KY-012 |
Part Number | KY-012 |
Manufacturer | Joy-IT |
Description | ..... 1 3 Pinout ...... |
Features |
2,5kHz.
The active Buzzer-module doesn't need a square wave, unlike the passiv module (KY-006), to create a sound. If it gets a minimum Voltage of 3.3V at its signal pin, the buzzer will create the square wave by itself.
Export: 16.06.2017
Copyright by Joy-IT - Published under CC BY-NC-SA 3.0
Page 51 of 214
KY-012 Active Piezo-Buzzer module
Pinout
Code example Arduino
In this example, you will see how the buzzer will be ON for 4 seconds and then will be OFF for 2 seconds.
int Buzzer = 13; void setup () {
pinMode (Buzzer, OUTPUT); // Output pin initialization for the buzzer } void loop (... |
Document |
KY-012 Data Sheet
PDF 323.73KB |
Similar Datasheet
No. | Parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
1 | KY-010 |
Joy-IT |
Light barrier-module | |
2 | KY-011 |
Joy-IT |
2-Color (Red+Green) 5mm LED module | |
3 | KY-013 |
Joy-IT |
Temperature-Sensor module | |
4 | KY-015 |
Joy-IT |
Combi-Sensor Temperature + Humidity | |
5 | KY-016 |
Joy-IT |
RGB 5mm LED module | |
6 | KY-017 |
Joy-IT |
Tilt switch module |