SN74AUCH245 |
Part Number | SN74AUCH245 |
Manufacturer | Texas Instruments (https://www.ti.com/) |
Description | ordering information This octal bus transceiver is operational at 0.8-V to 2.7-V VCC, but is designed specifically for 1.65-V to 1.95-V VCC operation. The SN74AUCH245 is designed for asynchronous com... |
Features |
buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE) input can be used to disable the device so the buses are effectively isolated.
To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with ... |
Document |
SN74AUCH245 Data Sheet
PDF 1.38MB |
Similar Datasheet
No. | Parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
1 | SN74AUCH244 |
Texas Instruments |
OCTAL BUFFER/DRIVER | |
2 | SN74AUCH16244 |
Texas Instruments |
16-BIT BUFFER/DRIVER | |
3 | SN74AUCH16374 |
Texas Instruments |
16-BIT EDGE-TRIGGERED D-TYPE FLIP-FLOP | |
4 | SN74AUCH32244 |
Texas Instruments |
32-BIT BUFFER/DRIVER | |
5 | SN74AUCH32374 |
Texas Instruments |
32-BIT EDGE-TRIGGERED D-TYPE FLIP-FLOP | |
6 | SN74AUC00 |
Texas Instruments |
QUADRUPLE 2-INPUT POSITIVE-NAND GATE |