SRF08 |
Part Number | SRF08 |
Manufacturer | ETC |
Description | 12/04/13 SRF08 Ultra sonic range finder SRF08 Ultra sonic range finder Technical Specification Communication with the SRF08 ultrasonic rangefinder is via the I2C bus. This is available on popular co... |
Features |
mples of using the SRF08 module with a wide range of popular controllers.
Connections The "Do Not Connect" pin should be left unconnected. It is actually the CPU MCLR line and is used once only in our workshop to program the PIC16F872 on-board after assembly, and has an internal pull-up resistor. The SCL and SDA lines should each have a pull-up resistor to +5v somewhere on the I2C bus. You only need one pair of resistors, not a pair for every module. They are normally located with the bus master rather than the slaves. The SRF08 is always a slave - never a bus master. If you need them, I reco... |
Document |
SRF08 Data Sheet
PDF 289.44KB |
Similar Datasheet
No. | Parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
1 | SRF005 |
Revolution Education |
ULTRASONIC RANGE SENSOR | |
2 | SRF01 |
ETC |
Ultrasonic range finder | |
3 | SRF02 |
ETC |
Ultrasonic Range Finder | |
4 | SRF02 |
ETC |
Ultrasonic Range Finder Tech | |
5 | SRF04 |
ETC |
Ultrasonic Rangefinger Schematic | |
6 | SRF04 |
Parallax |
Ultrasonic Range Finger Application Note |