74ACT11353 |
Part Number | 74ACT11353 |
Manufacturer | Texas Instruments (https://www.ti.com/) |
Description | Each of these data selectors/multiplexers contains inverters and drivers to supply full binary decoding data selection to the AND-OR gates. Separate strobe inputs (G) are provided for each of the two ... |
Features |
gates. Separate strobe inputs (G) are provided for each of the two four-line sections.
3 2 1 20 19
1C1 4
18 2C1
1C0 5
17 2C2
NC 6
16 NC
A7
15 2C3
B8
14 2G
9 10 11 12 13
1Y GND
NC 2Y 1G
The 3-state outputs can interface with and drive data lines of bus-organized systems. With all but one of the common outputs disabled (at a high-impedance state), the low-impedance of the single enabled output will drive the bus line to a high or low logic level. Each output has its own strobe (G). The output is disabled when its strobe is high.
The 54ACT11353 is characterized for operation over ... |
Document |
74ACT11353 Data Sheet
PDF 88.68KB |
Similar Datasheet
No. | Parte # | Fabricante | Descripción | Hoja de Datos |
---|---|---|---|---|
1 | 74ACT11352 |
Texas Instruments |
DUAL 4-LINE TO 1-LINE DATA SELECTOR/MULTIPLEXER | |
2 | 74ACT11373 |
Texas Instruments |
OCTAL TRANSPARENT D-TYPE LATCH | |
3 | 74ACT11374 |
Texas Instruments |
OCTAL EDGE-TRIGGERED D-TYPE FLIP-FLOP | |
4 | 74ACT11377 |
Philips |
OCTAL D-TYPE FLIP-FLOP | |
5 | 74ACT11377 |
Texas Instruments |
OCTAL D-TYPE FLIP-FLOP | |
6 | 74ACT11378 |
Texas Instruments |
HEX D-TYPE FLIP FLOP |