load) ⚫ Full Fail-safe Receiver (Open, Short, Terminated) ⚫ H/F control to support Half and Full Duplex RS485 ⚫ Polarity Control to Correct for Bus Reversal through RXP/TXP Pins ⚫ Bus-Pin Protection: ±12 kV IEC61000-4-2 Contact Discharge ±15 kV IEC61000-4-2 Air Discharge ±2 kV IEC61000-4-4 Fa. |
Datasheet |
TPT4089 Data Sheet
PDF 0.95MB |
Distributor | Stock | Price | Buy |
---|
No. | Parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
1 | TPT4032 |
3PEAK |
High Speed Quad Differential RS422 Receiver | |
2 | TPT4181 |
3PEAK |
3.0V to 5.5V RS-485 Transceivers | |
3 | TPT485E |
3PEAK |
RS-485 Transceiver | |
4 | TPT485N |
3PEAK |
Bus-Polarity Correcting RS-485 Transceiver | |
5 | TPT487 |
3PEAK |
3.0V to 5.5V RS-485 Transceivers | |
6 | TPT0472S |
TOPPOWER |
3W 1.5KVDC Isolated Triple Output DC/DC Converters | |
7 | TPT0572S |
TOPPOWER |
3W 1.5KVDC Isolated Triple Output DC/DC Converters | |
8 | TPT1042Q |
3PEAK |
Automotive Fault Protected High-Speed CAN FD Transceiver | |
9 | TPT1042VQ |
3PEAK |
Automotive Fault Protected High-Speed CAN FD Transceiver | |
10 | TPT1043 |
3PEAK |
Low-Power Fault Protected High-Speed CAN FD Transceiver |