Busque con el número de pieza junto con el fabricante o la descripción
SRF02 |
Click to view a larger image
| Part Number | SRF02 |
| Manufacturer | ETC |
| Description | SRF02 Ultra sonic range finder http://www.robotelectronics.co.uk/htm/srf02techI2C.htm SRF02 Ultr asonic r ange finder Technical Specification I2C Mode For Serial mode click here I2C Communi... |
| Features |
d each have a pullup resistor to +5v somewhere on the I2C bus. You only need one pair of resistors, not a pair for every module. They are normally located with the bus master rather than the slaves. The SRF02 is always a slave never a bus master. If you need them, I recommend 1.8k resistors. Some modules such as the OOPic already have pullup resistors and you do not need to add any more.
Registers The SRF02 appears as a set of 6 registers. Location 0 1 2 3
www.DataSheet4U.com
4
5
Read Software Revision Unused (reads 0x80) Range High Byte Range Low Byte Autotune Mi... |
| Document |
 SRF02 Data Sheet
PDF 142.58KB |
Similar Datasheet
| No. | Parte # | Fabricante | Descripción | Hoja de Datos |
|---|---|---|---|---|
| 1 | SRF005 |
Revolution Education |
ULTRASONIC RANGE SENSOR |
|
| 2 | SRF01 |
ETC |
Ultrasonic range finder |
|
| 3 | SRF02 |
ETC |
Ultrasonic Range Finder |
|
| 4 | SRF04 |
ETC |
Ultrasonic Rangefinger Schematic |
|
| 5 | SRF04 |
Parallax |
Ultrasonic Range Finger Application Note |
|
| 6 | SRF04 |
ETC |
Ultra Sonic Ranger |
|
Desde 2024. D4U Semiconductor.
|