TDA10045H |
Part Number | TDA10045H |
Manufacturer | NXP (https://www.nxp.com/) |
Description | TDA10045H The TDA10045H is a single-chip channel receiver for 2 and 8 kbytes COFDM modulated signals based on the ETSI specification (ETSI 300-744). The device interfaces directly to an IF signal, w... |
Features |
• 2 and 8 kbytes Coded Orthogonal Frequency Division Multiplexer (COFDM) demodulator (fully DVB-T compliant: ETSI 300-744) • All modes supported, including hierarchical modes • Fully automatic transmission parameters detection (including Fast Fourier Transformer (FFT) size and guard interval) • Digital Signal Processor (DSP) based synchronization (software can be upgraded on the fly) • No extra-host software required • On-chip 10-bit Analog-to-Digital Converter (ADC) • 2nd or 1st IF variable analog input • Only fundamental crystal oscillator required (4 MHz typical ±100 ppm) • 6, 7 and 8 MHz c... |
Document |
TDA10045H Data Sheet
PDF 94.11KB |
No. | Parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
1 | TDA10046HT |
Philips |
Single-Chip DVB-T Channel Decoder | |
2 | TDA1001B |
NXP |
Interference and noise suppression circuit for FM receivers | |
3 | TDA1001BT |
NXP |
Interference and noise suppression circuit for FM receivers | |
4 | TDA10021HT |
NXP |
DVB-C channel receiver | |
5 | TDA10023HT |
Philips |
Single chip DVB-C/MCNS channel receiver | |
6 | TDA10025HN |
NXP |
Dual cable demodulator |