logo

ET7272B ETC Quad Differential Line Driver Datasheet


ETC
ET7272B
Part Number ET7272B
Manufacturer ETC
Description These line drivers are pin compatible with 26LS31 in applications where pin 4 = 5V and pin 12 = GND. Internal clamp diodes allow trouble-free operation when driving cable lengths exceeding 100m. Split supplies are provided to minimize standby power dissipation in high voltage applications. The logic...
Features






• Supply (Bias) Voltage Range 3.5V to 30V Operation to 800KHz CMOS and TTL Compatible Inputs logic bias and driver supply pins
• Separate www.DataSheet4U.com Optional single supply operation for moderate power applications High Impedance Buffered Inputs with hysteresis Tri-State outputs 80mA peak SINK/SOURCE current This part is available in 16L SOIC or 20L TSSOP (all Pb-free) packages, or as die. PACKAGE Die Only 16 Lead SOIC 20 Lead TSSOP SUFFIX -C -SOP -TSS (Pb-free) -----------SOP-LF -TSS-LF APPLICATIONS:

• Encoders Industrial controls DESCRIPTION These line drivers a...

Document Datasheet ET7272B datasheet pdf (155.78KB)




ET7272B Distributor






ET7272B Similar Datasheet

Part Number Description
ET7272
manufacturer
ETIC
QUAD DIFFERENTIAL LINE DRIVER
These line drivers are pin compatible with 26LS31 in applications where pin 4 = 5V and pin 12 = GND. Internal clamp diodes allow trouble-free operation when driving cable lengths exceeding 100m. Split supplies are provided to minimize standby power dissipation in high voltage applications. The logic should be powered from a regulated 5V supply at the VccBias pin. The output stages may then be powered by a separate supply at VccDrivers, up to 30V. Output voltage swings of 0.3V to VCC-1.9V are typical. The outputs are protected against shorts to ground, shorts to Vcc and to other outputs, by a two-fold scheme of current limiting and thermal shutdown. This assures highly reliable operation in h...
ET7273C
manufacturer
ETIC
QUAD DIFFERENTIAL LINE DRIVER IC
These line drivers are similar in function to the ET7272, only in an open-collector format. The VCC pin powers the internal logic only. Output voltage is dependent on the customer supplied voltage, up to a maximum of 30V. There is essentially no difference in output swing or performance with VCC (LOGIC) values from 3.5V-30V. Internal clamp diodes allow trouble-free operation when driving cable lengths exceeding 100 meters. The outputs are protected by initiating shutdown when junciton temperatures...




logo    Since 2024. D4U Semiconductor.   |   Contact Us   |   Privacy Policy