logo

AN1048 ON Semiconductor RC Snubber Networks Datasheet

TCAN1048AVDMTRQ1 CAN Interface IC Enhanced Automotive dual CAN transceiver with inverted Standby and 1.8-V I/O Support 14-VSON -40 to 150


ON Semiconductor
AN1048
Part Number AN1048
Manufacturer ON Semiconductor (https://www.onsemi.com/)
Description AN1048/D RC Snubber Networks For Thyristor Power Control and Transient Suppression By George Templeton Thyristor Applications Engineer http://onsemi.com APPLICATION NOTE INTRODUCTION Edited and Updated RC networks are used to control voltage transients that could falsely turn-on a thyristor. The...
Features improves noise immunity and high temperature blocking stability at the expense of increased trigger and holding current. External resistors are optional for nonsensitive SCRs and TRIACs. They should be comparable in size to the internal shorting resistance of the device (20 to 100 ohms) to provide maximum improvement. The internal resistance of the thyristor should be measured with an ohmmeter that does not forward bias a diode junction. 1 MEG 100 K 10K 0.001 0.01 0.1 1 10 100 STATIC  dV  (Vńms) dt dV Figure 6.6. Exponential dt versus s Gate-Cathode Resistance ǒ Ǔ 2200 2000 1800 ST...

Document Datasheet AN1048 datasheet pdf (277.11KB)
Distributor Distributor
Mouser Electronics
Stock 4322 In Stock
Price
1 units: 2.43 USD
10 units: 2.19 USD
100 units: 1.76 USD
250 units: 1.65 USD
500 units: 1.45 USD
1000 units: 1.25 USD
3000 units: 1.05 USD
BuyNow BuyNow BuyNow (Manufacturer a Texas Instruments)




AN1048 Distributor

part
Texas Instruments
TCAN1048AVDMTRQ1
IC TRANSCEIVER HALF 2/2 14VSON
6000 units: 1849.1752 KRW
3000 units: 1882.196 KRW
Distributor
DigiKey

3000 In Stock
BuyNow BuyNow
part
Texas Instruments
TCAN1048AVDMTRQ1
CAN Interface IC Enhanced Automotive dual CAN transceiver with inverted Standby and 1.8-V I/O Support 14-VSON -40 to 150
1 units: 2.43 USD
10 units: 2.19 USD
100 units: 1.76 USD
250 units: 1.65 USD
500 units: 1.45 USD
1000 units: 1.25 USD
3000 units: 1.05 USD
Distributor
Mouser Electronics

4322 In Stock
BuyNow BuyNow
part
Fairview Microwave Inc
FMWAN1048
Conical Gain Horn Waveguide Antenna, WR-12, 77 GHz to 87 GHz, UG-387/U Round Co | Fairview Microwave FMWAN1048
1 units: 933.01 USD
Distributor
RS

0 In Stock
No Longer Stocked
part
ITT Interconnect Solutions
104-8543-000
Circular MIL Spec Connector 1048543000
No price available
Distributor
TTI Asia

0 In Stock
BuyNow BuyNow
part
Texas Instruments
TCAN1048AVDMTRQ1
No price available
Distributor
Ameya Holding Limited

144855 In Stock
No Longer Stocked
part
Pasternack Enterprises
PEWAN1048
Key Specifications, Waveguide Size: WR-12, Frequency, Min: 77 GHz, Frequency, Max: 87 GHz, Beam Width V: 10, Beam Width H: 9. WR-12 Waveguide Conical Gain Horn Antenna Operating from 77 GHz to 87 GHz with a Nominal 25 dBi Gain with UG-387/U Round Cover Flange. PEWAN1048 WR-12 conical gain horn antenna is also known as a waveguide horn. This WR-12 conical gain horn antenna has a 25 dBi nominal gain and a round cover flange. Our 25 dBi WR-12 horn antenna has a minimum frequency of 77 GHz and a maximum frequency of 87 GHz. WR12 conical gain horn waveguide antenna PEWAN1048 has a vertical beam width of 10 and horizontal of 9 degrees at 3 dB. This WR-12 conical gain horn antenna with 25 dBi is part of over 40,000 RF, microwave and millimeter wave components available from Pasternack. Our WR-12 waveguide horn antenna can ship worldwide the same day as it is purchased as with our other available RF parts.
1 units: 885.72 USD
5 units: 868.01 USD
10 units: 850.29 USD
Distributor
Pasternack Enterprises US

1 In Stock
BuyNow BuyNow





AN1048 Similar Datasheet

Part Number Description
AN1001
manufacturer
Vishay Siliconix
The Next Step in Surface-Mount Power MOSFETs
www.DataSheet4U.com AN1001 Vishay Siliconix LITTLE FOOTR TSSOP-8 The Next Step in Surface-Mount Power MOSFETs Wharton McDaniel and David Oldham When Vishay Siliconix introduced its LITTLE FOOT MOSFETs, it was the first time that power MOSFETs had been offered in a true surface-mount package, the SOIC. LITTLE FOOT immediately found a home in new small form factor disk drives, computers, and cellular phones. This is the low profile demanded by applications such as PCMCIA cards. It reduces the power package to the same height as many resistors and capacitors in 0805 and 0605 sizes. It also allows placement on the “passive” side of the PC board. The standard pinouts of the LITTLE FOOT TSSOP-...
AN1003
manufacturer
Littelfuse
Thyristors
Teccor® brand Thyristors AN1003 Introduction Due to high-volume production techniques, Thyristors are now priced so that almost any electrical product can benefit from electronic control. A look at the fundamentals of SCR and Triac phase controls shows how this is possible. Output Power Characteristics Phase control is the most common form of Thyristor power control. The Thyristor is held in the off condition -- that is, all current flow in the circuit is blocked by the Thyristor except a minute leakage current. Then the Thyristor is triggered into an “on” condition by the control circuitry. For full-wave AC control, a single Triac or two SCRs connected in inverse parallel may be used. One of...
AN101
manufacturer
Vishay Siliconix
MOSFETs
...
AN103
manufacturer
Siliconix
The FET Constant-Current Source/Limiter
www.DataSheet4U.com AN103 The FET Constant-Current Source/Limiter Introduction The combination of low associated operating voltage and high output impedance makes the FET attractive as a constant-current source. An adjustable-current source (Figure 1) may be built with a FET, a variable resistor, and a small battery. For optimum thermal stability, the FET should be biased near the zero temperature coefficient point. D S RL RS – + A change in supply voltage or a change in load impedance, will change ID by only a small factor because of the low output conductance goss. DID = (DVDS)(goss) (3) The value of goss is an important consideration in the accuracy of a constant-current source where...
AN1042
manufacturer
ON Semiconductor
High Fidelity Switching Audio Amplifiers Using TMOS Power MOSFETs
AN1042/D High Fidelity Switching Audio Amplifiers Using TMOS Power MOSFETs Prepared by: Donald E. Pauly ON Semiconductor Special Consultant http://onsemi.com APPLICATION NOTE With the introduction of complementary bipolar power transistors in the late 1960s, switching amplifiers became theoretically practical. At low frequencies, bipolar transistors have switching efficiencies of 99% and will directly drive a low impedance speaker filter. The requirement for switching frequencies above 100 kHz resulted in excessive losses however. Bipolar drive circuitry was also complex because of its large base current requirement. With the advent of complementary (voltage/current ratings) TMOS power MOSF...
AN1042D
manufacturer
ON Semiconductor
High Fidelity Switching Audio Amplifiers Using TMOS Power MOSFETs
AN1042/D High Fidelity Switching Audio Amplifiers Using TMOS Power MOSFETs Prepared by: Donald E. Pauly ON Semiconductor Special Consultant http://onsemi.com APPLICATION NOTE With the introduction of complementary bipolar power transistors in the late 1960s, switching amplifiers became theoretically practical. At low frequencies, bipolar transistors have switching efficiencies of 99% and will directly drive a low impedance speaker filter. The requirement for switching frequencies above 100 kHz resulted in excessive losses however. Bipolar drive circuitry was also complex because of its large base current requirement. With the advent of complementary (voltage/current ratings) TMOS power MOSF...
AN1043
manufacturer
Microchip
Unique Features of the MCP23X08/17 GPIO Expanders
The I/O port is highly configurable for maximum flexibility. Figure 1 is a simplified block diagram of an I/O port pin. The port can either drive logic levels on the pin, or read logic levels from the pad. The level on the pad can be read at any time, regardless if the pin is configured as an input or an output. The IODIR register controls the direction of the pins (input or output). More specifically, the IODIR registers simply enables/disables the output driver. When the driver is activated (IODIR = 0), the pad is driven to the state in the latch register (OLAT). When deactivated (IODIR = 1), the driver is high impedance. The I/O port has multiple, individual configurations. Each pin can …...
AN1048D
manufacturer
ON Semiconductor
RC Snubber Networks
AN1048/D RC Snubber Networks For Thyristor Power Control and Transient Suppression By George Templeton Thyristor Applications Engineer http://onsemi.com APPLICATION NOTE INTRODUCTION Edited and Updated RC networks are used to control voltage transients that could falsely turn-on a thyristor. These networks are called snubbers. The simple snubber consists of a series resistor and capacitor placed around the thyristor. These components along with the load inductance form a series CRL circuit. Snubber theory follows from the solution of the circuit’s differential equation. Many RC combinations are capable of providing acceptable performance. However, improperly used snubbers can cause unrel...
AN105
manufacturer
Vishay Siliconix
FETS AS VOLTAGE-CONTROLLED RESISTORS
www.DataSheet4U.com AN105 FETs As VoltageĆControlled Resistors Introduction: The Nature of VCRs A voltage-controlled resistor (VCR) may be defined as a three-terminal variable resistor where the resistance value between two of the terminals is controlled by a voltage potential applied to the third. For a junction field-effect transistor (JFET) under certain operating conditions, the resistance of the drain-source channel is a function of the gate-source voltage alone and the JFET will behave as an almost pure ohmic resistor. Maximum drain-source current, IDSS, and minimum resistance rDS(on), will exist when the gate-source voltage is equal to zero volts (VGS = 0). If the gate voltage is in...




logo    Since 2024. D4U Semiconductor.   |   Contact Us   |   Privacy Policy