logo

LF155 Texas Instruments JFET Input Operational Amplifiers Datasheet

PIC16LF1554-I/SL IC MCU 8BIT 7KB FLASH 14SOIC


Texas Instruments
LF155
Part Number LF155
Manufacturer Texas Instruments (https://www.ti.com/)
Description The LFx5x devices are the first monolithic JFET input operational amplifiers to incorporate well-matched, high-voltage JFETs on the same chip with standard bipolar transistors (BI-FET™ Technology). These amplifiers feature low input bias and offset currents/low offset voltage and offset voltage drif...
Features
•1 Advantages
  – Replace Expensive Hybrid and Module FET Op Amps
  – Rugged JFETs Allow Blow-Out Free Handling Compared With MOSFET Input Devices
  – Excellent for Low Noise Applications Using Either High or Low Source Impedance—Very Low 1/f Corner
  – Offset Adjust Does Not Degrade Drift or Common-Mode Rejection as in Most Monolithic Amplifiers
  – New Output Stage Allows Use of Large Capacitive Loads (5,000 pF) Without Stability Problems
  – Internal Compensation and Large Differential Input Voltage Capability
• Common Features
  – Low Input Bias Current: 30 pA
  – Low Input Offset Current: 3 pA
  – High Inp...

Document Datasheet LF155 datasheet pdf (2.45MB)
Distributor Distributor
DigiKey
Stock 596 In Stock
Price
100 units: 0.89 USD
25 units: 1 USD
1 units: 1.07 USD
BuyNow BuyNow BuyNow (Manufacturer a Microchip Technology Inc)




LF155 Distributor

Microchip Technology Inc
PIC16LF1554-I/P
MCU, 8BIT, PIC16, 32MHZ, DIP-14
100 units: 1785 KRW
25 units: 1822 KRW
1 units: 1859 KRW
Distributor
element14 Asia-Pacific

1547 In Stock
BuyNow BuyNow
Microchip Technology Inc
PIC16LF1554-I/SL
IC MCU 8BIT 7KB FLASH 14SOIC
100 units: 0.89 USD
25 units: 1 USD
1 units: 1.07 USD
Distributor
DigiKey

596 In Stock
BuyNow BuyNow
Microchip Technology Inc
PIC16LF1554T-I/ML
MCU 8-Bit PIC16 PIC RISC 7KB Flash 3.3V 16-Pin QFN EP T/R (Alt: PIC16LF1554T-I/ML)
No price available
Distributor
Avnet Asia

0 In Stock
No Longer Stocked
Microchip Technology Inc
PIC12LF1552T-I/MU
8-bit Microcontrollers - MCU 3.5KB Flash 256bytes RAM 16 MHz Int Osc
1 units: 1.04 USD
25 units: 0.95 USD
100 units: 0.85 USD
3300 units: 0.849 USD
Distributor
Mouser Electronics

17517 In Stock
BuyNow BuyNow
Microchip Technology Inc
PIC16LF1554-E/P
7KB Flash, 512B RAM, 12 I/Os, 2x 10-bit ADC, I2C, UART, 2x PWM, Projected EOL: 2039-08-05
5000 units: 1.05 USD
1000 units: 1.1 USD
100 units: 1.2 USD
25 units: 1.31 USD
1 units: 1.45 USD
Distributor
Microchip Technology Inc

930 In Stock
BuyNow BuyNow
Microchip Technology Inc
PIC16LF1554-I/P
7KB Flash, 512B RAM,12 I/Os, 2x 10-bit ADC, I2C, UART, 2x PWM14 PDIP .300in TUBE | Microchip Technology Inc. PIC16LF1554-I/P
1 units: 0.72 USD
Distributor
RS

50 In Stock
BuyNow BuyNow
National Semiconductor Corporation
LF155AH/883B
Operational Amplifier, Single AMP, Bipolar/JFET, 8 Pin, Metal Can
1 units: 32.5 USD
Distributor
Quest Components

4 In Stock
BuyNow BuyNow
Microchip Technology Inc
PIC16LF1559-I/SS
IC: PIC microcontroller; 14kB; 32MHz; 1.8÷3.6VDC; SMD; SSOP20; tube
134 units: 1.15 USD
67 units: 1.17 USD
5 units: 1.28 USD
1 units: 1.38 USD
Distributor
TME

0 In Stock
No Longer Stocked
Microchip Technology Inc
PIC16LF1554-I/P
MCU 8-Bit PIC16 PIC RISC 7KB Flash 3.3V 14-Pin PDIP Tube - Rail/Tube (Alt: PIC16LF1554-I/P)
100 units: 1.1 USD
25 units: 1.22 USD
1 units: 1.31 USD
Distributor
Avnet Americas

0 In Stock
BuyNow BuyNow
Microchip Technology Inc
PIC16LF1554-E/P
MCU 8-Bit PIC16 PIC RISC 7KB Flash 3.3V 14-Pin PDIP Tube (Alt: PIC16LF1554-E/P)
No price available
Distributor
Avnet Silica

0 In Stock
BuyNow BuyNow





Similar Datasheet

Part Number Description
LF1005-S
manufacturer
LEM
Current Transducer LF 1005-S
...
LF100ED
manufacturer
MicroPowerDirect
Dual Output Ultra-Miniature 1W SMT DC/DC Converters
Pin Description -Vin 6 NC +Vin 7 +Vout NC 8 NC Common 9 NC -Vout 10 NC NC = No Connection For applications requiring very low output noise levels, a simple LC filter should be effective. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the Model Selection table above for the correct rating. Recommended Solder Profile Mechanical Dimensions Board Layout Notes: • All dimensions are typical in inches (mm) • Tolerance x.xx = ±0.01 (±0.25) • Pin 1 is marked by a “dot” or indentation on the unit MicroPower Direct www.micropowerdirect.com • 292 Page Street Ste D Stoughton, MA 02072 TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropow...
LF101ED
manufacturer
MicroPowerDirect
Dual Output Ultra-Miniature 1W SMT DC/DC Converters
Pin Description -Vin 6 NC +Vin 7 +Vout NC 8 NC Common 9 NC -Vout 10 NC NC = No Connection For applications requiring very low output noise levels, a simple LC filter should be effective. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the Model Selection table above for the correct rating. Recommended Solder Profile Mechanical Dimensions Board Layout Notes: • All dimensions are typical in inches (mm) • Tolerance x.xx = ±0.01 (±0.25) • Pin 1 is marked by a “dot” or indentation on the unit MicroPower Direct www.micropowerdirect.com • 292 Page Street Ste D Stoughton, MA 02072 TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropow...
LF102ED
manufacturer
MicroPowerDirect
Dual Output Ultra-Miniature 1W SMT DC/DC Converters
Pin Description -Vin 6 NC +Vin 7 +Vout NC 8 NC Common 9 NC -Vout 10 NC NC = No Connection For applications requiring very low output noise levels, a simple LC filter should be effective. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the Model Selection table above for the correct rating. Recommended Solder Profile Mechanical Dimensions Board Layout Notes: • All dimensions are typical in inches (mm) • Tolerance x.xx = ±0.01 (±0.25) • Pin 1 is marked by a “dot” or indentation on the unit MicroPower Direct www.micropowerdirect.com • 292 Page Street Ste D Stoughton, MA 02072 TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropow...
LF103ED
manufacturer
MicroPowerDirect
Dual Output Ultra-Miniature 1W SMT DC/DC Converters
Pin Description -Vin 6 NC +Vin 7 +Vout NC 8 NC Common 9 NC -Vout 10 NC NC = No Connection For applications requiring very low output noise levels, a simple LC filter should be effective. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the Model Selection table above for the correct rating. Recommended Solder Profile Mechanical Dimensions Board Layout Notes: • All dimensions are typical in inches (mm) • Tolerance x.xx = ±0.01 (±0.25) • Pin 1 is marked by a “dot” or indentation on the unit MicroPower Direct www.micropowerdirect.com • 292 Page Street Ste D Stoughton, MA 02072 TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropow...
LF104ED
manufacturer
MicroPowerDirect
Dual Output Ultra-Miniature 1W SMT DC/DC Converters
Pin Description -Vin 6 NC +Vin 7 +Vout NC 8 NC Common 9 NC -Vout 10 NC NC = No Connection For applications requiring very low output noise levels, a simple LC filter should be effective. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the Model Selection table above for the correct rating. Recommended Solder Profile Mechanical Dimensions Board Layout Notes: • All dimensions are typical in inches (mm) • Tolerance x.xx = ±0.01 (±0.25) • Pin 1 is marked by a “dot” or indentation on the unit MicroPower Direct www.micropowerdirect.com • 292 Page Street Ste D Stoughton, MA 02072 TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropow...
LF111
manufacturer
National Semiconductor
Voltage Comparators
The LF111 LF211 and LF311 are FET input voltage comparators that virtually eliminate input current errors Designed to operate over a 5 0V to g 15V range the LF111 can be used in the most critical applications The extremely low input currents of the LF111 allows the use of a simple comparator in applications usually requiring input current buffering Leakage testing long time delay circuits charge measurements and high source impedance voltage comparisons are easily done Further the LF111 can be used in place of the LM111 eliminating errors due to input currents See the ‘‘application hints’’ of the LM311 for application help Features Y Y Y Eliminates input current errors Interchangeable with...
LF111ED
manufacturer
MicroPowerDirect
Dual Output Ultra-Miniature 1W SMT DC/DC Converters
Pin Description -Vin 6 NC +Vin 7 +Vout NC 8 NC Common 9 NC -Vout 10 NC NC = No Connection For applications requiring very low output noise levels, a simple LC filter should be effective. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the Model Selection table above for the correct rating. Recommended Solder Profile Mechanical Dimensions Board Layout Notes: • All dimensions are typical in inches (mm) • Tolerance x.xx = ±0.01 (±0.25) • Pin 1 is marked by a “dot” or indentation on the unit MicroPower Direct www.micropowerdirect.com • 292 Page Street Ste D Stoughton, MA 02072 TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropow...
LF11201
manufacturer
National Semiconductor
Quad SPST JFET Analog Switches
These devices are a monolithic combination of bipolar and JFET technology producing the industry’s first one chip quad JFET switch. A unique circuit technique is employed to maintain a constant resistance over the analog voltage range of ± 10V. The input is designed to operate from minimum TTL levels, and switch operation also ensures a break-before-make action. These devices operate from ± 15V supplies and swing a ± 10V analog signal. The JFET switches are designed for applications where a dc to medium frequency analog signal needs to be controlled. Features n Analog signals are not loaded n Constant “ON” resistance for signals up to ± 10V and 100 kHz n Pin compatible with CMOS switches wi...
LF11202
manufacturer
National Semiconductor
Quad SPST JFET Analog Switches
These devices are a monolithic combination of bipolar and JFET technology producing the industry’s first one chip quad JFET switch. A unique circuit technique is employed to maintain a constant resistance over the analog voltage range of ± 10V. The input is designed to operate from minimum TTL levels, and switch operation also ensures a break-before-make action. These devices operate from ± 15V supplies and swing a ± 10V analog signal. The JFET switches are designed for applications where a dc to medium frequency analog signal needs to be controlled. Features n Analog signals are not loaded n Constant “ON” resistance for signals up to ± 10V and 100 kHz n Pin compatible with CMOS switches wi...




logo    Since 2024. D4U Semiconductor.   |   Contact Us   |   Privacy Policy